Korg AW-LT100B Manual

Korg Ikke kategoriseret AW-LT100B

Læs gratis den danske manual til Korg AW-LT100B (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Korg AW-LT100B, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
- 1 -
Precautions
Location
Using the unit in the following locations can result in a malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
• Close to magnetic elds
Power supply
Be sure to turn o the power when the unit is not in use. Remove the battery in
order to prevent it from leaking when the unit is not in use for extended periods.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.
Handling
To avoid breakage, do not apply excessive force to the switches or controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid clean-
ers such as benzene or thinner, or cleaning compounds or ammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets into
the equipment, it could cause a breakdown, re, or electrical shock. Be careful
not to let metal objects get into the equipment.
THE FCC REGULATION WARNING (for USA)
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If items such as cables are included with this equipment, you must use those
included items.
Unauthorized changes or modication to this system can void the user’s au-
thority to operate this equipment.
Notice regarding disposal (EU only)
If this symbol is shown on the product, manual, battery, or package,
you must dispose of it in the correct manner to avoid harm to human
health or damage to the environment. Contact your local administra-
tive body for details on the correct disposal method. If the battery con-
tains heavy metals in excess of the regulated amount, a chemical sym-
bol is displayed below the symbol on the battery or battery package.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAN ICES-3 B / NMB-3 B.
IMPORTANT NOTICE TO CONSUMERS
This product has been manufactured according to strict specications and
voltage requirements that are applicable in the country in which it is intend-
ed that this product should be used. If you have purchased this product via
the internet, through mail order, and/or via a telephone sale, you must verify
that this product is intended to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for which it is
intended could be dangerous and could invalidate the manufacturer’s or dis-
tributor’s warranty.
Please also retain your receipt as proof of purchase otherwise your product
may be disqualied from the manufacturer’s or distributor’s warranty.
* All product names and company names are the trademarks or registered
trademarks of their respective owners.
アフターサービス
修理または商品のお取り扱いについてのご質問、ご相談は、お客
様相談窓口へお問い合わせください。
お客様相談窓口　
PHS等一部の電話ではご利用できません。固定電話または携
帯電話からおかけください。
受付時間　月曜～金曜　10:00 ～ 17:00　（祝祭日、窓口休業
日を除く）
●サービス・センター：
　〒168-0073　東京都杉並区下高井戸1-18-16　2F
■ お願い
1. 保証書に販売年月日等の記入がない場合は無効となります。
記入できないときは、お買い上げ年月日を証明できる領収書と一
緒に保管してください。
2. 保証書は再発行致しませんので、紛失しないように大切に保
管してください。
コルグ
AW-LT100G
AW-LT100B 保証書
本保証書は、保証規定により無償修理をお約束するものです。
お買い上げ日 年　　　　月　　　　日
販売店名
Published 017 5/2 Printed in etnamVi
Thank you for purchasing the Korg AW-LT100G/AW-LT100B Clip-
on Tuner. To help you get the most out of your new instrument,
please read this manual carefully.
Merci d’avoir choisi la Clip-on Tuner AW-LT100G/AW-LT100B de
Korg. An de pouvoir exploiter au mieux toutes les possibilités
oertes par l’instrument, veuillez lire attentivement ce manuel.
Vielen Dank, dass Sie sich für einen AW-LT100G/AW-LT100B Clip-
on Tuner von Korg entschieden haben. Bitte lesen Sie sich diese
Anleitung vollstädig durch, um bei der Bedienung alles richtig zu
machen.
Gracias por comprar el afinador para enchufar AW-LT100G/
AW-LT100B Clip-on Tuner de Korg. Por favor, lea este manual
atentamente y guárdelo para futuras consultas.
このたびは、コルグClip-on Tuner AW-LT100G/AW-LT100B
をお買い上げいただきまして、まことにありがとうございます。
本製品を末永くご愛用いただくためにも、取扱説明書をよくお読
みになって、正しい方法でご使用ください。
Owner’s Manual (¬p.2)
Manuel d’utilisation (¬p.5)
Bedienungsanleitung (¬s.6)
Manual de usuario ( )¬p.7
取扱説明書 (¬p.8)
- 2 -
Parts of the AW-LT100G/AW-LT100B
Battery compartment
(Rear)
Battery indicator Meter
Note name indicator
Reference pitch indicator
Right shuttle switchLeft shuttle switch
Installing the battery
When the battery becomes depleted, a
battery indicator ( ) will appear on the
display. Immediately replace the battery with
a new one.
1. Open the battery compartment cover on the
rear of the tuner in the direction of the arrow.
2. Insert the battery, making sure to observe the
correct polarity, and then close the cover.
Attaching to the instrument and range of motion
The AW-LT100G/AW-LT100B tunes by picking up the vibrations of the in-
strument. Therefore, attach the AW-LT100G/AW-LT100B to the headstock
of your instrument in order to tune it. Additionally, the AW-LT100G/AW-
LT100B can be freely moved so that the display is easy to read.
The AW-LT100G/AW-LT100B may be damaged if you apply excessive
force within its range of motion, or attempt to move it beyond its in-
tended range of motion.
20°
100°
20°
340°
180°
Please carefully attach the AW-LT100G/AW-LT100B to your instrument.
Leaving the AW-LT100G/AW-LT100B attached for a long time may
damage or mark the instrument's surface.
Depending on various factors such as age-related change or the sur-
face nish, there is a possibility that your instrument may be damaged
by attaching this product.
Tuning
Tuning procedure
1. Turn the upward. Each time you turn the shuttle left shuttle switch
switch, the AW-LT100G/AW-LT100B will be turned on or o.
If the power is left on for approximately 3 minutes without any user
input, it will turn o automatically (Auto power-o function).
2. If necessary, change the reference pitch (calibration) and meter mode.
3. Play a single note on your instrument.
The note name closest to the detected pitch appears in the note name
indicator. Check that the correct note name appears in the display, and
then tune your instrument while watching the meter.
The tuning indications dier depending on the selected meter mode
setting.
Even if the pitch is within the range of detection, it may not be possible
to detect the pitch of an instrumental sound that contains large num-
bers of overtones or a sound that has a rapid decay.
The meter may respond to vibrations it picks up from the environ-
ment.
Reference pitch settings (calibration) (*M)
Each time you turn the upward (or downward), the right shuttle switch
reference pitch (calibration value) increases (or decreases) in 1 Hz steps.
Setting the meter mode (*M)
Each time you turn the downward, the meter left shuttle switch
mode changes.
Regular ¬ Strobe ¬ Half strobe ¬ Regular ...
1: Regular meter
Tune your instrument until the meter segments up to the center (
) light up. If the pitch is sharp, meter segments up to the right of the
center light up. If the pitch is at, meter segments to the left of the
center light up.
The pitch is at. In tune. The pitch is sharp.
2: Strobe meter
Tune your instrument until the meter segments stop running. Since
the strobe meter has higher precision, it allows you to tune with
greater accuracy. The illumination will flow from left to right if the
note is sharp, or from right to left if the note is at.
The pitch is at. In tune. The pitch is sharp.
3: Half-strobe meter
Tune your instrument until the meter segment at the center ( )
lights up. If the pitch is sharp, meter segments to the right of the cen-
ter light up. If the pitch is at, meter segments to the left of the center
light up.
The pitch is at. In tune. The pitch is sharp.
Backlight
After turning the upward to turn on the AW-left shuttle switch
LT100G/AW-LT100B, you can change the brightness of the display by
keeping the left shuttle switch turned upward for approximately 2
seconds.
Auto : The backlight will light brightly when sound is inputted or
when a shuttle switch is operated. When there has been no sound in-
put or shuttle switch operation for approximately three seconds after
the power has been turned on, the backlight will turn oin order to
prevent the battery from being depleted.
Soft : The backlight will light at a lower level of brightness in order to
prevent the battery from being depleted.
Specications
Scale: 12-note equal temperament
Range (sine wave): AW-LT100G B1 (61.74 Hz)–E6 (1319 Hz)
AW-LT100B E0 (20.60 Hz)–C5 (523.3 Hz)
Precision: +/-0.1 cent
Reference pitch: A4 = 436–445 Hz (1 Hz steps)
Dimensions (W x D x H):
60 mm x 60 mm x 55 mm / 2.36’’ x 2.36’’ x 2.17’’
Weight: 32 g/1.13 oz. (including battery)
Power supply: One AAA Battery
Battery life: approximately 100 hours
(backlight:Soft, tuner continuously operating, A4
input, when using alkaline battery)
Included items: Owner’s manual, One AAA battery
*M Settings are remembered even when the power is o.
• Specications and appearance are subject to change without no-
tice for improvement.

