IPEGA PG-QT04B Manual

IPEGA Ikke kategoriseret PG-QT04B

Læs gratis den danske manual til IPEGA PG-QT04B (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om IPEGA PG-QT04B, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/1
Quest VR眼镜充电底座
产品说明书(PG-QT04B)
产品使用说明
1. 将适配器充电线的TYPE- C公头端插入本产品的TYPE- C母座输入端。
3. LED充电指示灯：1.待机绿色常亮，充电时常亮红色、2.充满电后常亮绿色。
4. VR头戴充电时，随着VR头戴的电池电量逐步上升，充电电流会逐步下降，
直到转灯；充满电指示灯转绿色灯。
5. 按一下产品前端灯光触摸按键，可以切换RGB灯光效果,长按灯光触摸按键
3秒，保存当前灯光模式并熄灯。
注意：
如不能充电请检查磁吸头与充电线有无接触到位
2. 将本产品配置的电池装入VR手柄，然后装上本产品配置的充电电池盖，将安
装完成后的VR手柄对应的接触点与本产品充电底座对应的充电探针位置接触
放好即可为手柄进行充电，对应的左右指示灯红色表示左右手柄充电状态。
左右指示灯显示红色，表示左右手柄充电状态
将本产品附带的磁吸头
TYPE-C公头插入VR头戴
将磁吸头的TYPE -C端与本机的磁吸头线相吸
即可进行充电，对应的中间指示灯显示红色。
中间指示灯显示红色，表示VR眼镜充电状态
适用说明
1. 本产品适用于Quest 3s/Quest 3/Quest 2 VR眼镜及手柄充电。
2. 本产品具备1个TYPE-C 2.0输入口和1个USB2.0输出口。
3. 具备1个VR头戴充电输出口，最大充电电流5V/3A(或9V/2A)左右。
4. 具备2个VR手柄充电输出口。
5. 具有炫彩灯效，并可以触摸切换。
注意：由于控制器电池非原装，VR头戴上显示的控制器电池电量不准确。
请以充电座上的控制器指示灯为准。
注意：本产品带有充电保护（额定30W），触发保护则产品反复重启，拔下
背面usb连接的设备即可。
注意事项：
产品清单
2. 请不要敲击、摔打、刺穿、或试图去分解本产品，以免对产品造成不必要
的损害。
3. 非专业人员勿拆卸本产品,否则不在售后保修服务内。
4. 产品内有电容等电子材料，不可随便丢弃，须集中给有资质的回收机构。
5. 因不可抗拒的因素造成部分产品无法连接操作，我公司不负任何责任，对
此我公司保留最终解释权。
充电底座 x1
电源线 x1 说明书 x1
磁吸转接头 x2 电池 x2 电池盖 x4
1. 输入电压/电流：DC 9-20V/2.0A
2. 手柄充电电流：600mA
3. 充电电池：1.2V/1800mA
VR左手柄充电
接触点
灯光触摸按键
USB输出接口
电源输入接口
VR右手柄充电接触点
VR眼镜充电头
磁吸转接头收纳槽
注意：如手柄无法充电，请
检查电池是否正确安装，确
保电池盖上的触点与电池侧
面的金属面正常接触
充电指示灯
Quest VR Headset Charging Stand
Product Manual（PG-QT04B）
5. Press the light touch button on the front of the product to switch the RGB
lighting effect. Press and hold the light touch button for 3 seconds to save
the current lighting mode and turn off the light.
6. USB A expansion port, can be used to charge other devices.
3. Led charging indicator: 1. Standby green color always on, charging turn to
red. 2. Change to green color while full charged.
4. When charging the VR headset, with the VR headset battery power gradually
increases, the charging current will gradually decrease until the light color
turn. Light indicator turn to green color while full charged.
2. Install the battery configured with this product into the VR controller, then
install the rechargeable battery cover, place the contact point corresponding
to the installed VR controller, in contact with the charging probe position
corresponding to the charging base of this product to charge the controller.
The corresponding left and right indicator turn red to indicate the charging
status of the left and right controllers.
The left and right indicator lights are red,
indicating the left and right controllers in
charging status.
Applicable Instructions
Product Appearance Illustration:
Electrical Parameters:
1. This product is suitable for Quest 3s/Quest3/Quest 2 VR headset and
controller charging.
2. With 1 TYPE-C 2.0 input and 1 USB 2.0 output port.
3. Equipped with 1 VR headset charging output port, max charging current is
5V/3A(or 9V/2A).
4. Equipped with 2 VR controller charging output ports.
5. With colorful lighting effects and can be switched by touch.
Note: since the controller battery is not original, the controller battery level
displayed on the VR headset is inaccurate. Please refer to the controller
indicator light on the charging dock.
Note: This product with charging protection(rated power 30W). If the protection
is triggered, the product will restart repeatedly. Just unplug the device
connected to the USB on the back.
Notes
Product List
1. Please do not put the products in wet or high temperature place.
2. Don’t knock, beat, drub, pierce, or try to decompose this product, avoid
any unnecessary damage to the product.
3. Non-professionals disassemble this product by mistake otherwise it will not
be cover by the after-sales warranty service.
4. The product contains capacitors and other electronic materials, which
cannot be discarded casually, should be collected by qualified recycling
agencies.
5. If some products can not be connected due to irresistible factors, our
company will not be responsible for any consequences. Our company
reserves the final right interpretation.
6. Do not use it to charge other types of rechargeable batteries or controllers.
Charging Station x 1
Type-C Cable x 1 Manual x 1
Magnetic Interface x 2 Battery x 2 Battery Cover x 4
1. Input voltage/current: DC 9-20V/2.0A
2. controller charging current: 600mA
3. Charging battery: 1.2V/1800mA
VR left controller
charging contact
point
Light touch button
USB output port
Power input port
VR right controller
charging contact point
VR headset
charging head
Magnetic connector
storage slot
Note: If the controller
cannot be charged,
please check whether the
battery is installed
correctly, and ensure that
the contacts point on the
battery cover are in
normal contact with the
metal surface on the side
of battery.
Charging
indicator
Product Instructions
1. Insert the TYPE-C male end of the adapter charging cable into the TYPE-C
female input end of this product.
Note:
If not charging please check whether the
magnetic charging connector and the
charging cable are in proper contact.
Insert the attached
magnetic TYPE-C male
connector included with
the product into the VR
headset.
Attach the TYPE-C port of the magnetic
connector to the magnetic head cable of the
device to charge, and the corresponding middle
indicator light turn red.
Middle indicator light turn red, it shows VR
headset in charging status.

