1
IMPORTANT:
Go to www.extron.com for the
complete user guide and installation
instructions befor
rce.
DA4 HD 4K and DA 6 HD 4K• Setup Guide
Overview
The Extron DA4 HD 4K and DA6 HD 4K distribution ampliers
distribute one HDMIinput signal to four or six outputs
simultaneously (following the HDMI 1.4 specication at
resolutions up to UHD and 4K). This setup guide provides basic
instructions for installation by an experienced installer. For
complete instructions, see the at DA HD 4K Series User Guide
www.extron.com.
Front Panel
DA4 HD 4K
HDMI DIST RIBUT ION AMPLIFIER
CONFIG HDCP
1 2 3 4
SIGNAL
INPUT OUTPUTS
DA6 HD 4K
HDMI DIST RIBUT ION AMPLIFIER
CONFIG HDCP
1 2 3 4
SIGNAL
INPUT OUTPUTS
5 6
C D
CD
F
BA
A — Lights green when power is applied to the unit.Power status LED
B — Used for SIS™ conguration, monitoring, and rmware updates.USB Config port
C — Lights green when a TMDS signal is detected on the HDMI input.Input Signal LED
D — Light green when HPD is detected from the corresponding sink device and when a TMDS Output Signal LEDs
signal is detected at the input.
E — Lights green when the source requires HDCP encryption and it has been authenticated with the Input HDCP LED
HDMI input.
F — Light green when HDCP is authenticated between the DA4 HD 4K or DA6 HD 4K output and Output HDCP LEDs
the corresponding sink device.
Rear Panel
50 60 Hz
100-240V ~ 0.3A MAX DA4 HD 4K
RS-232
4321
Tx Rx G
REMOTEOUTPUTSINPUT
50/60 Hz
100-240V ~ 0.3A MAX DA6 HD 4K
RS-232
4
521
Tx Rx G
OUTPUTS REMOTEINPUT
CA B D
50/60 H z
100-240V ~ 0.3A MAX
DA4 HD 4K
RS-232
4321
Tx Rx G
REMO T EOUT P UT SINPUT
1
31
42
3
1
4
2
3
1
4
2
2
3
100
LINK
ACT
COM IR
INPU
T
RELAY
TX
RX
R
IPL
250
®
ON
OF
F
DISPLA
Y
M UTE
SCRE
EN
UP
SCREE
N
D
OWN
VCR
DVD
DOC
CAM
LAPT
OP
PC
MOD
E
L 80
MOD
E
L
80
MOD
E
L
80 MOD
E
L 80
DA4 HD 4K
Distribution
Amplier
HDMI
Cables
RS-232 TCP/IP
TouchLink
Control
System
4K Displays
4K Media Player
A — Connect the provided female IEC cable Power input
to a 100‑240VAC (50or 60 Hz) power source.
B — Connect a source device to this female HDMI input
HDMI type A connector.
C — Connect up to four or six display HDMI outputs
devices to these female HDMI type A connectors.
D — Used for SIS conguration, monitoring, and RS-232
rmware updates (Pin 1 = Tx, Pin 2 = Rx, Pin 3 = Ground).
Protocol: 9600 baud, 8 data bits, 1 stop bit, no parity.
