Morphy Richards has a policy of continuous improvement in product quality and
design. The company, therefore reserves the right to change the specification of
its models at any time.
For electrical products sold within the European Community. At the end of the
electrical products useful life, it should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice in your country.
Registering Your 2 ear GuaranteeY
Your standard one year guarantee is extended for an additional 12 months when you register
the product within 28 days of purchase with Morphy Richards. If you do not register the
product with Morphy Richards within 28 days, your product is guaranteed for 1 year. To
validate your 2 year guarantee register with us online at
www.morphyrichards.co.uk
N.B. Each qualifying product needs to be registered with Morphy Richards individually.
Please note that the 2 year guarantee is only available in the UK. Please refer to the ne year o
guarantee for more information.
Your 1 Year Guarantee
It is impotant to retain the retailer’s receipt as proof of purchase. Staple your receipt to this
back cover for future reference.
Please quote the following information if the product develops a fault. These numbers can be
found on the base of the product.
Model no. Serial no.
All Morphy Richards products are individually tested before leaving the factory. In the unlikely
event of any appliance proving to be faulty within 28 days of purchase, it should be returned
to the place of purchase for it to be replaced.
If the fault develops after 28 days and within 12 months of original purchase, you should
contact the Helpline quoting Model number and Serial number on the product, or rite to w
Morphy Richards at the address shown.
You may be asked to return a copy of proof of purchase.
Subject to the exclusions set out below (see Exclusions), the faulty appliance will then be
repaired or replaced as appropriate and dispatched usually within 7 working days of receipt.
If, for any reason, this item is replaced or repaired during the 1 year guarantee period, the
guarantee on the new item will be calculated from original purchase date. Therefore it is vital
to retain your original till receipt or invoice to indicate the date of initial purchase.
To qualify for the 1 year guarantee, the appliance must have been used according to the
instructions supplied. For example, crumb trays should have been emptied regularly.
Disclaimer
Making Coffee and Choosing the Right Cup
Your Espresso Machine with Milk Frother allows you to create a variety of coffee drinks helping
you to create the coffee shop experience in your own home. The diagrams on this page are a
simple guide showing you the percentage of ingredients that make up each of the drink types.
Troubleshooting
Beverage Type Ratio
Coffee doesn’t dispense Tank is empty.
Coffee grind is too fine.
Coffee is tamped too
densely.
Fill tank.
Use medium grind coffee.
Tamp the coffee firmly, but
do not use too much force.
Espresso Single
Double
60ml
119ml
Milk is not foamy after
frothing or it is not coming
out of the forthing tube
Out of steam.
Milk is not cold enough.
Frothing tube blocked.
Fill water tank.
Chill milk.
Clean milk tank and frothing
tube.
Cappuccino Single
Double
178ml
355ml
Coffee comes out too
quickly
Ground coffee is too coarse.
Not enough coffee.
Use medium grind.
Add more coffee.
Latte Single
Double
296ml
474ml
Weak coffee Wrong filter fitted.
Coffee too coarse.
Fit appropriate filter.
Use finer coffee.
Control lights flashing Tank is empty Fill tank
Reason SolutionProblem
Espresso
Hot Milk
Milk Froth
Espresso
Espresso
Espresso
Whipped Cream
Espresso con Panna
Espresso
Water
Americano Caffé Latte
Espresso
Hot Milk
Flat White
Espresso
Hot Milk
Milk Froth
Cappuccino
Espresso
Milk Froth
Espresso Macchiato
Espresso
Chocolate Syrup
Hot Milk
Whipped Cream
Caffé Mocha
Filling The Water Tank (2)
To fill the water tank, remove it from the unit
and fill under the tap between the “MIN” and
“MAX” markings on the tank. Alternatively,
use bottled or filtered water (see Descaling).
Close the water tank lid (3) and ensure the
tank is re-attached securely to the unit.
Select Your Filter
For a single shot – use the 1 cup filter (11)
Filling With Coffee
a. Fill the selected filter with fresh, fine
ground espresso coffee (do not overfill).
