Leisure VHL1 Manual

Leisure Køkkenvask VHL1

Læs gratis den danske manual til Leisure VHL1 (4 sider) i kategorien Køkkenvask. Denne vejledning er vurderet som hjælpsom af 50 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 25.5 anmeldelser. Har du et spørgsmål om Leisure VHL1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

1970-02

2. Fitthexingclipstothe

sink using the screws 

provided,asshownin

g. 2 and hinge them  

back away from   the

sinkedge.

3. Atthispointtrythesink

in the cut-out, some   

localised enlargement 

of the hole may be    

necessaryaroundthe

clips.

4. Fit the tap to the   

sink.

5. Fit the wastes to the sink following the       instructions

packedwiththem.

6. Fitthefoamsealtotheedgeofthesink.Peeloffthepaper

backingstripandstickthesealtotherecessinthesink

asshowning.3.Ensurethataneatbuttjointisachieved

wheretheendsofthesealmeet.

FITTINGTHESINK

1. Positionthesinkinthecut

out.

2. Tensionthexingclipsas

showning.4.

 Ensurethatthefoamseal

is carefully  compressed

butdonotovertightenthe

clips.

3. Completetheplumbingof

thehotandcoldsupplyto

thetap.

ALTERNATIVEMETHODOFSEALING

1. Applysiliconesealant (notsupplied)totheundersideof

thesinkrim,asshowning.5.

2. Removesurplussealantfromaroundthesinkusing dampa 

cloth.

NOTE: During installation care should be taken to ensure

the sinkisprotectedfromscuffsandscratches.Strainingand

overtighteningofallplumbingxturesconnectedtothesink

shouldbeavoided.Installersshouldcarefullycheckthatthe

moulding andthe edgesof the sinkare deadlevel so that

waterwillow thedrainer.off

PLEASEREADTHOROUGHLYBEFOREATTEMPTINGTO

INSTALLSINK.

PREPARINGTHEWORKTOP

1. Itisrecommendedthattheinsetsinkisttedtotheworktop

beforebeingpermanentlyxedtothecabinet.

2. Placethesinkupsidedownonworktop.Positionthesink

relativetotheworktopasrequired,ensuringthatthecabinet

frameworkwillbeclearofallpartsofthesink.

 Withasharpsoftpencildrawroundsinkasaccuratelyas

possible.Seeg.1.

3. Remove the sink and draw another line 10mm inside        

theout-lineofthesinktop.Thisisthecuttinglineforthe

aperture.

4. Drillaslarge holea aspossibleinsidethecuttingline.Using

apadsaw,jigsaworsimilar,cutouttheaperture.Atthis

pointwewouldrecommendthattheworktopapertureis

sealed. dothispaintoverwithap.v.a.adhesive,paint,To

varnishorsmearwithsiliconesealant.

PREPARINGTHESINK

1. Ifatapholeisrequired,buthasnotbeensuppliedinthe

sink,proceedasfollows.

 Decidewhetherthebowlistobeontheleftorrighthand

when thesink is tted.Cut the appropriate tapholeinto

thesink.Todothisyouwillneedaholesawortankcutter

settocutouta35mmdiameterholeandapilotdrill.On

thereversesideofthesinkyouwillndalocationpoint

forthepilotdrillinthecentreofthetapcut-out.Drillout

thepilothole.TurnthesinkoverandcarefullydrilLcOt4he

tap-hole.

WARNING: Velstra&Neostoneproduc includeasilicaller.ts

Anymachiningoperationwillproduceneparticlesofdust.

Drillingorcuttingmustbecarriedoutinawell-ventilated

area.

INSTALLATIONDETAILSVELSTRA®&NEOSTONESINKS

Produkt Specifikationer

Mærke:	Leisure
Kategori:	Køkkenvask
Model:	VHL1
Bredde:	980 mm
Dybde:	508 mm
Produktfarve:	Sort
Første skål, dybde:	180 mm
Første skål, dimensioner (BxL):	400 x 433 mm
Antal vaskeskåle:	1 skåle
Vask, type:	Top-monteret vask
Vask form:	Rektangulær
Vandhane, hul:	Ja
Drænebræt:	Ja
Antal huller til haner:	2
Størrelse på vandhane:	35 mm