NEC VT460 Manual

NEC Beamer VT460

Læs gratis den danske manual til NEC VT460 (41 sider) i kategorien Beamer. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om NEC VT460, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/41

Portable Projector

VT660/VT560/VT460

User’s Manual

E-2

Safety Cautions

Precautions

Please read this manual carefully before using your NEC VT660/VT560/

VT460 Projector and keep the manual handy for future reference. Your

serial number is located on the bottom of your projector. Record it here:

CAUTION

To turn off main power, be sure to remove the plug from power

outlet.

The power outlet socket should be installed as near to the

equipment as possible, and should be easily accessible.

CAUTION

TO PREVENT SHOCK, DO NOT OPEN THE CABINET.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED NEC SERVICE PER-

SONNEL.

This symbol warns the user that uninsulated voltage within the

unit may be sufficient to cause electrical shock. Therefore, it is

dangerous to make any kind of contact with any part inside of

the unit.

This symbol alerts the user that important information con-

cerning the operation and maintenance of this unit has been

provided.

The information should be read carefully to avoid problems.

WARNING

TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO

RAIN OR MOISTURE.

DO NOT USE THIS UNIT’S PLUG WITH AN EXTENSION CORD

OR IN AN OUTLET UNLESS ALL TWO PRONGS CAN BE FULLY

INSERTED.

DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE COM-

PONENTS INSIDE. ALL SERVICING MUST BE DONE BY QUALI-

FIED NEC SERVICE PERSONNEL.

DOC Compliance Notice

This Class B digital apparatus meets all requirements of the Canadian

Interference-Causing Equipment Regulations.

Acoustic Noise Information Ordinance-3. GSGV:

The sound pressure level is less than 70 dB (A) according

to ISO 3744 or ISO 7779.

RF Interference

WARNING

The Federal Communications Commission does not allow any

modifications or changes to the unit EXCEPT those specified

by NEC Soluctions (America), Inc. in this manual. Failure to com-

ply with this government regulation could void your right to

operate this equipment. This equipment has been tested and

found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installa-

tion. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician for

help.

In UK, a BS approved power cable with moulded plug has a Black (five

Amps) fuse installed for use with this equipment. If a power cable is not

supplied with this equipment please contact your supplier.

Important Safeguards

These safety instructions are to ensure the long life of your projector

and to prevent fire and shock. Please read them carefully and heed all

warnings.

Installation

1. For best results, use your projector in a darkened room.

2. Place the projector on a flat, level surface in a dry area away from

dust and moisture.

3. Do not place your projector in direct sunlight, near heaters or heat

radiating appliances.

4. Exposure to direct sunlight, smoke or steam can harm internal com-

ponents.

5. Handle your projector carefully. Dropping or jarring can damage in-

ternal components.

6. Do not place heavy objects on top of the projector.

7. If you wish to have the projector installed on the ceiling:

a. Do not attempt to install the projector yourself.

b. The projector must be installed by qualified technicians in order

to ensure proper operation and reduce the risk of bodily injury.

c. In addition, the ceiling must be strong enough to support the

projector and the installation must be in accordance with any

local building codes.

d. Please consult your dealer for more information.

Important Information

CAUTION

• Avoid displaying stationary images for a prolonged pe-

riod of time.

Doing so can result in these images being temporarily

sustained on the surface of the LCD panel.

If this should happen, continue to use your projector. The

static background from previous images will disappear.

• Do not put the projector on its side when the lamp is

turned on.

Doing so may cause damage to the projector.

Produkt Specifikationer

Mærke:	NEC
Kategori:	Beamer
Model:	VT460

Har du brug for hjælp?

Hvis du har brug for hjælp til NEC VT460 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Beamer NEC Manualer

NEC NC2043ML Manual

12 Januar 2025

NEC NP-NC1503L Manual

18 December 2024

10 Oktober 2024

4 Oktober 2024

21 September 2024

14 September 2024

14 September 2024

1 September 2024

NEC NP-PA1705UL Manual

26 August 2024

NEC MT860 Manual

24 August 2024

Beamer Manualer

Nyeste Beamer Manualer

Philips NeoPix 130 Smart Manual

5 Marts 2025

Philips NeoPix 200 NPX200 Manual

5 Marts 2025

Acer DX427 Manual

30 Januar 2025

Acer HL-4K50 Manual

30 Januar 2025

Acer LR560ATV Manual

30 Januar 2025

Acer Vero PL3515ATV Manual

30 Januar 2025

Acer PD2528ic Manual

30 Januar 2025

Acer Vero PD2328 Manual

30 Januar 2025

Optoma UHZ35 Manual

29 Januar 2025

Acer P1165P Manual

13 Januar 2025