Note: the ground coffee should not exceed
the MAX amount mark.
b. Tamp and compress the coffee firmly
and evenly.
c. Clean any excess coffee from the rim to
ensure a proper fit under the brew head.
d. Place the porta-filter into the brew head
(4) ensuring it is properly locked and place a
cup under it.
Selecting Your Cup
Pull out the drip tray stand (15) if you are using a small “demitasse” cup to brew espresso or
when using a larger cup to brew latte or cappuccino stand your cup on the removeable drip
tray and grid (14).
For a double shot or 2 single shots – use the
2 cup filter (12)
Turning the Unit On
Plug the machine into an appropriate socket. Turn the on/off switch (1) to “I” . The six control
panel lights will start to flash until the water reaches temperature. When the six lights become
solid, your Espresso maker is ready to use.
Before brewing cappuccino, turn the froth
control knob on the milk tank to middle
position. You can adjust the quantity of
frothed milk to be dispensed by turning the
Milk Frother Control Knob (10) to the right to
increase and to the left to decrease.
The unit also allows you to prepare frothed milk for other beverages, e.g. macchiato, hot
chocolate etc or to add more foam to your beverage.
To avoid the coffee filter falling from the Potafilter when emptying the coffee grinds, the flap
in the Potafilter handle should be lifted and held in place with your thumb before upturning
the Potafilter.
When tap water is heated, calcium and other mineral deposits attach themselves to the
inside of your Espresso maker. Excessive build-up of lime scale can reduce efficiency and
also damage your machine. The frothing tube should be cleaned regularly as it is paticularly
vulnerable to lime scale blockage. Whenever possible we recommend using filtered or bottled
water. If this is not possible and you use water straight from the tap, it will be necessary to de-
scale the product regularly.
1. When the 6 lights on the control panel are quickly flashing alternately, this is a reminder to
descale your machine.
2. Fill the water tank (2) with 600ml clean water and a de-scaling liquid solution suitable for
coffee makers.
3. Press the Espresso (19) and Latte (25) buttons simultaneously, the machine automatically
starts the de-scaling mode, the six indicators then slowly flash alternately, after about half
an hour, the six indicators will start to quickly flash alternately.
4. Empty the water tank and refill it with 600ml clean water. Press Espresso (19) and Latte
(25) buttons simultaneously again, the machine will continue the de-scaling mode with the
six indicators slowly flashing alternately, after about half an hour the machine stops the
descale mode and goes back into standby condition.
Press and hold the Cappuccino Small & Large Cup Select Button (22) for 3 seconds and when
the required amount of frothed milk has been dispensed, press the Cappuccino Small & Large
Cup Select Button (22) once again to stop.
Once you have finished preparing your beverages with milk, you can either store the milk tank
in the refrigerator (ready to be used next time) or dispose of the leftover milk
CAUTION: When making cappuccino, latte or frothing milk, please make sure the milk frother
nozzle is positioned correctly inside/over the cup being used.
Note: You can press any functional buttons to cancel the de-scale warning and use as normal.
However, we suggest that you continue with the descale or the appliance will continue to
remind you to perform de-scaling after each use and the descale warning will only stop once a
complete descale cycle has completed.
The default de-scale programme will trigger after 500 cycles but we recommend in hard water
areas to descale after 40 cycles and in soft water areas after 80 cycles.
Note: If the machine is not operated for 15 minutes it will enter sleep mode.
You can press any button to wake up the machine.
Small Cup
Press the Cappuccino Small & Large Cup
Select Button (22) once to brew a small
cup of cappuccino, the 1 cup Cappuccino
dispense light (20) will illuminate while
dispensing; the programme stops
automatically.
Large Cup
Press the Cappuccino Small & Large Cup
Select Button (22) twice to brew a small
cup of cappuccino, the 1 cup Cappuccino
dispense light (20) and the 2 cup
Cappuccino dispense light (21) will illuminate
while dispensing; the programme stops
automatically.
