Electronics International C-1P Manual


Læs gratis den danske manual til Electronics International C-1P (22 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Electronics International C-1P, eller vil du spørge andre brugere om produktet?

Side 1/22
0912941
Electronics International Inc. ®
Primary TIT and CHT Instruments
and
Remote Switches
Operating and Installation Instructions
OII 091294 9/12/94
(Supersedes OI 101461, II 121161, II 110361 and II 111361)
(FAA Approved)
2092 N.W. Aloclek #523 Hillsboro OR 97124 (503) 439-8484
(This manual covers 12 instruments and remote switches)
Model:
S/N:
You must read this manual before installing or operating the instrument. This
manual contains warranty and other information that may affect your decision
to install this product and/or the safety of your aircraft.
Important Installation Information
0720921
1. Leave slack in the cable to allow
for engine movement and vibration.
All steps must be read before installing a probe.
FE
2. Do Not Overtighten.
Over time, tight wire
wraps will cause the wire
to break.
Hose Clamp.
4. The tab inside the male connector must be centered (not
bent up or down) to mate properly. Check each connector
before installation. Two drops of oil on the connector will
protect it from corrosion for many years.
5. If you remove a connector, double over the wire
before installing it into a new connector. Each connec-
tor must be double crimped very tightly.
Male Conn.
6. If connectors have been disconnected several times the female connector may become
loose. If this happens use a pair of needle nose pliers to retighten the female recep-
tacle then mate the connectors.
S.S. Washer.
3. Both clip rings must be on
the inside of the hose clamp.
The rubber band is used to hold
the washer on during shipping.


Produkt Specifikationer

Mærke: Electronics International
Kategori: Ikke kategoriseret
Model: C-1P

Har du brug for hjælp?

Hvis du har brug for hjælp til Electronics International C-1P stil et spørgsmål nedenfor, og andre brugere vil svare dig