Jindara Mallee Manual

Jindara Varmeapparat Mallee

Læs gratis den danske manual til Jindara Mallee (4 sider) i kategorien Varmeapparat. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Jindara Mallee, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Mallee SRS2 Freestanding

• Smoke e g the m m the box n e r is n may be caused bynterin roo fro fire whe th doo ope

• Insufficient n h of e (le gt flu Flue to be m m m e4500m minimu fro und rn ate h e of he er to e e of l)bas at und rsid cow

– I e he ht of e.ncreas ig flu

• F e ughtlu Downdra

– n t de er or in e e h t of f e.Co sul al cr as eigh lu

• e e d up in ueCr osot Buil fl

– Remov cow an cl flu pe cl ani stre l d ean e as r e ng in uctio ecns. Ch k e n nt of d.moistur co te woo

• Exc e h bu d upessiv as il

S e s l ve e u s of h e how u n the h er. h s l e u very . e the d wh h is stom wood wil gi larg amo nt as despit yo ru eat Ot er wil giv yo little Us woo ic mo

con ni fove ent r u as ng as it is dry. r a d of e u l get to k w when to y ur . s e mm of ashyo lo Afte perio tim yo wil no empt yo unit Alway leav 12

in the m of r he er. k l e u exce ve h. Try not to burn it.botto you at Bar wil giv yo ssi as

If u e bu g d t s u ch , u y f d that after n g the h r y for 8 hours at m burn rate, theyo ar rnin woo tha give yo arcoal yo ma in ru nin eate sa maximu

charcoa ildl bu s up ely. ern t burn l uce this ch l k to a f e . If u e not y to u n forexcessiv Ov igh wil red arcoa bac in ash yo ar read sh tdow

ov t burn en u n t fuel e e, d the ve h only one ernigh wh yo ex th stov loa sto wit piece of d and y it s the f x on p of thewoo la acros irebo to

charcoal Op th ai contro wid ope. en e r l e n and u l f d the ch l l burn n h the one e of . R t the p ssyo wil in arcoa wil dow wit piec wood epea roce

unti th as le signi icantl ducel e h vel is f y re d.

Tro blesu hooting (Continued)

1. Subject to clauses 2 & 3 of this warranty, A.F. Gason Pty Ltd ACN 004 667 556 (Gason) warrants the following components of its heaters against defects in workmanship and/or materials for the

following periods from the date of purchase:

(a) the firebox for ten years;

(b) the paint finish for a period of twelve months if the purchaser has followed the instructions provided by Gason in this Operation and Installation Instructions manual; and

(c) all other components for twelve months except the glass, fire brick lining or baffle plate if, in the opinion of Gason, these items have been damaged by impact.

2. This extended warranty does not apply:

(a) if the heater is purchased from a person who has not been authorised by Gason to sell its products;

(b) if, in the opinion of Gason, the heater or any component has been subjected to abuse, misuse, alteration, modification or has not been installed, operated or maintained in accordance with the

instructions provided by Gason; or

3. If you believe that the heater you purchased contains a manufacturing defect and you wish to make a claim under this warranty, please contact an authorised Gason service centre to arrange for an

assessment.

4. If, after assessing the heater, Gason determines that the heater contains a manufacturing fault, Gason may at its discretion:

(a) replace the heater;

(b) repair or replace specific components of the heater; or

5. Parts replaced under this warranty are warranted for the balance of their original warranty period.

6. If, at the discretion of Gason, the heater or any part needs to be replaced, serviced or repaired at an authorised Gason service centre, then the person claiming under this warranty must pay all costs

associated with:

(a) returning the heater; and

(b) the delivery or collection of any new or repaired heater.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably

foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Any benefits you receive under these warranties are in addition to other rights and remedies that you may have as a consumer under a law in relation to the heater to which these warranties relate.

These warranties are given by:

A.F. Gason Pty Ltd

Blake Street

Ararat VIC 3377

Please contact us if you have any queries on:

Phone: 03 9763 3200

or email us via the “Contact Us” section of our website: www.gason.com.au.

WARRANTY

AF Gason Pty. Ltd. reserves the right to modify or alter specifications, material, etc. in the interest of product improvement.

Mallee SRS 2 Freestanding 8

236021Rev *

Operation & Installation Instructions

Please keep these instructions for future reference.

Troubleshooting

WARNING

NEVER OPER TE THE HE A ATER WITH THE DOOR OOSE AND L NOT T. GAIR TIGH OVERFIRIN

COULD RESU LT TIN DETRIMEN AL WEAR AND TEAR ON THE FIREB OX.

• FanNoisy

Turn the power off and remove the three pin plug from the power point. emove the four screws that hold the front fan access R panel.

Remove the panel. Disconnect the wiring loom via the plastic joine r. re eUnscrew the two nuts which hold the fan in position and move th

fan. Clean any dust with dry paint brush and vacuum the fan blades. Clean around the moto a r. reeAfter completion place two or th

drops of sewing machine oil on the shafts at the bearings. eplace the fan in reverse to the removal R .

• Fan g not workin

Check the power connection with another appliance. If the power point is O.K. F te eassume the an or the Switch is defective. Isola th

power as above. Check that the terminals on the loom and the switch are firmly connected. If the fan then fails to function, move th re e

fan and switch by firstly removing the knob off the fan switch by r. ll hpulling it away from the heate Undo the holding nut and pu the switc

out. Disconnect the wiring from the power lead and remove the fan and switch. Convey the same to the authorised Jindara Dealer from

whom you purchased your unit for service. eplace in the reverse orde R r.

