Fusion SG-F77W Manual

Fusion Højttaler SG-F77W

Læs gratis den danske manual til Fusion SG-F77W (34 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 6 anmeldelser. Har du et spørgsmål om Fusion SG-F77W, eller vil du spørge andre brugere om produktet?

Side 1/34
®
Signature Series Subwoofer Installation Instructions ........................................................................2
Instructions d'installation du caisson de basse Signature Series ......................................................6
Subwoofer Signature Series Istruzioni di installazione ................................................................... 11
Subwoofer der Signature Series – Installationsanweisungen ......................................................... 15
Instrucciones de instalación del subwoofer de la Signature Series ................................................ 20
Signature Series da série esportiva da marca ................................................................................ 25
Signature Series subwooferinstallatie-instructies ........................................................................... 30
Garmin®, the Garmin logo, and the Fusion
logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. Fusion and True-Marine
are trademarks of Garmin Ltd. or its
subsidiaries. These trademarks may not be used without the express permission of Garmin.
December 2014 190-01845-90_0APrinted in China
Signature Series Subwoofer
Installation Instructions
Important Safety Information
WARNING
Failure to follow these warnings and cautions could result in
personal injury, damage to the vessel, or poor product
performance.
See the guide in the Important Safety and Product Information
product box for product warnings and other important
information.
This device must be installed according to these instructions.
Disconnect the vessel's power supply before beginning to install
this product.
CAUTION
Audio systems can produce sound pressure levels exceeding
135 dB. Continuous exposure to sound pressure levels over
100 dB may cause permanent hearing loss. The volume is
typically too loud if you cannot hear people speaking around
you. Limit the amount of time you listen at high volume. If you
experience ringing in your ears or muffled speech, stop listening
and have your hearing checked.
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite
side of the surface.
It is strongly recommended that you have your audio system
installed by a professional installer to ensure optimum
performance.
You must read all installation instructions before beginning the
installation. If you experience difficulty during the installation, go
to for product support.www.fusionentertainment.com
After installing the subwoofer, you should run the subwoofer at
low to medium volumes for the first few hours of use. This helps
to improve the overall sound by gradually loosening up the
moving components of the subwoofer, such as the cone, spider,
and surround
What's In the Box
1 subwoofer
6 Phillips stainless steel, 4.8 mm x 50 mm (10 gauge x 2 in.)
mounting screws
Mounting template
Grille (Classic models only)
1 tinned LED connection cable (6 m) (Sports models only)
Hex key (Sports models only)
Tools Needed
Electric drill
Drill bit (size varies based on surface material)
Phillips screwdriver
Wire strippers
Crimping tool
Electrical tape
Appropriate saw or utility knife to cut surface material
Suitable gauge speaker wire for the length required
NOTE: For customized installations, additional tools and
materials may be needed.
Mounting Considerations
Selecting the correct mounting location is critical to optimize the
performance of the audio system. Fusion
subwoofer is
designed to perform in the widest possible range of mounting
locations, but the more you plan the installation, the better the
subwoofer's sound will be.
The audio system must be turned off before making any
connections. Failure to do so could result in permanent
damage to the audio system.
You should protect all terminals and connections from
grounding and from each other. Failure to do so could result
in permanent damage to the audio system and voids the
product warranty.
You should protect the wires from sharp objects and always
use rubber grommets when wiring through panels.
The mounting location must avoid potential obstacles, such
as fuel and hydraulic lines and wiring.
The mounting location must provide sufficient clearance for
the mounting depth of the subwoofer as specified in the side
view drawings and the specifications.
When possible, the area behind each subwoofer should be
enclosed.
To avoid interference with a magnetic compass, the
subwoofer should not be installed closer to a compass than
the compass-safe distance value listed in the product
specifications.
You should select a flat mounting surface for the best seal.
For better bass performance, the subwoofer should be
mounted in an area that provides just enough room behind
the subwoofer. Too small an area restricts bass, and too
large an area compromises bass performance. Placing a
subwoofer close to an open area produces the least bass.
When a subwoofer is not exposed to the outside
environment, a better bass performance can be achieved
using an enclosure that has a ported design. See the
optimum enclosure design recommendations. Those
recommendations specify volume only, and for the ported
option, an optimum port size and length are also provided.
If you intend to mount the subwoofer outside the boat, follow
these considerations.
When mounted correctly, the subwoofer is rated IP65 for
protection in the harsh marine environment from the front
of the subwoofer. Water exposure and damage to the rear
of the subwoofer voids the warranty.
The subwoofer must be mounted in a location well above
the waterline, where it is not submerged.
The subwoofer must be mounted in a location where it
cannot be damaged by docks, pilings, or other pieces of
equipment.
The subwoofer should be mounted in a sealed enclosure,
especially if it is exposed to wash down. A port or vent
may allow water to collect in the enclosure and damage
the subwoofer.
Mounting the Subwoofer
Before mounting the subwoofer, you must choose a location
where there is enough clearance behind the mounting surface.
Refer to the side view drawing and the specifications for
clearance information.
Before mounting the subwoofer, you must choose a location
following the mounting considerations.
If you are replacing a Fusion MS-SW10 10" subwoofer with the
Signature Series Classic model 10" subwoofer, see Replacing a
Fusion MS-SW10 10" Subwoofer.
1Route the wires from the source to the mounting location,
away from sources of electrical interference.
2


Produkt Specifikationer

Mærke: Fusion
Kategori: Højttaler
Model: SG-F77W

Har du brug for hjælp?

Hvis du har brug for hjælp til Fusion SG-F77W stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler Fusion Manualer

Fusion

Fusion EL-F653W Manual

9 Januar 2025
Fusion

Fusion SG-CL65SP Manual

20 August 2024
Fusion

Fusion XS-F40CWB Manual

19 August 2024
Fusion

Fusion MS-EL602 Manual

18 August 2024
Fusion

Fusion XS-F65SPGW Manual

17 August 2024
Fusion

Fusion XS-FL65SPGW Manual

16 August 2024
Fusion

Fusion SG-F65W Manual

16 August 2024
Fusion

Fusion FM-F65RW Manual

16 August 2024
Fusion

Fusion SG-F772W Manual

16 August 2024
Fusion

Fusion SG-FL882SPC Manual

16 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer