Honeywell CT87K1004/E1 Manual

Honeywell Termostat CT87K1004/E1

Læs gratis den danske manual til Honeywell CT87K1004/E1 (16 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Honeywell CT87K1004/E1, eller vil du spørge andre brugere om produktet?

Side 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT87N/CT87K
The Round
®
® U.S. Registered Trademark. U.S. Patents 7,159,789;
7,159,790; 7,476,988 and other patents pending.
Copyright © 2009, Honeywell International Inc.
All rights reserved.
69-1959EFS-02
The Round
®
1. CAUTION TURN OFF POWER to system at the furnace, or at the fuse/circuit breaker
panel before you begin.
2. Remove cover and thermostat, but leave wallplate with wires attached.
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
Is there a sealed tube containing
mercury? If so, see mercury notice
below.
Leave wallplate in place.
Old thermostat
Cover
Check package contents:
• Thermostat
• Coverplate
• Wallanchors&screws(2each)
• Wirelabels
Before you begin, make sure
you have:
• No.2Phillips&smallpocket
screwdrivers
• Hammer
• Level(optional)
• Pencil
• Drillandbit(3/16”fordrywall,7/32”
forplaster)
Getting started
Remove your old thermostat
CT87K(24Vacheatingsystems) • CT87N(24Vacheatingandcoolingsystems)
This thermostat contains a Lithium battery which
may contain Perchlorate material.
Perchlorate Material—special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
CT87N/CT87K • Owner's Manual
69-1959EFS—02 2
Wrap supplied labels securely around each wire. Do not let wires fall into wall opening!
IGNORE WIRE COLORS: Use only letter designations
to identify wire types.
For CT87N: If your old thermostat
has7ormorewires(not counting
terminals C or C1),youmayhave
purchased the wrong replacement
thermostat. Stop now and call
1-800-468-1502 for advice.
CT87N
1. Pull wires
through base.
2. Level base if
desired.
3. Markpositions
of both screw
holes.
R
W
Y
CT87K
For CT87K: If your old thermostat
has4ormorewires(not counting
terminals C or C1),youmayhave
purchased the wrong replacement
thermostat. Stop now and call
1-800-468-1502 for advice.
Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with
thelabelmatchingtheletteronyouroldthermostat.(Adhesivelabelsaresuppliedinyour
thermostatpackage.)
Remove the old wallplate only after all wires are labeled. Be careful not to let loose wires fall
into the wall opening.
Label wires and remove old wallplate
Mark mounting position
CT87N CT87K


Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: CT87K1004/E1

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell CT87K1004/E1 stil et spørgsmål nedenfor, og andre brugere vil svare dig