Nemco 6450-4 Manual

Nemco Ikke kategoriseret 6450-4

Læs gratis den danske manual til Nemco 6450-4 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 44 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 22.5 anmeldelser. Har du et spørgsmål om Nemco 6450-4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

HEATED DISPLAY CASE

Model Series: 6450, 6450-4, 6451, 6451-2, 6451-NM,

6452, 6452-2, 6453, 6453-2, 6454, 6454-2,

6455, 6455-2

OPERATING INSTRUCTIONS

INTRODUCTION

1. Please read instructions before using this appliance.

2. When using electrical appliances, always follow basic precautions to reduce the risk of fire, electric shock and injury to persons.

3. Clean machine thoroughly before and after all uses using cleaning instructions below.

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model labels.

2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this machine. Do not

operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use authorized service for

examination, electrical or mechanical adjustment or repair.

3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL. To avoid burns, do not let bare skin

touch hot surfaces. Keep combustible materials away from appliance.

4. Use extreme caution when any appliance is used by or near children and whenever the appliance is left operating and unattended.

5. This appliance is not intended for use near or around water. Never locate appliance where it may fall into a water container.

6. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electrical shock, fire or

damage to the appliance. Do not block air intakes or exhaust in any manner. Do not use on soft surfaces where openings may

become blocked.

PREPARATION

1. Remove all packing pieces and lift unit out of the box.

2. Remove any outside packaging.

3. Remove any plastic coating that may be affixed to stainless steel surfaces.

4. Be sure the round tier rack systems (equipped on models that rotate) are secure at the top and bottom.

5. CAUTION – To reduce the risk of fire, the appliance is to be installed in non-combustible surroundings only, with no

combustible material within 18 inches of the sides, front, or rear of the appliance or within 40 inches above the appliance.

The appliance is to be mounted on floors of noncombustible construction with non-combustible flooring and surface finish

and with no combustible material against the underside, or on noncombustible slabs or arches that have no combustible

material against the underside. Such construction shall in all cases extend not less than 12 inches beyond the equipment

on all sides.

6. Unit can only be operated with the 4” legs provided. Failure to do so will cause damage to the unit.

7. Set unit on a flat surface.

8. Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or the

like. Arrange cord where it will not be tripped over.

9. This appliance has hot and live electrical parts. Do not use in areas where gasoline, paint or flammable liquids are used or stored.

10. If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761.

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to plug unit into grounded

outlet with sufficient power.

WARNING: DURING NORMAL OPERATIONS THE EXTERIOR OF THE UNIT IS HOT.

OPERATION

1. Fill one or both water reservoirs to provide humidity as required. Do not overfill.

2. Plug the unit into the appropriate power supply.

3. Turn heat switch to on position.

4. Turn temperature switch to high and preheat approximately 15 minutes.

5. Turn the temperature control to desired setting. (High, Medium or Low)

6. Load food products when pre-heat is complete.

7. Turn on the light switch for lights and rotating rack if equipped.

8. Pull pin and lift the top coupling to remove rack.

9. To disconnect appliance, turn controls to off and remove plug from outlet.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Ikke kategoriseret
Model:	6450-4

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 6450-4 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Nemco Manualer

17 September 2025

26 August 2025

26 August 2025

26 August 2025

25 August 2025

25 August 2025

21 August 2024

21 August 2024

20 August 2024

20 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Iogear GCS1908W Manual

30 Oktober 2025

Reflecta 23295 Manual

30 Oktober 2025

Calorex Delta DT 4 Manual

30 Oktober 2025

Abus HUD-Y ACE PURE Manual

30 Oktober 2025

Krups FDK442 Manual

30 Oktober 2025

Iogear GCS62HDPKIT Manual

30 Oktober 2025

Eliminator Lighting E 107 Manual

30 Oktober 2025

Segway eScooter E150S Manual

30 Oktober 2025

Phoenix Gold ZD-VOL4 Manual

30 Oktober 2025

Olimpia Splendid Bi2 SLIR NAKED Manual

30 Oktober 2025