JETI AddCAP 1640 Manual

JETI Radiostyret legetøj AddCAP 1640

Læs gratis den danske manual til JETI AddCAP 1640 (2 sider) i kategorien Radiostyret legetøj. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4 anmeldelser. Har du et spørgsmål om JETI AddCAP 1640, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

A CAP 820DD

A CAP 1640 DD

By JETI model s.r.o 12. 6. 2013

AddCAP 820, AddCAP 1640

1. Description

AddCAP 820 and AddCAP 1640 are add-on capacitor units designed to enhance battery power supply for drive

systems using low-impedence electric motors (1-2 pole). They should also be used when the wires from your battery

to your ESC need to be lengthened more than 20cm (8 inches). In cases where the wires are longer, use one AddCAP

820 or AddCAP 1640 for each 20cm (8 inch) section. Another advantage of adding an additional capacitor is to

reduce possible interference which may be caused by current moving through your power wires. Recommended for

use with 2.5-6 mm2 (14AWG – 10AWG) wires.

2. Parameters

AddCAP 820 AddCAP 1640

Maximum voltage: 59V 59V

Dimensions: 60x19x18 mm 60x35x24 mm

Weight: 13g 27g

3. Installation procedure

1. Prepare the cables and tin (pre-solder) their ends.

2. Put the large piece of heat shrink tubing over the power wires. It will be slipped over the capacitor once

the power wires have been installed. Be sure to keep this tubing far enough away from the unit while you

are working so that it does not get shrunk when soldering the power cables.

3. Put the small shrink tubing over the cables at the wire support tabs (match the colors, see picture 1),

align the ends of the cables on the prepared solder pads as shown (cable ends should be as close to each

other as possible), then shrink the cables to the support tabs on the PCB using a heat gun.

4. Carefully solder the cables (see picture 2).

5. Put the large piece of heat shrink tubing over the capacitor. Shrink it with a heat gun and apply the

sticker (see picture 3).

Fig. 1 Fig. 2

Fig. 3

-2-

Produkt Specifikationer

Mærke:	JETI
Kategori:	Radiostyret legetøj
Model:	AddCAP 1640

Har du brug for hjælp?

Hvis du har brug for hjælp til JETI AddCAP 1640 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Radiostyret legetøj JETI Manualer

JETI TD1609S Manual

21 August 2024

JETI JDEX-RR7 Manual

21 August 2024

JETI JEX-MF2G-800 Manual

21 August 2024

JETI Central Box 220 Manual

21 August 2024

JETI MEZON 75 opto (RPM) Manual

21 August 2024

JETI Central Box 210 Manual

21 August 2024

JETI Duplex Rsat 2 EX Manual

21 August 2024

JETI JM-090-L Manual

20 August 2024

JETI TD0905L Manual

20 August 2024

JETI AddCAP 1640 Manual

20 August 2024

Radiostyret legetøj Manualer

Nyeste Radiostyret legetøj Manualer

ARRMA Granite Grom Mega 380 Manual

3 August 2025

Carson Linde H 40 D Manual

3 August 2025

Spektrum NX20 Manual

1 August 2025

Spektrum Avian 2813-1750Kv Manual

1 August 2025

Spektrum S120 Manual

1 August 2025

Spektrum S6295 Manual

1 August 2025

Spektrum Avian 60 Manual

1 August 2025

Spektrum S1200 Manual

1 August 2025

Spektrum iX20SE Manual

1 August 2025

Spektrum AR20410T Manual

1 August 2025