NEC multisync vt460k Manual

NEC Beamer projektor multisync vt460k

Læs gratis den danske manual til NEC multisync vt460k (42 sider) i kategorien Beamer projektor. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om NEC multisync vt460k, eller vil du spørge andre brugere om produktet?

Side 1/42
Portable Projector
VT660K/VT460K
VT560
Users Manual
E-2
Safety Cautions
Precautions
Please read this manual carefully before using your NEC VT660K/
VT460K/VT560 Projector and keep the manual handy for future refer-
ence. Your serial number is located on the bottom of your projector.
Record it here:
CAUTION
To turn off main power, be sure to remove the plug from power
outlet.
The power outlet socket should be installed as near to the
equipment as possible, and should be easily accessible.
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED NEC SERVICE PER-
SONNEL.
This symbol warns the user that uninsulated voltage within the
unit may be sufficient to cause electrical shock. Therefore, it is
dangerous to make any kind of contact with any part inside of
the unit.
This symbol alerts the user that important information con-
cerning the operation and maintenance of this unit has been
provided.
The information should be read carefully to avoid problems.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
DO NOT USE THIS UNIT’S PLUG WITH AN EXTENSION CORD
OR IN AN OUTLET UNLESS ALL TWO PRONGS CAN BE FULLY
INSERTED.
DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE COM-
PONENTS INSIDE. ALL SERVICING MUST BE DONE BY QUALI-
FIED NEC SERVICE PERSONNEL.
DOC Compliance Notice
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Acoustic Noise Information Ordinance-3. GSGV:
The sound pressure level is less than 70 dB (A) according
to ISO 3744 or ISO 7779.
RF Interference
WARNING
The Federal Communications Commission does not allow any
modifications or changes to the unit EXCEPT those specified
by NEC Soluctions (America), Inc. in this manual. Failure to com-
ply with this government regulation could void your right to
operate this equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for
help.
In UK, a BS approved power cable with moulded plug has a Black (five
Amps) fuse installed for use with this equipment. If a power cable is not
supplied with this equipment please contact your supplier.
Important Safeguards
These safety instructions are to ensure the long life of your projector
and to prevent fire and shock. Please read them carefully and heed all
warnings.
Installation
1. For best results, use your projector in a darkened room.
2. Place the projector on a flat, level surface in a dry area away from
dust and moisture.
3. Do not place your projector in direct sunlight, near heaters or heat
radiating appliances.
4. Exposure to direct sunlight, smoke or steam can harm internal com-
ponents.
5. Handle your projector carefully. Dropping or jarring can damage in-
ternal components.
6. Do not place heavy objects on top of the projector.
7. If you wish to have the projector installed on the ceiling:
a. Do not attempt to install the projector yourself.
b. The projector must be installed by qualified technicians in order
to ensure proper operation and reduce the risk of bodily injury.
c. In addition, the ceiling must be strong enough to support the
projector and the installation must be in accordance with any
local building codes.
d. Please consult your dealer for more information.
Important Information
CAUTION
•Avoid displaying stationary images for a prolonged pe-
riod of time.
Doing so can result in these images being temporarily
sustained on the surface of the LCD panel.
If this should happen, continue to use your projector. The
static background from previous images will disappear.
Do not put the projector on its side when the lamp is
turned on.
Doing so may cause damage to the projector.


Produkt Specifikationer

Mærke: NEC
Kategori: Beamer projektor
Model: multisync vt460k

Har du brug for hjælp?

Hvis du har brug for hjælp til NEC multisync vt460k stil et spørgsmål nedenfor, og andre brugere vil svare dig




Beamer projektor NEC Manualer

NEC

NEC GT 5000 Manual

26 August 2024
NEC

NEC MT1045E Manual

26 August 2024
NEC

NEC np 4001 Manual

25 August 2024
NEC

NEC mt 860 Manual

25 August 2024
NEC

NEC LT156 Manual

25 August 2024
NEC

NEC np 2150 Manual

25 August 2024
NEC

NEC LT150 Manual

25 August 2024
NEC

NEC HT410 Manual

25 August 2024
NEC

NEC np 3150 Manual

25 August 2024

Beamer projektor Manualer

Nyeste Beamer projektor Manualer

Toshiba

Toshiba TLP-T60 Manual

15 Januar 2025
Bauer

Bauer Pantason M Manual

13 Januar 2025
Bauer

Bauer T17 Manual

13 Januar 2025
Bauer

Bauer Pantason S Manual

13 Januar 2025
Sanyo

Sanyo PLC EF10E Manual

17 December 2024
Viewsonic

Viewsonic PJ557DC Manual

4 Oktober 2024
XGIMI

XGIMI MoGo 2 Pro Manual

29 August 2024