Manson NTP-5631 Manual

Manson Batterioplader NTP-5631

Læs gratis den danske manual til Manson NTP-5631 (4 sider) i kategorien Batterioplader. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Manson NTP-5631, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

NTP- / /5661 SWITCHING MODE POWER SUPPLY 5621 5631

USER MANUAL

Keep this manual in a safe place for quick reference at all times.

This manual contains important safety and operation instructions for correct use of the power

supply. Read through the manual and pay special attention to the markings and labels of this unit

and equipment to be connected.

Pay special attention to these two types of notices used in this manual

WARNING:

Failure to observe this warning may cause injury to persons and damage to power supply

or connected equipment.

CAUTION:

Failure to observe this warning may result in damage to equipment

and Improper functioning of the power supply.

WARNING:

1. Do not use this power supply near water.

2. Do not operate or touch this power supply with wet hands.

3. Do not open the casing of the power supply when it is connected to ac mains.

4. Refer all servicing to qualied service personnel only.

5. Before replacing the AC fuse at AC socket, nd out and clear up the cause rst.

6. Replace the AC fuse with the same type and rating as the original fuse.

7. 5661 The max. output voltage of Model NTP- is 60VDC, avoid touch the metal contact part of the output

terminals.

CAUTION:

1. Use a grounded 3 pin AC source.

2. This unit is for indoor use only.

3. Do not operate or place this unit in a humid, dusty, in direct sunlight location or near any heat source.

4. Before plugging into local AC mains, check with the rating label at the back of the unit.

5. Do not block any ventilation openings of the unit.

6. This unit must be used within the specied rating, regular excessive continuous loading may cause

damage to the power supply.

7. The gauge size of input power cable must be at least 0.75mm

2 and the total length of power cable must

not exceed 3m.

OPERATION ENVIRONMENTAL CONDITION

• -80% R.H. 10

• Maximum relative humidity 80% for temperature up to 31°C decreasing linearly to 50% relative humidity at 40°C.

• Altitude up to 2000m

• Installation category: CAT 2

• Pollution degree: 2

• Mains supply voltage uctuation up to ±10% of the normal voltage

INTRODUCTIONS

This series of 100W Switching Mode Power Supplies with Current Limiting Control is designed with the objectives of

high accuracy, compactness and easy portability. Rotary encoder tuning with MCU are used for voltage and current

control. 4 digit display LCD of voltage and current for high precision.

CONTROLS AND INDICATORS

1. Power Switch

- Turns the power supply on off, when it is on the front display lights up. –

2. AC Input Socket with Fuse

3. Concealed Fuse box (ply open the cover to get to the fuse)

4. Output Voltage Tuning knob. (Quick push the knob to toggle the coarse and ne tuning)

5. Output Current Tuning knob. (Quick push the knob to toggle the coarse and ne tuning)

6. Output On/Off push button

- For Main output: Quick push this button to turn the Main output ON/OFF

- For Main output & Aux outputs: Push and hold this button for 3 seconds to turn the Main and Aux outputs

OFF, quick push this button again to turn them ON

7. n Mai Output Terminal Positive (+) Red color.

8. Main Output Terminal Negative (-) Black color

9. GND Terminal ( ) Green color

- Chassis ground terminal, normally this is to be short to (+) or (-) as required by user.

10. Aux Output 1 USB port (5VDC, 1.8 A)

11. Aux Output 2 USB port (5VDC, 1.8 A)

12. LCD Display panel showing:

- 4 digit voltmeter meter, (CV) constant voltage mode, (CC) constant current mode, , Am

- Output Terminal on/o state

- 2 digit Aux outputs Ammeter

13. Reserved (factory internal use only)

Produkt Specifikationer

Mærke:	Manson
Kategori:	Batterioplader
Model:	NTP-5631

Har du brug for hjælp?

Hvis du har brug for hjælp til Manson NTP-5631 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Batterioplader Manson Manualer

Manson HCS-3202 Manual

24 August 2024

Manson NTP-5561 Manual

24 August 2024

Manson NEP-8323 Manual

24 August 2024

Manson SDP-3660 Manual

24 August 2024

Manson NTP-5631 Manual

24 August 2024

Manson HCS-3102 Manual

24 August 2024

Manson SDP-3636 Manual

24 August 2024

Manson NTP-5521 Manual

24 August 2024

Batterioplader Manualer

Nyeste Batterioplader Manualer

Graphite 58G002-1 Manual

14 Juni 2025

Champion 100594 Manual

14 Juni 2025

Schwaiger LPBC0500 Manual

14 Juni 2025

Champion 100593 Manual

14 Juni 2025

Graphite 58G085-1 Manual

13 Juni 2025

Venom VS2872 Manual

9 Juni 2025

Stalco Perfect BCP60-8ACS Manual

9 Juni 2025

Stalco Perfect BCP60-5.5A Manual

8 Juni 2025

Xline CC702 Manual

8 Juni 2025

Draper D20 92239 Manual

8 Juni 2025