Honeywell X1N Manual


Læs gratis den danske manual til Honeywell X1N (56 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Honeywell X1N, eller vil du spørge andre brugere om produktet?

Side 1/56
X1N Non-Programmable
Thermostat
RTH11B/RTHC11B
Installation and User
Guide
M39547
Package includes:
Screws and
anchors
UWP™
Wall Plate
Thermostat
Literature
M39561
This document contains the following sections:
1) Installation and Wiring
2) Configuration
3) System Operation
4) Troubleshooting
2
Removing the old thermostat
2 Check that your system is off.
Change the temperature on your
old thermostat to be above room
temperature in heat mode or below
it in cool mode. If you don’t hear the
system turn on within 5 minutes,
the power is off. Note: If you have a
digital thermostat that has a blank
display, skip this step
1 Turn power OFF.
To protect yourself and your equipment,
turn off the power at the breaker box
or switch that controls your heating/
cooling system. Note that some
systems may have separate heating
and cooling breakers.
3 Remove the old thermostat’s faceplate.
On most thermostats, you can take off the
faceplate by grasping and gently pulling. Some
thermostats may have screws, buttons, or clasps.
Do not remove any wires from your thermostat
at this time!
75
75
Breaker box
Switch
READ AND SAVE THESE INSTRUCTIONS
Tools you will need
Small flat head scr
ewdriver
Phillips scr
ewdriver
Pencil
Le
vel
M36270
Wire stripper
Needle-nose pliers
Drill and
drill bit
Tools you may need
Installation and Wiring
M39590
OFF
OFF
ON


Produkt Specifikationer

Mærke: Honeywell
Kategori: Termostat
Model: X1N

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell X1N stil et spørgsmål nedenfor, og andre brugere vil svare dig