JUNG AFTR231PL Manual

JUNG Ikke kategoriseret AFTR231PL

Læs gratis den danske manual til JUNG AFTR231PL (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 15 anmeldelser. Har du et spørgsmål om JUNG AFTR231PL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Temperature Management Floor heating controller

Ref.-no.: ..FTR 231 ..

Operating Instructions

Floor heating controller

1. Area of application

Used in domestic electrical installations to regulate electrical floor heating

systems and temperature control systems.

2. Function

The floor heating controller consists of two parts:

• Control unit for setting the required floor temperature

• Remote sensor in the floor for monitoring the set temperature

Control unit:

Using the setting knob, set the required temperature for your floor. The

numbers  – 6 on the knob correspond to a temperature range of 10 – 50

°C.

Note the setting instructions from the manufacturer of your floor heating

system.

If the temperature in the floor falls below the temperature you have set,

the control unit requests heat; this state is displayed by the red LED

above the setting knob. You can therefore see if your heating is using

energy.

A range restriction can also be carried out in the setting knob.

The operating state of your floor heating is switched on or off with the

mains switch 0 – I.

You also have the option of programming a temperature reduction via an

external time switch e.g. during the night.

If you have installed this type of time switch, the temperature reduction is

indicated by the green LED above the setting knob. The temperature

reduction is approx. 5 °C.

Example: The temperature set by you on the control unit is 34 °C

(number on dial = 4). This means that the temperature in the floor e.g.

during the night can drop down to 29 °C without your heating switching

itself on.

Stand: Apr-08 240 9090 1

Temperature Management Floor heating controller

Ref.-no.: ..FTR 231 ..

Sensor:

The sensor is to be installed in the floor. It monitors the floor temperature

set on the control unit and issues commands to switch the floor heating

on and off.

Safety instructions

Electrical equipment may only be installed and fitted by qualified

electricians while observing the current accident prevention

regulations.

Non-observance of the safety warnings or installation instructions

may damage the device, cause fire or other hazards.

In the event of a fault, mains potential can be present at the sensor.

L The switch 0 – I on the control unit causes a singlepole disconnection

of the device from the mains and interrupts the circuit to the heating

resistor in the floor.

L When working on the load circuit, the mains voltage must be

disconnected in principle.

L When the sensor is interrupted, the relay contact is closed. If the

sensor experiences a short circuit, the relay contact is open.

3. Connection and installation

Control unit

Mount the control unit in a switch box in accordance with

DIN 49 073.

Notice! The device must always be mounted with its supporting

frame on top of the wallpaper!

• Carry out the electrical connection according to the wiring diagram

(Fig. (1)). Solid conductor cross-section: 1 to 2.5 mm2 No PE

conductor required. PE conductor is only used for looping through.

Protection class II can be achieved through appropriate installation

measures.

Abb.1

Produkt Specifikationer

Mærke:	JUNG
Kategori:	Ikke kategoriseret
Model:	AFTR231PL

Har du brug for hjælp?

Hvis du har brug for hjælp til JUNG AFTR231PL stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret JUNG Manualer

3 Juni 2025

31 December 2025

14 December 2024

10 December 2024

10 December 2024

JUNG MACD1193WW Manual

10 December 2024

JUNG WS10D Manual

10 December 2024

JUNG AL1561.07F Manual

10 December 2024

JUNG 1745DSTE Manual

10 December 2024

JUNG MALS1193 Manual

10 December 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

AmpliVox Airvox SW695 Manual

15 Juni 2025

Stiga SBC 635 KD Manual

15 Juni 2025

Cleveland 36CGM300 Manual

15 Juni 2025

Gourmia GTF7970 Manual

15 Juni 2025

Planet Audio P9630B Manual

15 Juni 2025

ORNO OR-DOM-YR-934UD Manual

15 Juni 2025

Lavex 842CD12VST12 Manual

15 Juni 2025

Marshall RCP-PLUS Manual

15 Juni 2025

Hughes & Kettner BassForce XL Manual

15 Juni 2025

Hughes & Kettner Red Box Mk III Manual

15 Juni 2025