Elektrobock PT14-HT Manual


Læs gratis den danske manual til Elektrobock PT14-HT (6 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Elektrobock PT14-HT, eller vil du spørge andre brugere om produktet?

Side 1/6
PT14-HT
PT14-HT
PT14-HT
PT14-HT
PT14-HT
SPATIAL
THERMOSTAT
FOR CONTROL OF THERMOELECTRIC DRIVES
• radiators equipped with thermoelectric drives
• hot water underoor heating distributors with thermoelectric drives
Intended/designed for
ASSEMBLY AND LOCATION
Install the thermostat in a suitable place where its operation will not be aected by the direct ow
of warm air from the heater, sunlight and other interfering inuences. Also avoid mounting on an
exterior wall. The installation height should be approx. 1.5 m above the ground.
Installation may only be carried out by a suitably qualied person!
Installation must be carried out without voltage!
1) Switch o the main circuit breaker.
2) Unscrew the locking screw and remove the front part of the thermostat with electronics (Fig.1).
3) Attach the back of the thermostat to the wall (Fig.2).
4) Connect the wires to the terminal board, make sure that the terminals are suciently tightened
(Fig.3).
5) Attach the front of the thermostat with LCD and secure the thermostat against splitting
locking screw (Fig.4).
6) Switch on the main circuit breaker. If everything is OK, the current temperature is displayed on
the LCD.
ASSEMBLY PROCEDURE
DESCRIPTION
power indication
heating
button for
lowering the
temperature temperature switch
/
button for
raising the temperature
We recommend:
Thermoelectric actuator type NC (valve closed
without voltage), not part of PT14-HT.
Can be ordered at www.elbock.cz order no.0030.


Produkt Specifikationer

Mærke: Elektrobock
Kategori: Termostat
Model: PT14-HT

Har du brug for hjælp?

Hvis du har brug for hjælp til Elektrobock PT14-HT stil et spørgsmål nedenfor, og andre brugere vil svare dig