Extron XPA U 1004 Manual

Extron Modtager XPA U 1004

Læs gratis den danske manual til Extron XPA U 1004 (3 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Extron XPA U 1004, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

XPA Ultra Series Audio Power Ampliﬁers • Setup Guide

(XPA U 358, XPA U 358-70V, XPA U 358-100V, XPA U 358C-70V, XPA U 358C-100V, XPA U 1004,

XPA U 1004-70V, XPA U 1004-100V, XPA U 1004C-70V, XPA U 1004C-100V, XPA U 1002,

XPA U 1002-70V, XPA U 1002-100V)

WARNING: Installation and service must be performed by experienced, professional installers only.

AVERTISSEMENT : L’installation et l’entretien doivent être effectués par des installateurs professionnels

expérimentés.

This guide provides startup instructions for experienced, professional installers to set up and operate the XPA Ultra Series audio

power ampliers. All references are to the XPA Ultra Series User Guide which can be found on www.extron.com.

Step 1 — Powering Down Equipment

Be sure that power to the amplier is turned off rst.

NOTE: Adjust the audio level to (full attenuation) prior to powering the amplier in Step 7 on page3.=

Turn off all other equipment and disconnect the power cables. Verify that the amplier is disconnected from the power source

before proceeding.

Step 2 — Mounting and Applications

Rack Mounting

The XPA Ultra Series ampliers can be rack mounted using one of the following methods.

NOTE: See the XPA Ultra Series User Guide for instructions on mounting to a rack shelf.

Rack Ear Mounting (Single Unit)

The XPA Ultra Series ampliers ship with a set of rack ears so the half rack-width ampliers can be installed in a full rack-width

space.

Mount the amplifier with the rack ears as follows:

1. If feet were installed on the bottom of the amplier, remove them.

2. Attach the included rack ears to the sides of the amplier with the four provided #6 machine screws (

1 in the gure below).

3. Insert the amplier into the rack, align the holes in the rack ears with the holes on the rack.

4. Secure the amplier to the rack using four provided 10-32 x 3/4” screws (2 in the gure below).

XPA U 1 004 SER IES

1 2 3 4

OVER

TEMP

LIMITE R/PRO T E C T

S IGNAL

POWER AMPL IFIERS

XPA U 10 04 SER IES

1234

OVER

TEMP L IMITER/P ROT E C T

S IGNAL

POWER AMPL

IFIERS

Bridge Plate Rack Mounting (Side-by-Side Units)

The XPA Ultra Series ampliers ship with a bridge plate connector for connecting two XPA Ultra Series ampliers together to form

a full rack-width unit.

Connect and mount two XPA Ultra Series amplifiers as follows:

1. If feet were installed on the bottom of the ampliers, remove them.

2. Position the two ampliers upside down and next to each other (see the gure below).

3. Use the bridge plate connector and four provided #4 machine screws to connect the two ampliers together (1 in the gure

below).

4. Attach the two short rack ears to the ampliers with four provided #6 machine screws (

2 in the gure below).

5. Insert the ampliers into the rack, align the holes in the rack ears with the holes on the rack.

6. Secure the amplier to the rack using four provided 10-32 x 3/4” screws (3 in the gure below).

XPA U 1

04 SERIES

1 2 3 4

OVER

TEMP LIMITE R/P RO T E

SIG NAL

POWER AMPLIFIERS

XPA U 1004 SERIES

1 2 3 4

OVER

TEMP L

IMITER/P R

OTE C T

IGNAL

POWER AMPLIFIE RS

Mounting

screws (4)

XPA U 1004 S ERIE

1 2 3 4

OVER

TEMP LIMITER/PROTECT

SIGNAL

POWER AMPLIFIER

XPA U 1004 S ERIES

1 2 3 4

OVER

TEMP LIMITER/PROTECT

SIGNAL

POWER

AMPL

IFIERS

Rack Mounting Ventilation Recommendations

Excessive heat can decrease the optimal lifetime of the power amplier.

An over temp indicator LED on the front panel of the amplier lights red

whenever the recommended operating temperature has been exceeded.

To reduce the chances of an over temp condition, the XPA Ultra ampliers

should be arranged in a rack environment so the environment around the

amplier does not reach or exceed +122 °F (+50 °C). No more than four

stacks of XPA Ultra ampliers should be arranged one-on-top-of-the-other

in a rack without an open space between the stacks (see the gure to the

right).

XPA Ultra ampliers can also be arranged above or below another

non-XPA Ultra device. In this case, the environment around the amplier

should not reach or exceed +122 °F (+50 °C).

Step 3 — Captive Screw Audio Cable Wiring

Wire the source output to the amplier 3.5 mm captive screw input connectors as shown in the following illustrations.

Balanced Stereo Input

Tip

Ring

Tip

Ring

Slee

ves

L R

Unbalanced Stereo Input

Tip

Sleeve

Tip

L R

Do not tin

the wires!

Balanced Dual Mono Input

Tip

Ring

Slee (s)ve

Tip

Ring

L R

Unbalanced Dual Mono Input

Tip

Sleeve

Tip

Sleeve

L R

Vent Space

Produkt Specifikationer

Mærke:	Extron
Kategori:	Modtager
Model:	XPA U 1004

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron XPA U 1004 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Extron Manualer

Extron XTP R HWP 201 4K Manual

30 September 2024

Extron DP DA2 Manual

24 September 2024

Extron DA HD 8K L Manual

11 September 2024

Extron DVI DA Plus Series Manual

11 September 2024

Extron DA HD 4K Manual

11 September 2024

Extron XPA U 2002 SB Manual

7 September 2024

Extron XPA U 3502 Manual

7 September 2024

Extron DTP2 R 211 Manual

7 September 2024

Extron XTP SFR HD 4K Manual

6 September 2024

Extron XPA U 1002 Manual

6 September 2024

Modtager Manualer

Nyeste Modtager Manualer

Ecler AURA-4B900 Manual

16 Juni 2025

Ecler AURA-2B900 Manual

15 Juni 2025

Planet Audio PSX26 Manual

15 Juni 2025

Planet Audio AC1200.2 Manual

15 Juni 2025

Planet Audio AC2400.4 Manual

15 Juni 2025

Planet Audio AC2600.2 Manual

15 Juni 2025

Planet Audio PL1500.1M Manual

15 Juni 2025

Ecler HSA2-400ES Manual

15 Juni 2025

Planet Audio PL4000.1D Manual

15 Juni 2025

Planet Audio MB1200.4D Manual

15 Juni 2025