Mean Well ELG-150-C2100DA Manual

Mean Well Ikke kategoriseret ELG-150-C2100DA

Læs gratis den danske manual til Mean Well ELG-150-C2100DA (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 119 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 60 anmeldelser. Har du et spørgsmål om Mean Well ELG-150-C2100DA, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Installaon Manual

 Type：

：

：：LED Power Supply

（

（（Families

：

：：AP, CEN, CLG, ELG, ELN, GSC, HBG, HLG, HLN, HLP, HSG, HVG, LCM, LP, LPF, PLC, NPF, OWA, PCD,

PLC, PLD, PLM, PLN, PLP, PWM, ULP）

）

））

 Introducon

The LED power supply is a dedicated LED driving device that delivers a constant current/voltage or generates an

adjustable current controlled by an external dimmer to LEDs. Depending on its types or design concept, some of

them not only have PFC capability but also can be located in a harsh environment such as dusty, humid places.

Mean Well’s LED power supplies include metal case, plasc case, and PCB types.

 Installaon

（）1 Before commencing any installaon or maintenance work, please disconnect the power supply from the ulity.

Ensure that it cannot be re-connected inadvertently!

（）2 Keep proper venlaon around the unit and do not stack any object on it. Also a 10-15 cm clearance must be

kept when the adjacent device is a heat source.

（）3 Mounng orientaons other than standard orientaon or operate under high ambient temperature may

increase the internal component temperature and will require a de-rang in output current. Please refer to

the specicaon sheet to receive the opmum mounng posion and informaon about the -rang curve. de

（）4 Current rang of an approved primary /secondary cable should be greater than or equal to that of the unit.

Please refer to its specicaon.

（）5 For LED power supplies with waterproof connectors, verify that the linkage between the unit and the lighng

xture is ght so that water cannot intrude into the system.

（）6 For dimmable LED power supplies, make sure that your dimming controller is capable of driving

these units. For ELN series, either “D” or “P” type, require 40mA each unit; for those with “3 in 1” dimming

funcon, e.g. HLG and LPF series, require 0.15mA each unit.

（）7 Wiring: The wire color will vary by country, please refer to the table below.

North America

European Harmonized

Live and ACL

Black

Brown

Neutral and ACN

white

Blue

PE and FG (Class I only)

Green

Green/yellow

（）a Connect the FG wire (green or green/yellow) of the LED power supply to (green or green/yellow), this PE

step can be skipped when the unit is marked class II, ungrounded.

（）b Connect the ACL wire (black or brown) of the LED power supply to Live (black or brown).

（）c Connect the ACN wire (white or blue) of the LED power supply to Neutral (white or blue).

Installaon Manual

（）8 The maximum number of the LED PSUs that can be connected to a circuit breaker at 230V is shown as below.

Model

B10

B16

C10

C16

D10

D16

APC-8

APC- 12

APC- 16

APC- 25

APC- 35

APC- 8E

APC- 12E

APC- 16E

APV-8

APV- 12

APV- 16

APV- 25

APV- 35

APV- 8E

A -12E PV

APV-16E

CEN- 60

CEN- 75

CEN-100

CLG- 60

CLG- 100

CLG- 150

ELG- 75

ELG- 100

ELG- 150

ELG- -C 75

ELG- -C 100

ELG- -C 150

ELN- 30

ELN- 60

GSC18

GSC25

GSC40

HBG- 100

HBG- 160

HBG- 240

HBG- 60

Produkt Specifikationer

Mærke:	Mean Well
Kategori:	Ikke kategoriseret
Model:	ELG-150-C2100DA
Kode for international beskyttelse (IP):	IP20
Vekselstrømsindgangsspænding:	100 - 305 V
Bredde:	63 mm
Dybde:	219 mm
Højde:	35.5 mm
Vægt:	850 g
Udgangseffekt:	150 W
Udgangsspænding:	72 V
Bæredygtighedscertifikater:	RoHS