Kathrein EXD 154 Manual

Kathrein Skifte EXD 154

Læs gratis den danske manual til Kathrein EXD 154 (8 sider) i kategorien Skifte. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Kathrein EXD 154, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
1 / 8
EXD 154
2050000003
Sat-IF Distribution System (4 x Sat-IF)
Digital Wideband Multi-switch
About This Manual
This document is part of the product.
►Do not install or use the device until you
have read and understood this document.
►Keep this document for reference throug-
hout the service life of the device and pass it
on to any new owner or user.
For the most up-to-date version of this docu-
ment, go to www.kathrein-ds.com.
Features
Universal multi-switch with automatic
operating mode detection. A standard TV or
16 receivers each can be operated in single
cable mode at each connection.
All types of signalling are supported and
automatically detected: 14/18 V 0/22 kHz
(legacy), DiSEqC™ 1.0, single cable stan-
dards according to EN 50494, as well as the
extended command set according to EN
50607 (SCD2 or JESS); PIN codes can also
be used in single cable operation.
Latest IC technology with full band captu-
ring ensures the best signal quality. The
inputs are broadband and can also be
operated with wideband LNBs (e.g. UAS
582). This means that a multi-feed system
can be implemented (for two LNBs, the TV
set must support either DiSEqC™ or the
single-cable standard).
QR code for user instructions
For indoor installation
The integrated AGC (Automatic Gain
Control) ensures that the Sat IF signals
have a constant output level and more
reserve in the distribution.
When all TV sets/receivers are switched
o, the multi-switch no longer consumes
any power. If Kathrein Power Saving is acti-
vated, the LNBs are also switched o.
suitable for DVB -T/T2
Wideband to Quatro mode:
In this case, the two inputs of the wideband
LNB are permanently connected to the four
outputs of the multi-switch. The outputs of
the EXD 154 behave like a Quatro LNB, so
that an additional standard multi-switch
can be connected.
The NCF 18 is a highly ecient, short-
circuit-proof switched-mode power supply
unit
Tip The QR code on the front of the
multi-switch will take you to our
website where you can download
these instructions:
111,6
134
148
159
2050000003
2 4
1 3
V low
V high
H high
Terr.
H low
18V
300mA ma x.
Pow er
Saving
Wideband
Universal
Wideband
Universal
ON
OFF
WB-Quatro
DC
42,5
2 / 8
Transport and Storage
►Use the original packaging for transporting
the device; store it in a dry place.
►Make sure there is no water condensation
build-up.
CAUTION!
Risk of damage to the device if operated in inappropriate ambient conditions!
►The equipment may only be installed in dry indoor areas. Do not install the equip-
ment on or against easily combustible material
►The equipment must be provided with an equipotential bonding wire (Cu, at least
4 mm2)
►The safety regulations set out in the current EN 60728-11 and EN 62368-1 standards
must be complied with
►Fasteners for concrete substrates and masonry: 4 suitable plugs and associated
screws with half-round or cylindrical head, outer thread diameter 4.5 - 5 mm, head
diameter ≥ 9 mm and a screw length ≥ 30 mm
For other types of wall, use the appropriate screws or screw-dowel systems, which
oer the same or better fastening
►Connectors: RF connectors 75 Ω (F series) compliant with EN 61169-24
►Unused subscriber ports should be closed o using 75 Ω resistors (e.g. EMK 03)
►To meet EMC requirements, the only power supply unit allower to be used is the
NCF 18
Risk of damage to property!
If the diameter of the inner cable conductor exceeds 1.2 mm or if there is a burr, the
device sockets may be damaged beyond repair.
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Mounting Instructions
Intended use
The equipment described is designed solely for the installation of satellite receiver systems.
Any other use or non-observance of these instructions will result in the loss of the warranty and
guarantee.
Scope of Delivery
●EXD 154
●Instructions for use for EXD 154
●NCF 18

Produkt Specifikationer

Mærke: Kathrein
Kategori: Skifte
Model: EXD 154

Har du brug for hjælp?

Hvis du har brug for hjælp til Kathrein EXD 154 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Skifte Kathrein Manualer

Kathrein

Kathrein EXR 2998 Manual

5 December 2024
Kathrein

Kathrein EXR 2908 Manual

4 August 2024
Kathrein

Kathrein EXD 2532 Manual

3 August 2024
Kathrein

Kathrein UWS 24 Manual

1 August 2024
Kathrein

Kathrein EXD 154 Manual

29 Juli 2024
Kathrein

Kathrein EBX 2920 Manual

19 Juli 2024
Kathrein

Kathrein EXI 3508 Manual

1 September 2023
Kathrein

Kathrein EXD 258 Twin Manual

16 Februar 2023
Kathrein

Kathrein VWS 2900 Manual

15 Januar 2023

Skifte Manualer

Nyeste Skifte Manualer

Lancom

Lancom GS-2412 Manual

4 April 2025
Lancom

Lancom GS-2412P Manual

4 April 2025
Lancom

Lancom GS-2426 Manual

4 April 2025
Hager

Hager ARF970D Manual

3 April 2025
Hager

Hager ARF920D Manual

3 April 2025
Roline

Roline 14.01.3579 Manual

2 April 2025
Fantini Cosmi

Fantini Cosmi B12BN Manual

1 April 2025
Fantini Cosmi

Fantini Cosmi B12DN Manual

1 April 2025
Fantini Cosmi

Fantini Cosmi B12GN Manual

1 April 2025
Fantini Cosmi

Fantini Cosmi B12HN Manual

1 April 2025