Honeywell RTH6350D1000/U Manual

Honeywell Termostat RTH6350D1000/U

Læs gratis den danske manual til Honeywell RTH6350D1000/U (40 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Honeywell RTH6350D1000/U, eller vil du spørge andre brugere om produktet?

Side 1/40
RTH6360 Series
Programmable Thermostat
RTH6360D1017
Quick Installation
Guide
Cool
PM
Tools you will need Tools you may need
Wire stripper
Needle-nose pliers Drill and
drill bit
Included in your box
Screws and
anchors
UWP™
Mounting
System
(UWP)
RTH6360
Thermostat
Quick Install Guide
Small flat head scr
ewdriver
Phillips scr
ewdriver
Pencil
Level
2
Quick Installation Guide
Removing your old thermostat
2 Check that your system is off.
Change the temperature on your
old thermostat to be above room
temperature in heat mode or below
it in cool mode. If you don’t hear the
system turn on within 5 minutes, the
power is off.
Note: If you have a digital
thermostat that has a blank display,
skip this step
1 Turn power OFF.
To protect yourself and your
equipment, Turn off the power at the
breaker box or switch that controls
your heating/cooling system.
3 Remove the old thermostat’s
faceplate.
On most thermostats, you can take
off the faceplate by grasping and
gently pulling. Some thermostats
may have screws, buttons, or clasps.
Do not remove any wires from your
thermostat at this time!
75
OFF
OFF
ON
Breaker box
Switch
4 Make sure there are no 120/240V
wires.
Do you have thick black wires with
wire nuts?
Is your thermostat 120V or higher?
If you answered yes to either of
these questions, you have a line
voltage system and the thermostat
will not work.
Wire nut
Thick black wire
Read and save these instructions


Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: RTH6350D1000/U

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell RTH6350D1000/U stil et spørgsmål nedenfor, og andre brugere vil svare dig