JUNG CD1561.07FKO Manual

JUNG Ikke kategoriseret CD1561.07FKO

Læs gratis den danske manual til JUNG CD1561.07FKO (7 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 5 anmeldelser. Har du et spørgsmål om JUNG CD1561.07FKO, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/7
Light Management Radio-control pushbutton and pilot lamp
Ref.-no.: ..1561.07FKO..
Operating Instructions
Radio-control pushbutton and pilot lamp
1. Function
The radio-contol pushbutton permits radio-controlled or manual switching
and dimming of lamps.The starting brightness can be stored in the device
as memory brightness. The pushbutton with radio-control receiver is
plugged onto one of the following inserts:
Universal touch dimmer 1254 UDE
Standard touch dimmer 1225 SDE
Relay insert single-channel 1201 URE
Relay insert two-channel 1202 URE
Tronic switching insert 1254 TSE
LV triac switching insert 1244 NVSE
Touch control unit 1240 STE
Relay insert with potential-free contact 1201-1 URE After reception of a
data telegram from a programmed radio-control detector and
corresponding darkness, the radio-contol pushbutton is switched on for
about 1 minute with the preset memory brightness. The radio-contol
pushbutton can be programmed to identify up to 30 radio channels.
Lightscapes
The radio-contol pushbutton can be included in up to five lightscapes
which are activated with the corresponding radio-control transmitters (e.g.
hand-held transmitter ‘Komfort’) and stored. The desired lightscape key
must be programmed beforehand into the radio-contol pushbutton.
All-ON / All-OFF
The programming of a radio channel (e.g. hand-held transmitter
‘Komfort’) always includes the simultaneous and automatic storage of the
functions of the All-ON or All-OFF key.The All-ON or All- OFF key of a
radio-control transmitter switches the load connected to the switching
actuator on or off.
Light control
In combination with a programmed radio-control presence detector, the
radio-contol pushbutton can be used for lighting control functions. For
more information, refer to the operating instructions of the radio presence
detector.
Stand: Mai-07 325 276 53
Light Management Radio-control pushbutton and pilot lamp
Ref.-no.: ..1561.07FKO..
Important
The present instructions describe the functions of the radio-control
pushbutton without lighting control. More information on light control with
a presence detector is set out in the operating instructions for these
devices.
WARNING!
Caution: The installation and assembly of electrical equipment may
only be performed by a skilled electrician.
2. Fitting
The radio-control pushbutton can only be operated in conjunction with the
inserts listed under ‘Functions’. Connection and fitting are described in
the operating instructions of the insert.
Procedure
1. Install the selected insert (1) in a flush-mounting box (deep model
recommended), the connecting terminals of the insert pointing
downwards.
2. Plug the radio-control pushbutton (2) together with frame (3) onto
the insert while the mains voltage is disconnected.
c
d
e
L The distance from electrical appliances (e.g. microwave oven, hi-fi and
TV sets) must be at least 0.5 m.
L To prevent saturation of the radio receiver (actuator), the radiocontrol
pushbutton must be at least 1 m away from the nearest transmitter.
Learning a Radio Transmitter
During programming of a transmitter, the sensitivity of a radiocontrol
receiver is reduced to a range of approx. 5 m. The distance between the
radio-control pushbutton and the transmitter to be programmed should be
between 0.5 m and 5 m.
Procedure
1. Switch off the load connected to the radio-control pushbutton by a brief
depression (< 0,4 s) of any of the two pushbutton rockers.
2. Depress both rockers of the radio-control pushbutton at the same time
for abt. 4 seconds (fig. B: double-sided operation) to switch over to the
programming mode. The LED blinks for abt. 1 min (Fig. C). The radio
pushbutton is then in the programming mode.
2

Produkt Specifikationer

Mærke: JUNG
Kategori: Ikke kategoriseret
Model: CD1561.07FKO

Har du brug for hjælp?

Hvis du har brug for hjælp til JUNG CD1561.07FKO stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret JUNG Manualer

JUNG

JUNG RCDME2022 Manual

30 Juli 2025
JUNG

JUNG RCD2023 Manual

30 Juli 2025
JUNG

JUNG RCD2021 Manual

30 Juli 2025
JUNG

JUNG RCD2044 Manual

30 Juli 2025
JUNG

JUNG RCD2022 Manual

30 Juli 2025
JUNG

JUNG RCDME2044 Manual

30 Juli 2025
JUNG

JUNG 1711 DE Manual

30 Juli 2025
JUNG

JUNG MA1000AD4 Manual

20 Juli 2025
JUNG

JUNG A1561.07BFFKOANM Manual

20 Juli 2025
JUNG

JUNG SM1608 Manual

19 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Cudy

Cudy IF1008 Manual

24 August 2025
Samsung

Samsung VCA-SAE902 Manual

24 August 2025
Candy

Candy HE520PET 011 Manual

24 August 2025
Netgear

Netgear GS748Tv6 Manual

24 August 2025
Samsung

Samsung RR20N282ZU3 Manual

24 August 2025
Candy

Candy HDP 4149AMBC/1-S Manual

24 August 2025
Deye

Deye SUN-12K-SG01HP3-AU-AM2 Manual

24 August 2025
Candy

Candy HE310HM 011 Manual

24 August 2025
Candy

Candy HWP 610AMBC/1-S Manual

24 August 2025
Candy

Candy H3WS 69TAMCE-S Manual

24 August 2025