
Quick Start Guide
Website: www.dahuasecurity.com
Address: No.1399 Binxing Road, Binjiang District, Hangzhou, P.R.China  Postcode: 310053
Tel:+86-571-87688888 28933188
Email: dhoverseas@dhvisiontech.com
ZHEJIANG DAHUA VISION TECHNOLOGY CO., LTD.
  1     Mounting
Figure 1-1 Installation
Figure 3-1 AP
Outdoor Access Point
Outdoor
Determine device processing power outage status.
As shown in Figure 1, insert the hoop into the holding pole on the 
           back of the casing.
Use a hoop to attach the AP to the pole (applicable pole diameter  
There are multiple specications for AP antennas to choose from, and this 
guide takes the default model as an example.
Holding pole
Hoop
AP device
Hoop                        2pcs
Accessories List
  2     Connection
  3     Note
The outdoor AP device is connected to the PoE port of the PoE power 
adapter through a network cable. (For non-standard network cables, it 
is necessary to ensure that the impedance of a single line in the required
length of the network cable does not exceed 6 Ω).
Connect the PC to the PoE power adapter LAN port through a network
cable.
After the PoE power adapter is powered on, the power light of the
outdoor AP device remains on, indicating that the device is powered
on and running. 
Checking the network connection status on the PC can check whether
the network connection between the PC and the outdoor AP is normal.
AP
Device
PoE Power 
adapter
Figure 2-1 Network connection
PC
The user‘s wireless terminal should be within the coverage range of the AP signal as
 much as possible.
Connect the network cable of the AP to ensure that the eight cable cores are normal 
and in good contact with the crystal heads at both ends. Use Cate5e or higher Ethernet
 cables, and after the production of the cables, use a cable tester for testing.
The recommended installation height for AP is 2-3 meters above the ground to ensure 
op
timal signal coverage.
lf the Outdoor AP adopts a power supply of PoE 48 V, use a switch with
a power supply of IEEE802.3at standard.
When the wireless scale is large and uses more Outdoor APs, we 
recommend using a AC wireless controller to manage all the APs.
2
3
Step  1
Step  2
Step  3
Step  4