Produkt Specifikationer

Mærke: Korg
Kategori: Ikke kategoriseret
Model: AW-LT100B

Har du brug for hjælp?

Hvis du har brug for hjælp til Korg AW-LT100B stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Korg Manualer

Korg

Korg ST1K Manual

10 Januar 2025
Korg

Korg Pitchstrap Manual

18 December 2024
Korg

Korg STB1 Manual

11 December 2024
Korg

Korg Sample Builder Manual

11 December 2024
Korg

Korg ST-SV1-BK Manual

11 December 2024
Korg

Korg PC-400 Manual

5 September 2024
Korg

Korg USB Boot Utility Manual

28 August 2024
Korg

Korg SY-1D Manual

28 August 2024
Korg

Korg Magnetune MG1 Manual

18 August 2024
Korg

Korg AW-LT100B Manual

14 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vulcan

Vulcan 1048C Manual

16 Juni 2025
Playtive

Playtive IAN 91495 Manual

16 Juni 2025
Playtive

Playtive IAN 270612 Manual

16 Juni 2025
Playtive

Playtive IAN 315026 Manual

16 Juni 2025
Playtive

Playtive IAN 115585 Manual

16 Juni 2025
Playtive

Playtive 10464 Manual

16 Juni 2025
Playtive

Playtive HG03821 Manual

16 Juni 2025
Martin

Martin VC-Strip Manual

16 Juni 2025
Playtive

Playtive HG06316 Manual

16 Juni 2025
Playtive

Playtive HG05102 Manual

16 Juni 2025