Select The Function
Filling The Milk Tank (7)
If you are preparing cappuccino or latte,
remove the milk tank from the unit and
open the milk tanklid (8) and fill between
the “MIN” and “MAX” levels. Replace the
milk tank lid and ensure the milk tank is re-
attached securely to the unit.
Note: You can use the milk type of your
preference, e.g. whole milk, low fat milk,
organic or soy milk.
Preparing Cappuccino
Preparing Frothed Milk
Emptying Coffee Grinds from the Filters
Operating Instructions
Descaling
How to Descale
• Unplug from the mains and allow coffee maker cool down completely before cleaning.
• Make sure the appliance has completely cooled down.
• Wipe the exterior with a clean, damp cloth. Do not use any abrasives or metal scourers as
this will damage the finish on the unit.
• The Filters (11 & 12) and Water Tank (2) should be washed after each use by rinsing them
under clean warm water.
• To keep the Portafilter (5) clean, we recommend you periodically run the machine with the
Filter Holder in place, without coffee, using water only.
• Should the holes in the Filters become blocked with coffee grinds, use a fine bristled brush
to help clean.
• When your coffee maker is not being used, we recommend that you do not leave the
Portafilter (5) attached to the machine as this will reduce the life of the seal.
• Remove the Drip Tray and Grid (14) and Drip Tray Stand (15) from the appliance and rinse
them under clean warm water.
• Clean any spilt coffee, water and milk with a damp cloth or a damp sponge.
• Do not clean with alcohol or solvent cleanser. Never immerse the Espresso machine in
water for cleaning.
• Dry all cleaned attachments thoroughly
IMPORTANT: Never wash your coffee machine accessories in a dishwasher.
Care and Cleaning
Cleaning and Deep Cleaning the Milk Tank
and Frothing Tube
Even though the milk reservoir with left over milk can be stored in the refrigerator, it is
important to clean the milk tank (7) and the milk frothing nozzle (9) to avoid blockages.
NOTE: We also, recommend that the milk tank lid is dismantled regularly for deep cleaning.
• Remove the milk tank (7) from the unit.
• Remove the lid (8) from the milk tank (7).
• The milk frothing nozzle (9) can be detached by rotating and rinsed with clean warm water,
then replace.
• Pour away any leftover milk, rinse and wash the milk tank (7) and milk tank lid (8) thoroughly
with warm soapy water. Rinse and dry well. Do not use abrasive cleaners and scouring
pads, as they will scratch the finish.
• Place a large empty cup under the milk frothing nozzle (9) turn the milk frother control
knob clockwise to the clean position then press and hold the Latte Small & Large Cup
Select and cleaning button (25) for 3 seconds and release to activate the clean function.
The unit will start releasing steam through the frothing tube, let it run for a few seconds
then press the Latte Small & Large Cup Select and cleaning button (25) once to stop the
process.
• Detach the milk frothing nozzle (9) by rotating anti-clockwise and then pulling.
• Remove the milk tube from the lid by pulling.
• Remove the steam nozzle at the back of the lid by rotating anti-clockwise and then pulling.
• Wash all removed parts with clean warm water and dry thoroughly before reassembling.
• The silicon flap on top of the milk tank should also be lifted and underneath it rinsed with
clean water, dry thoroughly before replacing the silicon flap.
• Disconnect the machine from the power supply.
• Do not touch the metal parts until they have cooled.
• Remove the porta-filter and discard the coffee grounds. Wash both the porta-filter and
filter with warm soapy water and rinse them well. Do not wash the porta-filter and filters in
the dishwasher.
• Wipe brew head in the unit with a damp cloth or paper towel to remove any coffee
grounds left from brewing.
• Secure the porta-filter without a filter back into the brew head, place a large cup under
the porta-filter, press the espresso button once and let the unit brew with water only until
it stops automatically.
Remove the water tank and discard any remaining water, wash the water reservoir with soapy
water, rinse it well and wipe it dry. It is recommended to empty the water reservoir between
uses.
Deep Cleaning the Milk Tank Lid
Cleaning the Brew Head, the Pota-filter and
Filter
Cleaning the Water Tank
