Extron MPA 401-100V Manual

Extron Modtager MPA 401-100V

Læs gratis den danske manual til Extron MPA 401-100V (2 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Extron MPA 401-100V, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

MPA 401-70V and MPA 401-100V • Setup Guide

This guide provides basic instructions for an experienced installer to install and congure the

Extron MPA 401-70V and MPA 401-100V mini power ampliers.

INPUTS OUTPUT

50/60 Hz

100-240V .3A

134

LRLR

L R

AUDIO

VID

/VID

B-Y

/R-Y

/B-Y

RS-232

LAN

RESET

ACTLINK

DVI-I

SDI R-Y

RGB/R-Y,Y,B-Y/YC/VID

P O WER

12V

1.5A MAX

OU T P U T

70V

INP U T S

(MONO)

RREMO T E

VOL/MUTE

MPA 401- 70V

CLAS S 2 W IRING

DO NOT GROUND

OR S HORT

S PEAKER OUTPUTS !

10V 50mA

LI S T E D

17TT

AUDIO/VIDEO

APPARATUS

Extron

SI 3CT LP

Full-Range

Ceiling S speaker

Extron

MPA 401

Mini Power

Amplier

Extron

DVS 4 DVI 30 AD

Digital V ideo

Scaler

with Audio

Audio

F t P la anel

Display

(DVI)

DSS R verecei

(S-video)

Laptop

(RGB)

DVD

(Component)

VCR

(Video)

Ext 50ron VC

Vol e C r um ontrolle

Extron

MLC 4 10 IP Plus

Controller

POWER

12V

1.5A MAX

CLAS S 2 W IRING

(SUMMED)

VCG

MPA 401- 100V

10V 50mA

REMOTE 100V OUTPUT

INPU T S

VC 50

Extron

VOLUME

DB S R ECEIVER

CONFIG

DISPLAY

MLC 104 IP

VOLUME

OFF

Step 1 — Turn all of the equipment off and disconnect all power sources.

Step 2 — Mount the amplier in either a plenum space, on a rack, under a desk, or on a projector.

ATTENTION: Although the amplier is plenum rated, the power supply provided with it is not. The power supply must not be

placed in the plenum space. Cables to and from the amplier must be plenum rated.

NOTE: Use only the two round mounting holes for mounting the MPA 401. The other four (hexagonal) holes anchor stand-offs

for the internal circuit boards. Using them may damage the amplier and does not provide secure mounting for the unit.

Step 3 — Attach the speakers to the MPA 401 using the 2-pole, 5 mm screw-lock

captive screw speaker receptacle on the rear panel. (The old and new silk screens for the

MPA401-100V are shown to the right).

ATTENTION: Do not ground or short the speaker outputs as this will damage the

amplier.

NOTE: The mono audio speaker receptacle may be labeled in one of two ways (see

the images to the right). The wiring and function are the same whichever way the

product is labeled.

Step 4 — Attach sources to the MPA 401 unit from the audio source or projector.

The three rear panel audio inputs can be used individually or together:

zOne pair of RCA receptacles (unbalanced)

zOne 3.5 mm stereo tip-ring-sleeve receptacle (unbalanced)

zOne 3.5 mm, 5-pole captive screw receptacle (balanced or unbalanced)

Balanced Mono Input

Tip

Ring

Sleeve

L R

Balanced Stereo Input

Tip

Ring

Tip

Ring

Slee sve

L R

Unbalanced Stereo Input

Tip

Slee

Tip

L R

Unbalanced Mono Input

Tip

Sleeve

L R

CLASS 2 WIRING

100V OUTPUT

Tip (+)

Slee ( )ve

RCA Connector

Slee ( )ve

Ring (R)

Tip (L)

3.5 mm TRS Connector

OUTPUT

100V

MPA 401-70V and MPA 401-100V • Setup Guide (Cont’d)

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

Extron Europe

+800.3987.6673

(Inside Europe Only)

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.299.1800

+971.4.299.1880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

(Inside India Only)

+91.80.3055.3777

+91.80.3055.3737 FAX

Rev C 05 13

NOTES:

• The input receptacle may be labeled in one of two ways: the ground pins of the input

connector port may be labeled or (see the images to the right). The wiring and

function are the same whichever way the product is labeled

• The MPA 401 amplifier sums the left and right signals from both the TRS and RCA

inputs to form Sum 1. Sum 1 is then weighted. At the same time, the amplifier sums

the left and right signals from the captive screw input to form Sum 2. Sum 1 and Sum 2

are then summed together to form a single mono signal. See figure 6 on page 9 of the

MPA401 Series User Guide for more details.

