Irox ETS50 Manual

Irox Vejrstation ETS50

Læs gratis den danske manual til Irox ETS50 (2 sider) i kategorien Vejrstation. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Irox ETS50, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

ENG

ETS50

The ETS50 is a replacement and additional sensor to the device EBR505 of iROX.

More probes on compatibilities www.irox.com / Support / sensors list.

BATTERY INSTALLATION FOR REMOTE SENSOR UNIT

1. Remove the battery cover by grabbing its bottom edge (near the two recess location) from

bottom of sensor unit.

2. Insert 2 pieces of AA size batteries according to the “+” and “-” polarity marks shown in the

battery compartment and then close the battery door with the clip on (press down the snap

on both sides slightly).

WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE

1. Insert 3 pieces of AA batteries first to the main unit. The temperature display shows - - - -

while the wave icon will keep blinking for 2 minutes indicate the main unit is in sensor

searching mode.

2. In a second step, insert the 2 pieces of AA batteries into the sensor unit. The red LED on

the front will start flashing at a rate of one time per 2 seconds indicates channel-1 is in

use.

3. While the red LED is flashing, press once the ▲/CH button (located in the battery

compartment) will change the sensor channel setting to 2. Keep toggle on ▲/CH button

can change channel setting up to 3. The LCD is blinking at a frequency to indicate the

channel setting, i.e. continuous blinks 2 times indicate channel-2 is selected.

Note: If user does not press any key for 10 seconds, it will exit the channel setting

mode and transmit the RF signal. The main unit will register the temperature

reading.

For later sensor search and registration:

Start the sending mode on the main (EBR505) unit by pressing the /CH button for 2 ▲

seconds.

On the sensor unit do as described in step 2 and 3 above.

For more details, read the manual of the display device!

Produkt Specifikationer

Mærke:	Irox
Kategori:	Vejrstation
Model:	ETS50
Type:	Fritstående
Bredde:	104 mm
Dybde:	54 mm
Højde:	25 mm
Forbindelsesteknologi:	Trådløs
LED-indikatorer:	Ja
Arbejdsområde:	30 m
Formål:	Indendørs/udendørs
Sensortype:	Temperatur og luftfugtighedssensor
Antal kanaler:	3 kanaler
Temperatur, måleenheder:	F, °C
Temperatur måleinterval:	- °C