Henry Engineering USB Matchbox II Manual

Henry Engineering Ikke kategoriseret USB Matchbox II

Læs gratis den danske manual til Henry Engineering USB Matchbox II (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Henry Engineering USB Matchbox II, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
USB MATCHBOX II
USB<>XLR MULTIMODE DIGITAL AUDIO CODEC
DESCRIPTION
The USB Matchbox II is a high-performance professional audio codec. Used in place of a computer “sound card”, it
provides stereo analog inputs and outputs at professional studio levels, an AES/EBU output, and a Headphone
output for critical monitoring. The USB Matchbox II yields superb “audiophile” performance with the convenience of
any audio recording/editing software that supports a USB sound device. No special software or driver is needed.
A USB 1.1 (or higher) connection to th the AES-48-2005 the PC is required. The USB Matchbox II complies wi
grounding standard.
INSTALLATION
ANALOG LINE INPUTS/OUTPUTS: Connect balanced analog inputs and output to the XLR connectors as follows:
Pin 1 = GND, Pin 2 = HI, Pin 3 = LOW.
NOTE: Ground loops cause hum, buzz, and other noises that are created by the computer mouse, drives, fan, and
keyboard. Prevent noise by connecting ground wires at one end only.
The HEADPHONE output can be used to monitor the “play” output of the system. Use contemporary headphones
with an impedance of 24 ohms or greater. Do NOT use older “8 ohm” headphones. The VOLUME control adjusts
the headphone level. Warning! Excessive listening levels can cause permanent hearing damage.
DIGITAL OUTPUT: Connect to the AES/EBU digital output XLR connector as follows:
Pin 1 = GND, Pin 2 = HI, Pin 3 = LOW. (The AES/EBU output is transformer isolated.)
COMPUTER CONNECTION:
First, close any audio-related programs. Use a USB cable to connect the USB Matchbox II to any USB port on the
PC. The computer should recognize the USB Matchbox II as “ No additional software or USB Audio Codec”.
drivers are needed. When audio software is started, it may be necessary to change its Settings to select the
USB Audio Codec as its default.
WINDOWS* VOLUME SETTING
BEFORE USING USB MATCHBOX II
, be sure to check the Windows “SPEAKER VOLUME” setting. The Speaker
Volume can be accessed via the Windows Control Panel under “Sound and audio devices” or “Adjust the system
volume”. Select “Volume” or “Set system volume”, then adjust the slider. In most cases, the Speaker Volume
should be set to MAXIMUM.
*Windows is a registered trademark of Microsoft Corporation.
OUTPUT LEVEL CALIBRATION
The USB Matchbox II is calibrated to operate with analog I/O levels of +4 dBu. Input and Output levels can be
changed via the recessed trimmers; use a small screwdriver to carefully adjust. NOTE: There is 15 dB of digital
headroom above +4 dBu: a calibration tone recorded at 0 dBfs will produce an output level of about +19 dBu.
OPERATION
To record, feed audio into the unit. Set the INPUT LEVEL trimmers as necessary, as indicated by the software
being used. To play a recording, simply play the file. Audio will be present on the XLR analog outputs, Headphone
jack, and on the AES/EBU digital output. (The Headphone output monitors “playback” audio only.)
SPECIFICATIONS
Balanced analog inputs Stereo, nom. +4 dBu @ -15 dBfs, 20K ohms input impedance, XLR X 2
Balanced analog outputs Stereo, nom. +4 dBu @ -15 dBfs, +24 dBu max level, 600 ohms, XLR X 2
AES/EBU digital output Transformer isolated, 110 ohms, XLR connector
Headphones output For headphones, 24 ohms or higher; 3.5mm stereo jack
Sample rates supported 48, 44.1, or 32 kHz, software defined
Resolution, dynamic range 16 bit stereo or mono, software defined
USB supported USB 1.1 or higher
Power Input 115 or 230 VAC, 50-60 Hz, 2W, + USB power
Approval City of Los Angeles Electrical Test Lab
Physical 5.75” w X 5.50”d X 1.60”h, 3 LBS
Construction Steel enclosure
HENRY ENGINEERING
503 Key Vista Drive
Sierra Madre, CA 91024
Tel: 626.355.3656
Fax: 626.355.0077
www.henryeng.com
TM

Produkt Specifikationer

Mærke: Henry Engineering
Kategori: Ikke kategoriseret
Model: USB Matchbox II

Har du brug for hjælp?

Hvis du har brug for hjælp til Henry Engineering USB Matchbox II stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Henry Engineering Manualer

Henry Engineering

Henry Engineering Talent Pod II Manual

28 September 2025
Henry Engineering

Henry Engineering SuperLight Manual

25 December 2024
Henry Engineering

Henry Engineering MultiPhones Mini Pod Manual

25 December 2024
Henry Engineering

Henry Engineering Autoswitch Manual

25 December 2024
Henry Engineering

Henry Engineering LogiConverter Manual

25 December 2024
Henry Engineering

Henry Engineering SUPERELAY II Manual

25 December 2024
Henry Engineering

Henry Engineering SportsCaster Manual

7 December 2024
Henry Engineering

Henry Engineering TwinMatch Manual

20 November 2024
Henry Engineering

Henry Engineering Mike Alert Manual

6 September 2024
Henry Engineering

Henry Engineering MultiPort Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

MuxLab

MuxLab 500439 Manual

5 November 2025
GVM

GVM BL160-II Manual

5 November 2025
Uniprodo

Uniprodo UNI_ROLL_03 2in1 Manual

5 November 2025
Rockville

Rockville SS6 Manual

5 November 2025
Silk'n

Silk'n VacuPedi FTC04 Manual

5 November 2025
MEPROLIGHT

MEPROLIGHT MCO PRO Manual

5 November 2025
XPG

XPG Battlecruiser II Manual

5 November 2025
Hosa

Hosa USQ-110 Manual

5 November 2025
JMAZ

JMAZ Centipede Quadro Manual

5 November 2025
Lake People

Lake People Mic-Amp F311-D Manual

5 November 2025