Produkt Specifikationer

Mærke: IPEGA
Kategori: Ikke kategoriseret
Model: PG-QT04B

Har du brug for hjælp?

Hvis du har brug for hjælp til IPEGA PG-QT04B stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret IPEGA Manualer

IPEGA

IPEGA PG-P5V002 Manual

13 Oktober 2025
IPEGA

IPEGA PG-P5013 Manual

13 Oktober 2025
IPEGA

IPEGA PG-SW2210 Manual

13 Oktober 2025
IPEGA

IPEGA PG-P5042 Manual

13 Oktober 2025
IPEGA

IPEGA PG-SW2019 Manual

13 Oktober 2025
IPEGA

IPEGA PG-P5S023 Manual

13 Oktober 2025
IPEGA

IPEGA PG-QT04B Manual

13 Oktober 2025
IPEGA

IPEGA PG-P5S019 Manual

13 Oktober 2025
IPEGA

IPEGA PG-SW2186 Manual

13 Oktober 2025
IPEGA

IPEGA PG-QT03A Manual

12 Oktober 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Scotsman

Scotsman Prodigy Plus NH0922 Manual

13 Oktober 2025
Anybus

Anybus EtherMIRROR Manual

13 Oktober 2025
Scotsman

Scotsman Prodigy Plus NS1322 Manual

13 Oktober 2025
Scotsman

Scotsman Prodigy Elite MC0330X Manual

12 Oktober 2025
IStarUSA

IStarUSA TC-RAIL-26 Manual

12 Oktober 2025
Scotsman

Scotsman Prodigy Plus NH0622 Manual

12 Oktober 2025
Scotsman

Scotsman Prodigy Plus NH1322 Manual

12 Oktober 2025
Scotsman

Scotsman Prodigy Elite MC0530X Manual

12 Oktober 2025
Arkon

Arkon TABPB88L22 Manual

12 Oktober 2025
Arkon

Arkon IBMAG179 Manual

12 Oktober 2025