Garmin BC 35 Manual

Garmin Bakkamera BC 35

Læs gratis den danske manual til Garmin BC 35 (34 sider) i kategorien Bakkamera. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om Garmin BC 35, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/34
BC™ 35 BACKUP WIRELESS CAMERA
Installation Instructions 2
Instructions d'installation 5
Istruzioni di installazione 8
Installationsanweisungen 11
Instrucciones de instalación 14
Instruções de Instalação 17
Installatie-instructies 20
Installationsvejledning 23
Asennusohjeet 26
Installeringsinstruksjoner 28
Installationsinstruktioner 30
Instrukcja instalacji 32
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. BC™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be
used without the express permission of Garmin.
February 2018
190-02351-91_0A
BC™ 35 WIRELESS BACKUP
CAMERA
Installation Instructions
Introduction
WARNING
See the guide in the Important Safety and Product Information
product box for product warnings and other important
information.
Garmin® strongly recommends having an experienced installer
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
When connecting the power cable, do not remove the in-line
fuse holder. To prevent the possibility of injury or product
damage caused by fire or overheating, the appropriate fuse
must be in place as indicated in the product specifications. In
addition, connecting the power cable without the appropriate
fuse in place will void the product warranty.
CAUTION
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite
side of the surface.
These installation instructions do not apply to a specific vehicle
type, and are meant as a guide when installing this product on
your vehicle. For questions specific to your vehicle, you should
contact the vehicle manufacturer.
Device Overview
Item Description
ÀTransmitter
ÁCamera
ÂCamera mounting bracket
Tools Needed
• Drill and 10 mm, or size X (0.397 in.) drill bit
• #2 Phillips screwdriver
• Screws, bolts, or cable ties (to secure the transmitter)
• Solderless wire-splice connector or solder and heat-shrink
tubing
• RV sealant (optional)
Installation
Camera Mounting Considerations
When selecting a location to mount the camera, observe these
considerations.
• You should test a mounting location before you permanently
mount the camera.
• Installing the camera higher on the back of the vehicle
provides a better viewing angle.
• The included bracket can be clipped onto a license plate or
other similar surface, or it can be fastened to the back of the
vehicle using the included self-tapping, panhead screws.
Transmitter Location and Wiring Considerations
NOTICE
The transmitter is not intended to be held or worn on your body
while it is in use.
When selecting a location to install the wireless transmitter,
observe these considerations.
• You should test a proposed installation location before you
permanently install the transmitter.
• Some vehicles do not provide constant minimum voltage to
the reverse lamps. You should use an automotive relay when
connecting the transmitter and camera to a power source that
does not provide constant voltage.
• Although the transmitter can transmit the video signal
approximately 45 ft (13.5 m), the location of the transmitter
can affect this range.
◦ The closer you install the transmitter to the device, the
more reliable the signal.
◦ The signal transmits from the flat front and back surfaces
À of the transmitter. The transmitter provides the best
signal when either flat surface points toward the receiver.
◦ Dense metal or appliances Á in the path of the transmitter
greatly reduce the transmission distance.
◦ The fewer solid objects that exist between the path of the
transmitter and the device, the more reliable the signal.
• The fuse holder located near the transmitter is not
waterproof. Installing the fuse holder in a location that is
exposed to the elements is not recommended.
• The connector between the camera and the transmitter is not
waterproof. If you make this connection in a location exposed
to the elements, you must make sure that the connection is
waterproof.
• If you are installing the camera on a boat trailer or other
location that may be exposed to water, you must waterproof
all wiring connections and the fuse holder in the transmitter
cable.
Testing the Camera and Transmitter Location
1Temporarily secure the camera in the preferred mounting
location.
2Temporarily place the transmitter in the preferred installation
location, and connect it to power and to the camera.
TIP: If you do not want to splice into the wiring of your vehicle
for this test, you can connect the transmitter and camera to a
12 Vdc battery.
3Test the transmitter for correct operation by viewing the
camera on the compatible Garmin device.
NOTE: You may need to pair the camera to the Garmin
device before you can view the image and test the transmitter
location (Pairing the Camera with a Garmin Navigation
Device, page 3).
2 Installation Instructions

Produkt Specifikationer

Mærke: Garmin
Kategori: Bakkamera
Model: BC 35

Har du brug for hjælp?

Hvis du har brug for hjælp til Garmin BC 35 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Bakkamera Garmin Manualer

Garmin

Garmin BC 35 Manual

21 September 2024
Garmin

Garmin BC 20 Manual

21 Juli 2024
Garmin

Garmin Varia Radar Manual

28 Juni 2024
Garmin

Garmin BC 40 Manual

5 Oktober 2022

Bakkamera Manualer

Nyeste Bakkamera Manualer

Pioneer

Pioneer ND-BC9 Manual

29 Maj 2025
Dometic

Dometic PerfectView CAM 18 Manual

20 Februar 2025
Dometic

Dometic PerfectView CAM35 2.0 Manual

11 Januar 2025
Kenwood

Kenwood CMOS-C230 Manual

30 December 2025
CRUX

CRUX CMB-17C Manual

29 December 2024
CRUX

CRUX CMB-16K Manual

29 December 2024
CRUX

CRUX CMB-16G Manual

29 December 2024
CRUX

CRUX CMB-15S Manual

29 December 2024
Pyle

Pyle PLCM4340 Manual

6 December 2024
Dometic

Dometic PerfectView CAM 11 Manual

26 November 2024