• The captive screw, RCA and TRS inputs are buffered.

Ensure that the audio output of the projector is set to variable out. Multiple input options can be

used simultaneously and result in summing.

Step 5 — Connect power cords to the MPA 401 and other audio

equipment. The MPA401 ships with an Extron 36W desktop power

supply.

Connect the pre-wired captive screw connector into one of the two pole,

3.5 mm captive screw outlets on the power supply and the other end into

the power receptacle on the amplier (see the gure to the right). The

power cord connectors are correctly wired when shipped.

ATTENTION:

• See the attention notices in the Power Input section of the

MPA401 Series User Guide for important information about using

power supplies.

• When the 36 W power supply is connected to the MPA 401, it

must not be shared with any other devices.

Step 6 — Adjust the MPA 401 input level, bass, and treble from the front panel (see gure at right).

1. If necessary, unplug the remote connector from the unit (see step 7, below).

2. If connecting the amplier to a system with adjustable volume, set the volume to its lowest

point. Then adjust the MPA401 front panel level potentiometer fully counterclockwise.

3. Set the system volume to its maximum volume level (no sound should come out).

4. Return to the MPA 401 and raise the level until sound distortion rst occurs, then lower slightly until the distortion disappears.

This setting ensures that, whatever the system volume setting may be, no clipping occurs.

5. Adjust bass and treble to preference.

Step 7 — The rear panel 3-pole Remote captive screw receptacle on the amplier can be

used for remote control of the volume by an Extron volume controller such as an Extron

VCM100 AAP, VC 50, or MLA VC10 Plus. A MediaLink controller can also adjust the audio

volume via a network connection or by IR remote (see the MPA 401 Series User Guide).

NOTE: Control signal ground pins may be labeled as or “G.” The wiring and function

are the same, whichever way the product is labeled.

BASSLEVEL TREBLE

MINI POWER AMPLIFIER

MPA 401

Power Receptacle

DC Power Cord

Captive Scr Connectorew

MPA 401 series

Amplifier

DC Powe

Outputs

AC Power Cord

Tie

Wrap

Captive Screw

Connector

Power Supply

Output Cord

36 W Power Supply

12V

1.5A MAX

INPUTS

L (MONO)

(SUMMED)

INPUTS

V C G

10V 50mA

REMOTE

VOL/MUTE

10V 50mA

Produkt Specifikationer

Mærke:	Extron
Kategori:	Modtager
Model:	MPA 401-100V

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron MPA 401-100V stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Extron Manualer

Extron XTP R HWP 201 4K Manual

30 September 2024

Extron DP DA2 Manual

24 September 2024

Extron DA HD 8K L Manual

11 September 2024

Extron DVI DA Plus Series Manual

11 September 2024

Extron DA HD 4K Manual

11 September 2024

Extron XPA U 2002 SB Manual

7 September 2024

Extron XPA U 3502 Manual

7 September 2024

Extron DTP2 R 211 Manual

7 September 2024

Extron XTP SFR HD 4K Manual

6 September 2024

Extron XPA U 1002 Manual

6 September 2024

Modtager Manualer

Nyeste Modtager Manualer

Planet Audio PSX26 Manual

15 Juni 2025

Planet Audio AC1200.2 Manual

15 Juni 2025

Planet Audio AC2400.4 Manual

15 Juni 2025

Planet Audio AC2600.2 Manual

15 Juni 2025

Planet Audio PL1500.1M Manual

15 Juni 2025

Ecler HSA2-400ES Manual

15 Juni 2025

Planet Audio PL4000.1D Manual

15 Juni 2025

Planet Audio MB1200.4D Manual

15 Juni 2025

Pure Acoustics AZ-2U-3240 Manual

15 Juni 2025

Ecler AURA-4B600 Manual

15 Juni 2025