NAD L40 Manual

NAD Modtager L40

Læs gratis den danske manual til NAD L40 (84 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 17 anmeldelser. Har du et spørgsmål om NAD L40, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/84

L 40

STORE

CANCEL DISPLAY MONO

BASS EQ

TONE

DEFEATRANDOMREPEAT

VOLUME

TREBLE BALANCE BASSINPUT SELECTOR

SEARCH / TUNE

PLAY PAUSEST OP OPEN SKIP/ PRESET

Compact Disc Receiver L40

PHONES

RANDOM REPEAT 1 ALL TOTAL STEREO RDS

kHz

MHz

PROGRAM REMAIN BASS EQ TONE DEFEATANTENNA

• OWNER'S MANUAL

• MANUEL D'INSTALLATION

• BEDIENUNGSANLEITUNG

• MANUAL DEL USUARIO

• MANUALE DELLE ISTRUZIONI

• BRUKSANVISNING

• MANUAL DO PROPRIETÁRIO

Warning: To reduce the risk of fire or electric shock, do not expose this

unit to rain or moisture.

The lightning flash with an arrowhead symbol within an equilateral trian-

gle is intended to alert the user to the presence of uninsulated “danger-

ous voltage” within the product’s enclosure that may be of sufficient

magnitude to constitute a risk of electric shcok to persons.

The exclamation point within an equilateral triangle is intended to alert

the user to the presence of important operating and maintenance

(servicing) instructions in the literature accompanying the product.

Do not place this unit on an unstable cart, stand or tripod,

bracket or table. The unit may fall, causing serious injury to a

child or adult and serious damage to the unit. Use only with a

cart, stand, tripod, bracket or table recommended by the man-

ufacturer or sold with the unit. Any mounting of the device on a

wall or ceiling should follow the maufacturer’s instructions and

should use a mounting accessory recommended by the manu-

facturer.

An appliance and cart combination should be moved with care. Quick stops,

excessive force and uneven surfaces may cause the appliance and cart combi-

nation to overturn.

Read and follow all the safety and operating instructions before connecting or

using this unit. Retain this notice and the owner’s manual for future reference.

All warnings on the unit and in it’s operating instructions should be adhered to.

Do not use this unit near water; for example, near a bath tub, washbowl, kitchen

sink, laundry tub, in a wet basement or near a swimming pool.

The unit should be installed so that its location or position does not interfere with

its proper ventilation. For example, it should not be situated on a bed, sofa, rug

or similar surface that may block the ventilation openings; or placed in a built-in

installation, such as a bookcase or cabinet, that may impede the flow of air

through its ventilation openings.

The unit should be situated from heat sources such as radiators, heat registers,

stoves or other devices (including amplifiers) that produce heat.

The unit should be connected to a power supply outlet only of the voltage and

frequency marked on its rear panel.

The power supply cord should be routed so that it is not likely to be walked on or

pinched, especially near the plug, convenience receptacles, or where the cord

exits from the unit.

Unplug the unit from the wall outlet before cleaning. Never use benzine, thinner

or other solvents for cleaning. Use only a soft damp cloth.

The power supply cord of the unit should be unplugged from the wall outlet when

it is to be unused for a long period of time.

Care should be taken so that objects do not fall, and liquids are not spilled into

the enclosure through any openings.

This unit should be serviced by qualified service personnel when:

A. The power cord or the plug has been damaged; or

B. Objects have fallen, or liquid has been spilled into the unit; or

C. The unit has been exposed to rain or liquids of any kind; or

D. The unit does not appear to operate normally or exhibits a marked change in

performance; or

E. The device has been dropped or the enclosure damaged.

DO NOT ATTEMPT SERVICING OF THIS UNIT YOURSELF.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

Upon completion of any servicing or repairs, request the service shop s assur-’

ance that only Factory Authorized Replacement Parts with the same characteris-

tics as the original parts have been used, and that the routine safety checks

have been performed to guarantee that the equipment is in safe operating condi-

tion.

REPLACEMENT WITH UNAUTHORIZED PARTS MAY RESULT IN FIRE,

ELECTRIC SHOCK OR OTHER HAZARDS.

ATTENTION

POUR VITER LES CHOC ELECTRIQUES, INTRODUIRE LA LAMEÉ

LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON-

DANTE DE LA PRISE ET POUSSER JUSQU AU FOND.’

CAUTION

TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG

TO WIDE SLOT FULLY INSERT.

If an indoor antenna is used (either built into the set or installed separately),

never allow any part of the antenna to touch the metal parts of other electrical

appliances such as a lamp, TV set etc.

CAUTION

POWER LINES

Any outdoor antenna must be located away from all power lines.

OUTDOOR ANTENNA GROUNDING

If an outside antenna is connected to your tuner or tuner-preamplifier, be sure

the antenna system is grounded so as to provide some protection against volt-

age surges and built-up static charges. Section 810 of the National Electrical

Code, ANSI/NFPA No. 70-1984, provides information with respect to proper

grounding of the mast and supporting structure, grounding of the lead-in wire to

an antenna discharge unit, size of grounding conductors, location of antenna dis-

charge unit, connection to grounding electrodes and requirements for the

grounding electrode.

a. Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminium, No. 17

AWG (1.0mm2) copper-clad steel or bronze wire, or larger, as a ground wire.

b. Secure antenna lead-in and ground wires to house with stand-off insulators

spaced from 4-6 feet (1.22 - 1.83 m) apart.

c. Mount antenna discharge unit as close as possible to where lead-in enters

house.

d. Use jumper wire not smaller than No.6 AWG (13.3mm2) copper, or the equiva-

lent, when a separate antenna-grounding electrode is used. see NEC Section

810-21 (j).

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL

CODE INSTRUCTIONS CONTAINED IN ARTICLE 810 - RADIO AND TELEVI-

SION EQUIPMENT.

NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to

call the CATV system installer s attention to Article 820-22 of the’

National Electrical Code that provides guidelines for proper grounding

and, in particular, specifies that the ground cable ground shall be con-

nected to the grounding system of the building, as close to the point of

cable entry as practical.

CAUTION

RISK OF ELECTRIC

SHOCK DO NOT OPEN

ATTENTION:

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO USER

SERVICEABLE PARTS INSIDE. REFER SERVICING TO

QUALIFIER SERVICE PERSONNEL

IMPORTANT SAFETY INSTRUCTIONS

Produkt Specifikationer

Mærke:	NAD
Kategori:	Modtager
Model:	L40

Har du brug for hjælp?

Hvis du har brug for hjælp til NAD L40 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager NAD Manualer

NAD M2 Manual

30 September 2024

NAD CI 8-150 DSP Manual

27 September 2024

20 September 2024

16 September 2024

15 September 2024

28 August 2024

15 August 2024

10 August 2024

9 August 2024

6 August 2024

Modtager Manualer

Nyeste Modtager Manualer

Futaba R7206 SB Manual

16 Juni 2025

DS18 FRP-3.5K Manual

16 Juni 2025

DS18 SMD-300.4AB Manual

16 Juni 2025

DS18 SMD-3000.1D Manual

16 Juni 2025

DS18 GEN-X G3600.1D Manual

16 Juni 2025

DS18 HYDRO NXL-X1000.1D Manual

16 Juni 2025

DS18 SMD-200.4AB Manual

16 Juni 2025

DS18 GEN-X G1000.4D Manual

16 Juni 2025

DS18 GEN-X G4000.5D Manual

16 Juni 2025

Diamond Audio MICRO85U Manual

16 Juni 2025