MTX Audio RTF10P Manual

MTX Audio Ikke kategoriseret RTF10P

Læs gratis den danske manual til MTX Audio RTF10P (48 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om MTX Audio RTF10P, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/48

RTF10P

25cm (10“) Class-D Flat Sealed Enclosure

200W RMS - 600W Peak

mtxaudio.eu facebook.com/MTXEuropetwitter.com/MTXEurope

25cm 10“ 200W RMS

Class-D Powered Enclosure

EBC Remote

Control

High Level

Inputs

Gain Control

4V~0,1V

Ch.1

Ch.2

Power

+12V

Rem.

GND

Prot ection

Input

Left

Right

Owner’s Manual - MTX RTF10P

Thank You !

Thank you for purchasing an MTX Audio High-End powered enclosure. Proper installation matched with MTX speakers and powered

enclosures provide superior sound and performance for endless hours of waking the neighbors, slammin’ your friends or ﬂat out

stomping wanna-be players. Congrats and enjoy the ultimate audio experience with MTX !

Speciﬁcations :

• Powered sealed shallow enclosure

• Subwoofer : 25cm (10“)

• Class-D mono block Ampliﬁer

• Peak Power : 600W

• RMS Power : 200W

• EBC remote included

• High and low level inputs

• Dimensions : 34x48x13cm

Power Terminal (+12V) : This is the main power input for the ampliﬁer and must be con-

nected directly to the positive terminal of the vehicles battery for proper operation. Use

caution when installing (+12V) power cable in the vehicle. Avoid running this cable par-

allel with RCA cables, antennas, or other sensitive equipment due to massive currents that

can induce noise into the audio system. It is also very important to have a tight, secure

connection for maximum performance. MTX recommends using a minimum of 10mm2 full

copper power wire with the MTX RTF10P.

Remote Terminal (REM) : The ampliﬁer can be turned on by applying 12 volts to this ter-

minal. Typically this voltage is supplied by a wire from the source unit marked “remote”

or “power antenna”.

Ground Terminal (GND) : A proper ground is required for your ampliﬁer to operate at peak

performance. A short ground cable the same diameter as the power cable should be used

to attach the ground terminal directly to the chassis of the vehicle. Always remove paint,

dirt or debris to expose bare metal where the ground will be attached.

Protection LED (Prot.) : When the amp is in thermal protection, the LED turns to red.

PowerOn LED (PWR.) : The LED illuminates red when the amp is switched on.

RCA Inputs (Input) : These RCA inputs are used with source units that have RCA or Line level

outputs. (Source units need a minimum level of 100mV output for proper operation of the

ampliﬁer). MTX recommends only high quality RCA cables to decrease the possibility of

radiated noise entering the system.

Gain Control (Gain) : The gain control matches the input sensitivity of the ampliﬁer to the

source unit being used.

The operating range varies from 100mv to 4V. Adjusting the gain:

1. Turn the gain control on the ampliﬁer all the way down (counter clockwise).

2. Turn up the volume control on the source unit to approximately 3⁄4 of maximum.

3. Adjust the gain control on the ampliﬁer until audible distortion occurs.

4. Adjust the gain control down until audible distortion disappears.

5. The ampliﬁer is now calibrated to the output of the source unit.

Speaker level inputs (High Level Input) : This input will allow the ampliﬁer to operate from

source units with speaker-level outputs. Output speaker leads from the source unit should

be tied directly to the wire harness provided with the ampliﬁer.

Note : When speaker level inputs are used, a remote turn on wire must used to switch the

ampliﬁer on and oﬀ.

B ass remote control port (EBC) : use this port to connect the optional MTX EBC. It alows you

to control the output level siting at the front of the car.

Control Panel on the Ampliﬁer :

Produkt Specifikationer

Mærke:	MTX Audio
Kategori:	Ikke kategoriseret
Model:	RTF10P

Har du brug for hjælp?

Hvis du har brug for hjælp til MTX Audio RTF10P stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret MTX Audio Manualer

MTX Audio ZNXH2L Manual

28 December 2024

MTX Audio Terminator TN500-1D Manual

25 Juli 2024

MTX Audio Thunder Sports MUDRZRDK Manual

25 Juli 2024

MTX Audio Terminator TNA251 Manual

25 Juli 2024

MTX Audio Magnum MB210SP Manual

25 Juli 2024

MTX Audio RTU8P Manual

25 Juli 2024

MTX Audio iX4 Manual

25 Juli 2024

MTX Audio RTP8x2 Manual

25 Juli 2024

MTX Audio iWa250 Manual

25 Juli 2024

MTX Audio RTF10P Manual

25 Juli 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vulcan 1024W Manual

15 Juni 2025

Backyard Pro 554PL2030 Manual

15 Juni 2025

Haier 1U18TE2HDA Manual

15 Juni 2025

AEG EWKEXT1 Manual

15 Juni 2025

Planet XGPN-400AXV Manual

15 Juni 2025

Cadac 3 Cook Turbo Manual

15 Juni 2025

Bobrick B-3944 Manual

15 Juni 2025

Sony SZC-4008 Manual

15 Juni 2025

Watts ETX-15 Manual

15 Juni 2025

Sigma REMOTE ONE Manual

15 Juni 2025