Nemco 6600 Manual

Nemco Ikke kategoriseret 6600

Læs gratis den danske manual til Nemco 6600 (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Nemco 6600, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

NEMCO STEAMER

Model Series: 6600

OPERATING INSTRUCTIONS

INTRODUCTION

1. Read These Operating Instructions thoroughly before installing or using this Equipment. Improper installation or use can result in

equipment or property damage, electric shock or personal injury.

2. Nemco Steamers are heavy duty and are designed for commercial use.

3. Only trained personnel should operate this equipment.

SAFETY INSTRUCTIONS

1. IMPORTANT: Clean machine thoroughly before first use and after all uses, using cleaning instructions below.

2. IMPORTANT: Incoming power MUST be the same as the equipment’s rating. Refer to the Electrical Ratings listed on the

equipment’s Data Tag Located on the side of the unit.

3. CAUTION: This unit’s power cord is equipped with a GROUNDED, 3-prong power cord. Plug only into a matching, grounded outlet.

DO NOT cut or break off the third prong. Operating this equipment without proper grounding may result in electric shock.

4. CAUTION: Always disconnect Power when not in use and before cleaning or servicing.

5. CAUTION: Do not operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use

authorized service for examination, electrical or mechanical adjustment or repair.

6. CAUTION: Equipment surfaces are HOT during use and a short time after disconnecting the power. Allow to cool before moving or

servicing.

7. WARNING: DO NOT immerse in water or other liquid. DO NOT clean with water jet. SEVERE personal injury or death can result.

ELECTRICAL REQUIREMENTS

1. The electrical ratings are listed on the equipment’s Data Tag located on the side of this equipment.

2. Model 6600 is rated 120 Volts, 1800 Watts, 15Amps and has a NEMA 5-15P plug and grounded cord.

3. This equipment must be properly GROUNDED.

Note: This unit is equipped with a Hi-Limit reset button (located on the rear of the unit). To reset this thermostat, unplug the unit

and allow unit to cool for approximately 45 minutes. Remove cap located on the reset switch and fully press the reset button and

reinstall cap.

PREPARATION

1. Remove all packing pieces and lift unit out of the box.

2. Remove any outside packaging.

3. Set unit on a flat surface. REFER to SAFETY INSTRUCTIONS No. 1 above.

4. Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or the

like. Arrange cord where it will not be tripped over.

5. This appliance has hot and live electrical parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or

stored.

6. Unit must be operated with legs installed.

7. Remove any white plastic coating that may be affixed to exterior surfaces.

8. If unit fails to work properly when first operated,

call NEMCO customer service at 1-800-782-6761.

OPERATION

1. Plug the unit into the power supply.

2. Open tank cover and verify that filter inside tank is installed properly. Fill unit with approximately 3 quarts of cold tap water (Do

NOT overfill the tank). Note: 6600 is designed to use cold tap water. Distilled water may be used to reduce calcium/mineral deposit

build-up and reduce maintenance costs.

3. Turn on/off switch to the on position and allow the unit to preheat for approximately 30 minutes. Note: Do NOT push the operate

button during warm-up.

4. Open the top cover and place the product to be steamed onto the Trivet and then close the top cover.

5. Press the OPERATE button for 1 second then release and wait 20 seconds for the steam to penetrate the product. Repeat if product

requires more steam. Note: Pressing and holding the OPERATE button for longer than 1 second at a time and/or to often will flood

out the generator surface and result in poor steaming.

6. Remove steamed product.

7. To disconnect appliance, turn switch to off and remove plug from outlet.

WARNING: DURING NORMAL OPERATION, THE EXTERIOR OF THE UNIT IS HOT.

1011069 Rev. D 03/121

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Ikke kategoriseret
Model:	6600

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 6600 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Nemco Manualer

17 September 2025

26 August 2025

26 August 2025

26 August 2025

25 August 2025

25 August 2025

21 August 2024

21 August 2024

20 August 2024

20 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

IFM EBT004 Manual

31 Oktober 2025

Nebula P1 Manual

31 Oktober 2025

Philips BG3470 Manual

31 Oktober 2025

IFM EBC029 Manual

31 Oktober 2025

Adventys DTIC 6000 Manual

31 Oktober 2025

Blizzard wiCICLE Ion Manual

31 Oktober 2025

Adventys GLN 3000 Manual

31 Oktober 2025

Soler & Palau PULSER-D Manual

31 Oktober 2025

EtherWAN EX46100 Manual

31 Oktober 2025

Cudy M3600 Manual

31 Oktober 2025