• ing Air Co rolnt Jamm

Remove air control cover plate by removing the four screws which hold it onto the face of the heate r. iThere are two bolts hold ng the air slid e

in place. Undo them and remove the air slide. Wipe any ash or dust that may have accumulated on the back of the air slide or on ofthe face

the heate r. r, aIf any burrs have developed on the back of the air slide or on the face of the heate rub them off with fine wet nd dry san d

paper till you have smooth surface and edges. a Replace the air slide and ma ke wh usure the washers and spacers are on the bolts en yo

screw the bolts back into the face of the heate r. Do not apply any type of lubricant tothe air slide whatsoever as this will attract ddust an

make .the slide stick

• nNo Overnight Bur

Remove the air slide as per air control jamming and check that the air slide is hard against the face of the heate r. l eIf it is oose, tighten up th

bolts holding the air slide to the face of the heate r. .Do not overtighten

Check that the door rope has an even indentation from the sealing strip, which is on the face of the firebox. If it is uneven nd a it appears as

though air could leak through the seal, adjust the thickness of the door rope to suit. Stretch the rope to ma ke re isit thinner whe the indentation

the heaviest and bunch up the excess where the indentation is smalle r.

Check the four bolts that hold the glass retainer in position. If loose tighten. Do not overtighten .

The door may become loose through the door seal shrinkin g. To r, tighten the doo open the door and look at the inside of the do catch. Undor o

the nut which is holding the latch plate. Remove the latch plate. Remove one thick r. Rwasher and the star washe efit the latch plate. The latc h

plate is concave to provide a lead in edge so that there is smooth connection between the door latch and the catch. Ma ke t ofsure hat the face

the latch that is curved outward is facing towards the doo r.

Replace the nut. When closing the door you should now feel firm resistance when the latch comes into contact with the catch .

Overfiring

WARNING

R .ead and follow these instructions carefully before installing and using this appliance

SAVE THESE INSTRUCTION S

Pa eint curing and car

WARNING

• A dflue fire with resulting damage may occur if this appliance is not installed, operated an

maintained as per this booklet .

• .Never place combustible material such as wood, paper or furniture near the appliance

• eThis appliance is designed to burn dry wood. Do not burn rubbish, driftwood, flammabl

liquids or any substance containing salts or corrosives .

• k tThis appliance must not be installed and operated in an area where erosene, petrol, pain

thinner or other flammable liquid is used or stored .

• F toThe flue system must be inspected and cleaned annually or sooner if required. ailure

do so could result in an excessive build up of creosote which may result in flue fir a e

which may damage the flue or cause damage to your home .

• ofThe surface of the appliance becomes hot during operation. Do not touch the surface

this appliance. eep children away from the appliance during operation. Do not allo K w

anyone to operate this appliance who is not familiar with the instructions in this booklet .

WARNING

Your heater is coated with the best available heat resistant paint. Even though the paint ha s

been ba ed after application, it may require further temperature curin It ma k g. y, eif you overfir

the heater on its first fire, discolou r. mFor your first two or three firings, never exceed mediu

air setting and always have the fan on when above low burn. Do not wipe the heater while th e

paint is curin After the paint has cured the only maintenance required to maintain th g. e

heaters finish is to wipe it with soft cloth. Do not use any commercial cleaners or solvent a s

on the paint finish.

We eare proud of the presentation of our products. If at any time you need to freshen up th

paint finish, your local dealer has touch up paint available for purchase.

If you have any enquires, please contact the dealer from whom you purchased your heater :

PLEASE COMPLET E:

Dealer Nam e

Dealer Addres s

Phone

Please attach your original purchase doc ets to this booklet for future reference k .

Safety Wa srning

Mallee SRS 2 Freestanding 2 Mallee SRS 2 Freestanding 7

Produkt Specifikationer

Mærke:	Jindara
Kategori:	Varmeapparat
Model:	Mallee

Har du brug for hjælp?

Hvis du har brug for hjælp til Jindara Mallee stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Varmeapparat Jindara Manualer

Jindara Kimberley Mk2 Manual

21 August 2024

Jindara Hamersley MK2 Freestanding Manual

20 August 2024

Jindara Tilga Manual

19 August 2024

Jindara Hamersley Mk2 Manual

18 August 2024

Jindara Riverina Manual

16 August 2024

Jindara Mallee Manual

14 August 2024

Jindara Spectre Manual

14 August 2024

Jindara Grange Manual

13 August 2024

Jindara Gawler Manual

11 August 2024

Jindara Sturt Manual

10 August 2024

Varmeapparat Manualer

Nyeste Varmeapparat Manualer

BEKO RHO8323BT Manual

14 Juni 2025

DeWalt DXAM-2260 Manual

14 Juni 2025

AlorAir Zeus 900 Manual

14 Juni 2025

XPower B-55 Manual

14 Juni 2025

XPower B-2 Manual

14 Juni 2025

XPower M-27 Manual

14 Juni 2025

B-Air Vent VP-34 Manual

14 Juni 2025

XPower P-80 Manual

14 Juni 2025

DeLonghi JRE0812 Manual

14 Juni 2025

Aura CF15120B Manual

14 Juni 2025