Genelec F One Manual

Genelec Subwoofer F One

Læs gratis den danske manual til Genelec F One (13 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 50 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 25.5 anmeldelser. Har du et spørgsmål om Genelec F One, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/13
Operating Manual
操作手册
F One
F One Active Subwoofer
General description
The Genelec F One is a very compact
active subwoofer designed to complement
Genelec G One or G Two active loudspeak-
ers. The F One extends the system’s bass
response down to 35 Hz and integrates
perfectly with the main loudspeakers in
any environment. The playback level for the
whole system is conveniently controlled by
the wireless volume control provided with
the subwoofer. A wired volume control is
available as an option.
The F One has integrated bass manage-
ment for the two output channels which
directs frequencies below 85 Hz to the
subwoofer and higher frequencies through
the output connectors to the main loud-
speakers. When using the subwoofer for the
.1/LFE channel of a multichannel system, we
recommend that bass management is done
in the processor or receiver and only the LFE
channel is connected to the subwoofer.
Installation
Before connecting the audio signals, ensure
that all equipment is switched off.
As the F One contains its own amplier, no
separate power amplier is needed. Never
connect the F One to the loudspeaker out-
puts of a power amplier, integrated ampli-
er or receiver.
Please follow the steps listed below for a
succesful setting up of the subwoofer:
1. Check the contents of the shipment.
in addition to the subwoofer, there is a
wireless remote control, a mains cable,
an IR extension cable and a Quick Setup
Guide.
2. Pull out the battery insulating strip from
the underside of the remote control as
shown in gure 1. This strip insulates the
battery from the contacts on the remote
control during shipping and the remote
control does not function before it is
removed.
3. Place the subwoofer in its position.
4. Connect audio cables from your signal
source(s). You can connect up to two
digital audio sources and two analog
audio sources.
5. Connect the main loudspeakers to the
output connectors of the subwoofer.
6. Adjust the phase of the subwoofer as
instructed in this manual and the Quick
Setup Guide.
7. Use test recordings and familiar music
pieces to judge the sound balance. Use
the “SUBWOOFER LEVEL” rotary control
and the “BASS ROLL-OFF” dip switches
to ne-tune the balance. If this fails,
consider relocating the subwoofer.
Operating Environment
The F One subwoofer is designed for
indoor use only. The ambient temperature
should be 15-35 °C (50-95 °F) and the rela-
tive humidity 20-80 %. Condensation is not
allowed. If it has been stored or transported
in a cool environment, the product must be
allowed to warm up in its packing to the
ambient temperature before connecting
mains power.
Connectors
The F One is equipped with both analog
and digital signal input connectors, that
can be used simultaneously to connect
up to four audio sources (two analog, two
digital). Switching between sources is done
with the Select button on the connector
panel or with the “<” and “>” buttons on
the remote control. The colour of the LED
light on the subwoofer enclosure indicates
which source is selected.
Analog Input Connectors
The F One has two stereo inputs (3.5 mm
jack and L/R RCA connectors) and an LFE
RCA connector. The stereo inputs are par-
allel, so you can connect two audio sources
at the same time, just play only one of them
at a time. The Select function does not
work between these two inputs. The LFE
input is used for the LFE (.1) signal in a
2.1 or 5.1 channel sound system. The LFE
input has a 120 Hz low pass lter, so it is
not suitable for full frequency range signals.
Digital Input Connectors
The F One has two digital signal input con-
nectors, one coaxial and one optical, that
accept stereo PCM format digital signal. You
can connect two digital sources and switch
between them using the Select function.
Figure 1. Removing the battery insulating strip
from the remote control

Produkt Specifikationer

Mærke: Genelec
Kategori: Subwoofer
Model: F One

Har du brug for hjælp?

Hvis du har brug for hjælp til Genelec F One stil et spørgsmål nedenfor, og andre brugere vil svare dig


Subwoofer Genelec Manualer

Genelec

Genelec 7382A Manual

29 Juli 2024
Genelec

Genelec 7071A Manual

22 Juli 2024
Genelec

Genelec 7040A Manual

22 Juli 2024
Genelec

Genelec 7050 CPM Manual

13 April 2024
Genelec

Genelec 5041A Manual

10 Februar 2024
Genelec

Genelec 7370APM Manual

17 Januar 2024
Genelec

Genelec 7360APM Manual

16 Juni 2023
Genelec

Genelec F One Manual

14 Januar 2023

Subwoofer Manualer

Nyeste Subwoofer Manualer

Audison

Audison Prima APBMW S8-2.2 Manual

28 September 2025
Audison

Audison Prima APBMW S8-4.2 Manual

28 September 2025
Boston Acoustics

Boston Acoustics BT1100 Manual

25 September 2025
Boston Acoustics

Boston Acoustics Classic CPS 10Wi Manual

25 September 2025
Boston Acoustics

Boston Acoustics Classic CPS 8Wi Manual

24 September 2025
Boston Acoustics

Boston Acoustics Classic CPS 12Wi Manual

24 September 2025
Ground Zero

Ground Zero GZRW 250-D2 FLAT Manual

24 September 2025
Ground Zero

Ground Zero GZNW 38NEO-SPL Manual

24 September 2025
Ground Zero

Ground Zero GZIW 200 Manual

24 September 2025
Ground Zero

Ground Zero GZIW 250 Manual

24 September 2025