Honeywell CT50K1028 Manual

Honeywell Termostat CT50K1028

Læs gratis den danske manual til Honeywell CT50K1028 (16 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Honeywell CT50K1028, eller vil du spørge andre brugere om produktet?

Side 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT50 Series
Thermostat
® U.S. Registered Trademark. Patents pending.
Copyright © 2009 Honeywell International Inc.
All rights reserved.
M23785
69-2040EFS-01
M23786
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
TURN OFF POWER at heating/cooling system (or fuse/circuit-breaker panel).
Remove cover and thermostat, but leave wallplate with wires attached.
Temperature Control Range
• 45°–95°F(7°–35°C)
• 35°–85°F(2°–29°C);selectmodels;forgaragesorotheroutbuildings.
Is there a sealed tube containing mercury?
If so, see mercury notice below.
Leave wallplate in place.
Old thermostat Cover
Check package contents:
• Thermostat
• Wallanchors&screws(2each)
• Wirelabels
Before you begin, make sure you have:
• No.2Phillips&smallpocketscrewdrivers
• Hammer
• Level(optional)
• Pencil
• Drillandbit(3/16”fordrywall,7/32”for
plaster)
Getting started
Remove your old thermostat
Vertical Mount:
CT50(24Vacheatingsystems)
CT51(24Vacheatingandcoolingsystems)
CT53(750mVor12Vdcheatingsystems)
Horizontal Mount:
CT54(24Vacheatingsystems)
CT55(24Vacheatingandcoolingsystems)
CT50 Series • Owner's Manual
69-2040EFS—01 2
M23789
M23787
M23790
M23788
Wrapsuppliedlabelssecurelyaroundeachwire.Do not let wires fall into wall opening!
IGNORE WIRE COLORS: Use only letter
designations to identify wire types.
ForCT51/CT55: If your old
thermostathas7ormorewires
( ), not counting terminals C or C1
you may have purchased the
wrong replacement thermostat.
Stopnowandcall1-800-468-1502
for advice.
CT50/CT53/CT54
1. Pullwires
through base.
2. Level base if
desired.
3. Markpositions
of both screw
holes.
ForCT50/CT53/CT54: If your old
thermostathas3ormorewires
( ), not counting terminals C or C1
you may have purchased the
wrong replacement thermostat.
Stopnowandcall1-800-468-1502
for advice.
Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with
the label matching the letter on your old thermostat. (Adhesive labels are supplied in your
thermostat package.)
Remove the old wallplate only after all wires are labeled. Be careful not to let loose wires fall
into the wall opening.
Label wires and remove old wallplate
Mark mounting position
CT51/CT55
CT50/CT53/CT54 CT51/CT55


Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: CT50K1028

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell CT50K1028 stil et spørgsmål nedenfor, og andre brugere vil svare dig