JL Audio M10IB5 Manual

JL Audio Subwoofer M10IB5

Læs gratis den danske manual til JL Audio M10IB5 (4 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om JL Audio M10IB5, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Thank you for choosing a JL Audio Marine Subwoofer.

With proper installation, your new speaker

will deliver years of listening pleasure.

We strongly recommend that you have your subwoofer installed

by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and experience to

properly install this product. If you prefer to perform

your own installation, please read this instruction manual

completely before beginning the process.

owner’s manual

Marine Subwoofer

M10IB5 / M10W5

2 JL AUDIO M10IB5/M10W5

INSTALLATION PROCEDURE

The diagram above shows the typical

installation procedure into a fiberglass panel using

the supplied hardware (Classic Grille Model shown.

Installation is the same for Sport Grille Models).

Always follow proper safety procedures when

working on a vessel. Use eye-protection at all times

and a dust mask and gloves when cutting.

1) Choose a flat mounting surface that has

sufficient

depth and air space behind it to accept

the subwoofer.

2) Cut a 8.875-inch (225 mm) diameter hole.

3) Run the speaker cable to the mounting location.

4) Place the woofer in the hole and mark the screw

hole locations using a sharp, pointed tool.

5) Remove the woofer and drill a pilot hole

(see chart on next page) in each of the screw

locations. It is also advisable to use a hand-driven

countersink tool on each hole to further inhibit

gel-coat cracking of fiberglass panels.

6) Connect the speaker wires and place the woofer,

with its grille in place, into the opening (for Sport

Grille models, pay attention to where the logo

badge will added.

7) While holding the speaker firmly in its mounting

location, evenly snug the mounting screws in a

criss-cross pattern, then hand tighten in a criss-

cross pattern.

Non-standard installations may require different

hardware. Always use marine-grade, stainless-steel

fasteners to ensure a secure, reliable installation.

We recommend the use of this speaker in a bi-amplified system using high-quality satellite speakers and amplifiers.

We do not recommend the use of this subwoofer with a passive crossover (coil), as this type of device will adversely

affect performance.

A l l s p e c i f i c a t i o n s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e .

PHYSICAL SPECIFICATIONS

INCLUDED PARTS

• One Polymer Subwoofer Grille

• Six #10 x 1 5/8-inch (41 mm) pan-head

stainless-steel screws

• Six #10 stainless-steel washers

• Logo Badges (Sport-Grille Models Only)

One Pair Black (White & Titanium/Black Models)

One Pair Red (White & Titanium/Black Models)

One Pair White (White Models Only)

One Pair Titanium (Titanium/Black Models Only)

Subwoofer Physical Specifications

Nominal Diameter: 10 in. / 250 mm

Overall Diameter (A): 10.75 in. / 273 mm

Mounting Hole Diameter (B): 8.875 in. / 225 mm

Bolt Hole Circle (C): 9.706 in. / 247 mm

Motor Overmold Outer Diameter (D): 6.11 in. / 155 mm

Mounting Depth (E): 5.93 in. / 151 mm

Net Weight: 11.4 lbs. / 5.17 Kg

Driver Displacement: 0.064 ft / 1.81 litres

Subwoofer Parameters M10IB5 M10W5

Free Air Resonance (Fs): 42.20 Hz 31.55 Hz

Electrical “Q” (Qes): 0.819 0.484

Mechanical “Q” (Qms): 10.355 8.946

Total Speaker “Q” (Qts): 0.759 0.460

Equivalent Compliance (Vas): 1.16 ft3 / 32.85 litres 1.58 ft3 / 44.75 litres

One-way, Linear Excursion (Xmax)*: 0.52 in. / 13.2 mm 0.52 in. / 13.2 mm

Efficiency (1W/1m)**: 86.8 dB SPL 86.7 dB SPL

Effective Piston Area (Sd): 50.11 in² / 0.0323 m² 50.11 in² / 0.0323 m²

DC Resistance (Re): 4.167 ohm 3.602 ohm

Nominal Impedance: 4 ohm 4 ohm

Infinite Baffle Use: Yes No

Enclosure Use: Yes (Sealed Only) Yes (Sealed and Ported)

Power Handling (continuous): 250W 250W

* Xmax specifications are derived via one-way voice coil overhang method with no correction factors applied.

** Efficiency (1W/1m) is not an accurate indicator of a subwoofer’s output capability and should not be used

as a comparison to other subwoofers to determine which one is “louder” !

Produkt Specifikationer

Mærke:	JL Audio
Kategori:	Subwoofer
Model:	M10IB5

Har du brug for hjælp?

Hvis du har brug for hjælp til JL Audio M10IB5 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Subwoofer JL Audio Manualer

JL Audio Fathom CTS-113-MD900-13TW5H Manual

7 September 2025

JL Audio Fathom CTS-113-TT525-13TW5H Manual

7 September 2025

JL Audio Stealthbox SB-IN-G35CPE/10W1v2 Manual

27 Juli 2025

JL Audio 8W1v2-4 Manual

27 Juli 2025

JL Audio Stealthbox SB-H-PIO7/10TW3 Manual

27 Juli 2025

JL Audio Stealthbox SB-GM-SLVCRW/10TW3 Manual

30 December 2025

JL Audio Stealthbox SB-F-MUCUPE2/13W3v3 Manual

30 December 2025

JL Audio Stealthbox SB-F-150-SPRCRW/13TW5v2/GA Manual

30 December 2025

JL Audio Stealthbox SB-N-370/10W3v3 Manual

8 December 2024

JL Audio Stealthbox SB-GM-CTRIP/10TW3/UF Manual

8 December 2024

Subwoofer Manualer

Nyeste Subwoofer Manualer

Audison Prima APBMW S8-2.2 Manual

28 September 2025

Audison Prima APBMW S8-4.2 Manual

28 September 2025

Boston Acoustics BT1100 Manual

25 September 2025

Boston Acoustics Classic CPS 10Wi Manual

25 September 2025

Boston Acoustics Classic CPS 8Wi Manual

24 September 2025

Boston Acoustics Classic CPS 12Wi Manual

24 September 2025

Ground Zero GZRW 250-D2 FLAT Manual

24 September 2025

Ground Zero GZNW 38NEO-SPL Manual

24 September 2025

Ground Zero GZIW 200 Manual

24 September 2025

Ground Zero GZIW 250 Manual

24 September 2025