Harley Davidson J03893 (2005) Manual

Harley Davidson Motor J03893 (2005)

Læs gratis den danske manual til Harley Davidson J03893 (2005) (2 sider) i kategorien Motor. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Harley Davidson J03893 (2005), eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

-J03893 REV. 2005-08-10

FLHTCUSE HEATED SEAT KIT

GENERAL

Kit Number

51718-06

Models

This kit ﬁts 1997 and later FLHT/I (Electra Glide

® Standard),

FLHTC/I (Electra Glide Classic) and FLHTCUI (Ultra Classic®

Electra Glide), and 1998 and later FLTR/I (Road Glide®)

models.

Additional Parts Required

If another accessory is already using the accessory circuit

connector [4] (under the seat, see Figure 1), the Heated Seat

Kit will require a Switched Circuit Adapter Harness (Part No.

70264-94A), available separately from a Harley-Davidson

dealer.

Electrical Overload

It is possible to overload your motorcycle's charging

system by adding too many electrical accessories. If your

combined electrical accessories operating at any one time

consume more electrical current than your vehicle's

charging system can produce, the electrical consumption

can discharge the battery and cause vehicle electrical

system damage. See a Harley-Davidson dealer for advice

about the amount of current consumed by additional

electrical accessories, or for necessary wiring changes.

(00211b)

When installing any electrical accessory, be certain not

to exceed the maximum amperage rating of the fuse or

circuit breaker protecting the aﬀected circuit being modi-

ﬁed. Exceeding the maximum amperage can lead to elec-

trical failures, which could result in death or serious injury.

(00310a)

The Heated Seat requires up to additional current4.2 Amps

from the electrical system.

Kit Contents

Table 1. Kit Contents

Part NumberDescription (Quantity)

Not Sold SeparatelyHeated seat

51479-06Grab strap

INSTALLATION

1. For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR

models:

a. Follow the instructions in the Owner's Manual to

remove the left-side and right-side saddlebags

b. Remove the bolts and ﬂat washers to remove the

passenger grab strap and saddlebag front mounting

brackets from the chrome frame tube covers.

c. Remove the passenger grab strap.

2. ALL models: Follow the instructions in the Owner's

Manual to remove the seat.

To prevent accidental vehicle start-up, which could cause

death or serious injury, disconnect negative (-) battery

cable before proceeding. (00048a)

3. Follow the instructions in the Owner's Manual to remove

the negative (-) battery cable from the battery.

4. See Figure 1. Identify and remove the plug from the

accessory circuit connector [4] in front of the battery.

is01034

Figure 1. Accessory Circuit Connector [4] (2004 and Later

Shown)

5. Locate the heated seat connector on the underside of the

heated seat.

-J03893 1 of 2

NOTE

If another accessory is already using the accessory circuit

connector [4], use a Switched Circuit Adapter Harness (Part

No. 70264-94A, available separately) as a "Y" adapter.

6. Mate the heated seat connector to the accessory circuit

connector [4].

7. Follow the instructions in the Owner's Manual to re-connect

the negative (-) battery cable.

8. Guide the wiring into the space beneath the seat so that

the wiring will not be crimped when the seat is installed.

9. Follow the instructions in the Owner's Manual to install the

seat.

After installing seat, pull upward on seat to be sure it is

locked in position. While riding, a loose seat can shift

causing loss of control, which could result in death or

serious injury. (00070b)

10. For 1997 through 2005 FLHT/I/C/CI/CUI models: Pro-

ceed to the OPERATION section.

For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR

models:

a. See Figure 2. Obtain the passenger grab strapnew

(1) from the kit, and the saddlebag front mounting

brackets (4), bolts (3) and ﬂat washers (2) removed

earlier.

b. Install the saddlebag front mounting brackets and

grab strap as shown to the chrome frame tube covers.

Finger-tighten the bolts.

c. Follow the instructions in the Owner's Manual to re-

install the left-side and right-side saddlebags.

d. Tighten the mounting bolts to 60-96 (7-11 Nm)in-lbs

after seating the saddlebags.

is01041

1. Passenger grab strap

2. Original equipment ﬂat washer

3. Original equipment hex head bolt

4. Forward saddlebag mounting bracket

Figure 2. Grab Strap and Saddlebag Front Mounting

Bracket

OPERATION

NOTE

The accessory switch is a rocker switch found on the inner

fairing switch panel.

1. With the ignition/key switch at IGNITION or ACCESS,

open the circuit to the heated seat by ﬂipping the

accessory switch from OFF to ON.

2. Two switches on the side of the seat control the rider and

passenger heating areas independently. The forward

switch controls the rider area, and the rearward switch

controls the passenger area.

a. In the center position, the heat to that area of the seat

is OFF.

b. Pressing the lower part of the switch in toward the

seat turns the heat in that area ON at the LOW set-

ting.

c. Pressing the upper part of the switch in toward the

seat turns the heat in that area ON at the HIGH set-

ting.

NOTES

If the accessory switch is left ON and a seat heater rocker

switch is left in either the LOW or HIGH position when the

motorcycle is turned oﬀ, the seat will begin heating when the

ignition/ key switch is turned to the IGNITION or ACCESS

position.

A seat heater in operation while the motorcycle engine is

turned oﬀ or running below normal operating speed can

quickly discharge the vehicle battery, which could lead to

a subsequent failure to start, and could damage the elec-

trical system.

is01042

1. Rider section heat control switch

2. Passenger section heat control switch

3. Low heat position

4. High heat position

Figure 3. Seat Heating Control Switches

-J03893 2 of 2

Produkt Specifikationer

Mærke:	Harley Davidson
Kategori:	Motor
Model:	J03893 (2005)

Har du brug for hjælp?

Hvis du har brug for hjælp til Harley Davidson J03893 (2005) stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Motor Harley Davidson Manualer

Harley Davidson Sportster (2005) Manual

29 September 2024

Harley Davidson J01521 (1999) Manual

22 September 2024

Harley Davidson Dyna (2005) Manual

17 September 2024

Harley Davidson J02830 (2003) Manual

26 August 2024

Harley Davidson 1200 Custom (2016) Manual

19 August 2024

Harley Davidson CVO (2005) Manual

6 August 2024

Harley Davidson J03893 (2005) Manual

6 August 2024

Harley Davidson J02909 (2003) Manual

5 August 2024

Harley Davidson J04409 (2011) Manual

2 August 2024

Harley Davidson Softail (2005) Manual

2 August 2024

Motor Manualer

Nyeste Motor Manualer

Suzuki TL1000S Manual

15 Januar 2025

BodyCraft R1000 Manual

10 Januar 2025

Honda CBF125M (2024) Manual

8 Januar 2025

Honda CL500A (2025) Manual

8 Januar 2025

Honda Fury (2025) Manual

2 Januar 2025

Hero Mavrick 440 (2024) Manual

31 December 2025

Honda Rally CRF250 (2017) Manual

31 December 2025

Honda Goldwing (2014) Manual

31 December 2025

Honda Goldwing (2012) Manual

31 December 2025

Bajaj Dominar 400 Manual

30 December 2025