NAD C725BEE Manual

NAD Modtager C725BEE

Læs gratis den danske manual til NAD C725BEE (24 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om NAD C725BEE, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/24

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Owner’s Manual

C 725BEE

Stereo Receiver

SAVE THESE INSTRUCTIONS FOR LATER USE.

FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE

AUDIO EQUIPMENT.

1 Read instructions - All the safety and operating instructions should be

read before the product is operated.

2 Retain instructions - The safety and operating instructions should be

retained for future reference.

3 Heed Warnings - All warnings on the product and in the operating

instructions should be adhered to.

4 Follow Instructions - All operating and use instructions should be

followed.

5 Cleaning - Unplug this product from the wall outlet before cleaning.

Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for

cleaning.

6 Attachments - Do not use attachments not recommended by the

product manufacturer as they may cause hazards.

7 Water and Moisture - Do not use this product near water-for example,

near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet

basement; or near a swimming pool; and the like.

8 Accessories - Do not place this product on an unstable cart, stand,

tripod, bracket, or table. The product may fall, causing serious injury to

a child or adult, and serious damage to the product. Use only with a

cart, stand, tripod, bracket, or table recommended by the manufacturer,

or sold with the product. Any mounting of the product should follow

the manufacturer’s instructions, and should use a mounting accessory

recommended by the manufacturer.

9 A product and cart combination should be moved with

care. Quick stops, excessive force, and uneven surfaces may

cause the product and cart combination to overturn.

10 Ventilation - Slots and openings in the cabinet are provided for

ventilation and to ensure reliable operation of the product and to

protect it from overheating, and these openings must not be blocked

or covered. The openings should never be blocked by placing the

product on a bed, sofa, rug, or other similar surface. This product should

not be placed in a built-in installation such as a bookcase or rack unless

proper ventilation is provided or the manufacturer’s instructions have

been adhered to.

11 Power Sources - This product should be operated only from the type

of power source indicated on the marking label. If you are not sure of

the type of power supply to your home, consult your product dealer or

local power company.

The primary method of isolating the amplier from the mains supply

is to disconnect the mains plug. Ensure that the mains plug remains

accessible at all times. Unplug the AC power cord from the AC outlet if

the unit will not be used for several months or more.

12 Grounding or Polarization - This product may be equipped with a

polarized alternating-current line plug (a plug having one blade wider

than the other). This plug will t into the power outlet only one way.

This is a safety feature. If you are unable to insert the plug fully into the

outlet, try reversing the plug. If the plug should still fail to t, contact

your electrician to replace your obsolete outlet. Do not defeat the safety

purpose of the polarized plug.

13 Power - Cord Protection - Power-supply cords should be routed so that

they are not likely to be walked on or pinched by items placed upon or

against them, paying particular attention to cords at plugs, convenience

receptacles, and the point where they exit from the product.

14 Outdoor Antenna Grounding - If an outside antenna or cable system

is connected to the product, be sure the antenna or cable system is

grounded so as to provide some protection against voltage surges

and built-up static charges. Article 810 of the National Electrical Code,

ANSI/NFPA 70, provides information with regard to proper grounding

of the mast and supporting structure, grounding of the lead-in wire

to an antenna discharge unit, size of grounding conductors, location

of antenna discharge unit, connection to grounding electrodes, and

requirements for the grounding electrode.

NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer’s attention to Section

820-40 of the NEC which provides guidelines for proper grounding and, in

particular, species that the cable ground shall be connected to the grounding

system of the building, as close to the point of cable entry as practical.

15 Lightning - For added protection for this product during a lightning

storm, or when it is left unattended and unused for long periods of

time, unplug it from the wall outlet and disconnect the antenna or

cable system. This will prevent damage to the product due to lightning

and power-line surges.

16 Power Lines - An outside antenna system should not be located in the

vicinity of overhead power lines or other electric light or power circuits,

or where it can fall into such power lines or circuits. When installing an

outside antenna system, extreme care should be taken to keep from

touching such power lines or circuits as contact with them might be

fatal.

17 Overloading - Do not overload wall outlets, extension cords, or

integral convenience receptacles as this can result in a risk of re or

electric shock.

18 Object and Liquid Entry - Never push objects of any kind into this

product through openings as they may touch dangerous voltage points

or short-out parts that could result in a re or electric shock. Never spill

liquid of any kind on the product.

WARNING: THE APPARATUS SHOULD NOT BE EXPOSED TO

DRIPPING OR SPLASHING, AND OBJECTS FILLED WITH LIQUIDS,

SUCH AS VASES, SHOULD NOT BE PLACED ON THE APPARATUS.

AS WITH ANY ELECTRONIC PRODUCTS, USE CARE NOT TO SPILL

LIQUIDS INTO ANY PART OF THE SYSTEM. LIQUIDS CAN CAUSE A

FAILURE AND/OR A FIRE HAZARD.

IMPORTANT SAFETY INSTRUCTIONS

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

Produkt Specifikationer

Mærke:	NAD
Kategori:	Modtager
Model:	C725BEE
Bredde:	435 mm
Dybde:	350 mm
Højde:	133 mm
Vægt:	9400 g
Brugervejledning:	Ja
Produktfarve:	Sort
Pakkevægt:	11000 g
Wi-Fi:	Ingen
Equalizer:	Ja
Ethernet LAN:	Ingen
Fjernbetjening inkluderet:	Ja
Frekvensområde:	20 - 20000 Hz
Forbindelsesteknologi:	Ledningsført
Lyd-output kanaler:	2.0 kanaler
Pakkens dimensioner (BxDxH):	435 x 396 x 149 mm
Understøttede radiobånd:	AM, FM
RDS Tuner inkluderet:	Ja
Lyd (L, R) indgang:	6
AC (strøm) indgang:	Ja
Lyd (L, R) udgang:	4
klirfaktor (THD):	0.01 %
Signal/støjforhold:	107 dB
FM båndbredde:	87.5 - 108.5 Mhz
Linie ud:	Ja
Line-in:	Ja
Fjernbetjeningstype:	SR 8
Bas indstillinger:	Ja
Diskant indstillinger:	Ja
Højttalere tilslutningstype:	Fortøjningsstolpe
Kampatibilitet med Apple-docking:	Ikke understøttet
Antal forudindstillede stationer:	30
RS-232-porte:	1
Output impedans:	75 - 1000 ohm (Ω)
AM båndbredde:	530 - 1710 kHz
Indgangsimpedans:	22000 ohm (Ω)
Udgangseffekt pr. kanal (20-20KHz @8 Ohm):	- W
Optisk drev inkluderet:	Ingen
Fjernbetjening (IR) indgang:	1
Fjernbetjening (IR) udgang:	1
12V udløser:	Ja
RS-232 grænseflade:	Ja
Maksimalt indgangsniveau:	6 V
Indgangsfølsomhed:	730 mV
Højttalervælger:	A+B
Dynamisk effekt pr. kanal (4 Ohm):	148 W
Dynamisk effekt pr. kanal (8 Ohm):	102 W
Pre-out-tilslutningsmulighed:	Ja
Antal 12V triggerporte:	1