Elektrobock BT52 Manual

Elektrobock Termostat BT52

Læs gratis den danske manual til Elektrobock BT52 (20 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Elektrobock BT52, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/20

BT52

T52

BT52

WIRELESS ROOM THERMOSTAT

for boilers with OpenTherm communication

The BT52 wireless thermostat is designed to control gas and electric boilers that use the OpenTherm plus (OT +) commu-

nication protocol. It consists of a receiving part (receiver) and a transmitting part (transmitter), which use two-way wireless

communications on the frequency of 433.92 MHz. This wireless variant allows for easy and quick installation, thus eliminating

the laborious and time-consuming installation of the line between the thermostat and the boiler with a passage through the

oor. The receiver is connected to the boiler via the OT communication line. This line transmits data and also powers the rece-

iver. The receiver immediately transmits the data obtained from the boiler to the transmitter, where the data is processed. The

required heating water is calculated and this request is sent back to the boiler.

receiver

transmitter

• Possibility to place a thermostat (transmitter) as needed.

• Predictive system (smart timer) guarantees determined

temperature at the required time. The adaptive controller evaluates

temperature gradient of the room and can determine the necessary

time to reach the required temperature.

• 9 weekly programs (optional) for UT (6 temperature changes

for a day).

• 1 week program (optional) for DHW (3 time periods

with dierent temperatures).

• Choice of regulation type:

equithermal regulation

equithermal control with internal temperature correction

PI regulation

• Display of operating hours information for UT / TUV.

• Display of outdoor temperature information.

• Display of heating water temperature and modulation power in-

formation.

• Display of additional information sent by the boiler to the receiver

(water ow in liters, return temperature, etc. depending on the type

boilers).

• E-EPROM memory retains all settings indenitely

even in the event of a power failure.

• Possibility of control via GSM module GST1 or GST2 (optional).

• Automatic changeover to WINTER or SUMMER time.

• Automatic indication of boiler maintenance.

• Measured temperature -9 ° C to 39 ° C.

• Antifreeze mode.

• Holiday mode and summer mode.

• Power supply 2x1.5 V alk. battery

• Power supply via OT communication

line directly from the boiler (or external

adapter AD05 - not included)

• Receiver with SELF-LEARNING system

CODES and with E-EPROM memory (sto-

re code even in case of power failure).

• Visual inspection of conditions

using colored indicator LEDs.

•The receiver keeps the last settings

and in the event of a wireless failure

signal, ensures the operation of the boiler.

ca 25 m

BOILER

with OpenTherm

communications

over one

oor

CONTENT

Description BT52 ............................................................... .1p

Content ............................................................... .2p

Properties BT52 ............................................................... .3p

Function .......................................................... p.3

Commissioning diagram .......................................................... p.3

Receiver BT52 ............................................................... .4p

Assembly .......................................................... p.4

Wireless mode .......................................................... p.5

Receiver coding .......................................................... p.5

Transmitter BT52 ............................................................... .6p

Description of controls .......................................................... p.6

Battery placement .......................................................... p.6

Transmitter disassembly .......................................................... p.6

Display description .......................................................... p.7

Operating modes (AUTO, MANU ..) .......................................................... p.8

Setting of temperature programs for UT and TUV .......................................................... p.9

Table of free and preset programs .......................................................... p.9

Setting constants CONST1 to CONST7 .......................................................... p.10

CONST1 Language selection ..................................................................... .10p

CONST2 Minimum regulated temperature ..................................................................... .10p

CONST3 Maximum regulated temperature ..................................................................... .10p

CONST4 Minimum water temperature in the heating system ..................................................................... .10p

CONST5 Maximum water temperature in the heating system ..................................................................... .10p

CONST6 Choice of regulation type ..................................................................... .10p

CONST7 PI control interval ..................................................................... .10p

Setting the CONST8 constant .......................................................... p.11

CONST8 Proportional band of PI regulation ..................................................................... .11p

Setting constants CONST9 to CONST12 .......................................................... p.12

CONST9 Manual or automatic heating curve correction .................................................................... .12. p

CONST10 Building insulation ...................................................................... .12p

CONST11 Equithermal control interval ...................................................................... .12p

CONST12 Equithermal control reaction rate ...................................................................... .12p

Setting constants CONST13 to CONST20 .......................................................... p.13

CONST13 Premature heating on ...................................................................... .13p

CONST14 Summer mode ...................................................................... .13p

CONST15 Odd - even week choice ...................................................................... .13p

CONST16 Temperature correction ...................................................................... p.13

CONST18 Choice of control via GSM module ...................................................................... .13p

CONST19 Phone number setting ...................................................................... .13p

CONST20 Setting the PIN code of the used SIM card ...................................................................... .13p

Setting constants CONST21 to CONST27 .......................................................... p.14

CONST21 Function test ...................................................................... .14p

CONST22 Key lock ...................................................................... .14p

CONST23 Key code ...................................................................... .14p

CONST24 Boiler maintenance indication ...................................................................... .14p

CONST26 Boiler type selection ...................................................................... .14p

CONST27 Password (against setting change) ...................................................................... .14 p

Other displayed information .......................................................... p.15

Error messages .......................................................... p.16

Antifreeze mode .......................................................... p.16

GSM module connection .......................................................... p.16

Control when using the GSM module .................................................................. p.17

Technical parameters ......................................................... p.18

For easier orientation in the manual, each page is marked with the symbol of the part of the thermostat to

which it applies specied settings:

RECEIVER TRANSMITTER

Produkt Specifikationer

Mærke:	Elektrobock
Kategori:	Termostat
Model:	BT52

Har du brug for hjælp?

Hvis du har brug for hjælp til Elektrobock BT52 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Termostat Elektrobock Manualer

Elektrobock PT741W-EI WIFI Manual

8 Juli 2025

Elektrobock BT730 Manual

31 August 2024

Elektrobock PT712-EI Manual

31 August 2024

Elektrobock PT 32 GST Manual

26 August 2024

Elektrobock BPT 32 Manual

26 August 2024

Elektrobock PT 14 Manual

26 August 2024

Elektrobock PT 713 EI Manual

26 August 2024

Elektrobock PT 713 Manual

26 August 2024

Elektrobock BPT 22 Manual

26 August 2024

Elektrobock BT52 Manual

20 August 2024

Termostat Manualer

Nyeste Termostat Manualer

GE RAK190V Manual

12 August 2025

Honeywell CT50K1028/E Manual

12 August 2025

Honeywell RET97B5D1002/U Manual

12 August 2025

Honeywell RCHT9510WFW2001/W Manual

12 August 2025

Honeywell CT87K1004/E1 Manual

12 August 2025

Honeywell YCT87N1006 Manual

12 August 2025

Honeywell RTH7500D1049/A Manual

12 August 2025

Honeywell YCT50K1006 Manual

12 August 2025

Honeywell RTH2510B1000/U Manual

12 August 2025

Honeywell RTH221B1039/E1 Manual

12 August 2025