NightStick XPP-5422GMX Manual

NightStick Lommelygte XPP-5422GMX

Læs gratis den danske manual til NightStick XPP-5422GMX (4 sider) i kategorien Lommelygte. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om NightStick XPP-5422GMX, eller vil du spørge andre brugere om produktet?

Side 1/4
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-XPP-5422GMX-GMXA-DL-24
08-28-2024
Instruction Manual
XPP-5422GMX / XPP-5422GMXA
THE XPP-5422GMX/GMXA IS APPROVED FOR USE
CLASS I DIV 1 GRPS A-D T3
CLASS II & III DIV 1 GRPS E-G T135C
CLASS I ZONE 0 IIC T3
CLASS II ZONE 20 IIIC T135C
-20ºC ≤ Tamb ≤ +40ºC
1.5V/Cell AA Alkaline
ID 4003544
INTRINSICALLY SAFE
SECURITE INTRINSEQUE
Bayco Products, Inc. XPP-5422GMX
Wylie, TX 75098
640 S. Sanden Blvd.
CLASS I DIV 1 GRPS A-D T3
CLASS II & III DIV 1 GRPS E-G T135C
CLASS I ZONE 0 AEx ia IIC T3 Ga
CLASS I ZONE 0 Ex ia IIC T3 Ga
Ex ia op is I Ma
Ex ia op is IIC T3 Ga
Intertek ITS 13 ATEX 27837X
ITS21UKEX0264X
IECEx ITS 16.0067X
-20ºC ≤ Tamb ≤ +40ºC
1.5V/Cell AA Alkaline
2575
ID 4003544
INTRINSICALLY SAFE
SECURITE INTRINSEQUE
I M 1 Ex ia op is I Ma
II 1 G Ex ia op is IIC T3 Ga
Bayco Products, Inc. XPP-5422GMXA
Wylie, TX 75098
640 S. Sanden Blvd.
Conforms to:
ANSI/UL STD 913, ANSI/UL
60079-0, ANSI/UL 60079-11
ANSI/ISA 60079-26
Certified to:
CAN/CSA STD C22.2 No 157
CAN/CSA STD C22.2 No 60079-0
CAN/CSA STD C22.2 No 60079-11
CSA STD C22.2 No 25
0359
21-AV4BO-0137X
Ex ia op is I Ma
Ex ia op is IIC T3 Ga
(-20ºC Tamb +40ºC)
NCC 15.0286 X
CAPACITANCE LIMITATION - INTRINSICALLY SAFE
The capacitance measured on the two magnets and the side clip exceeds 3pF as is
required for a Group IIC rating. The user should consider this fact when deciding to use this
light in their specic application.
WARNINGS - INTRINSICALLY SAFE
y Warning: Use only the approved non-rechargeable batteries listed below.
y Warning: Do NOT attempt to use rechargeable AA batteries with this light.
y Warning: To prevent ignition of a hazardous atmosphere, do not open the lens bezel in
the hazardous environment. This task must ONLY be performed in an area known to be
non-hazardous.
y Warning: When exchanging batteries, use only Duracell PC1500, Energizer EN91 or
Energizer L91 batteries.
y Warning: To prevent ignition of a hazardous atmosphere, the AA batteries must only be
exchanged in an area known to be non-hazardous.
y Warning: To reduce the risk of explosion, do not mix new non-rechargeable batteries
with used non-rechargeable batteries, or mix non-rechargeable batteries from different
manufacturers.
y Warning: Substitution of components may impair intrinsic safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always conrm the rating of any known hazardous or potentially
hazardous location where the light is to be used.
BATTERY INSTALLATION
WARNING: In order to maintain the Intrinsically Safe Permissible rating, the only AA
batteries certied for use with this light are the Duracell PC1500, Energizer EN91 or
Energizer L91 batteries.
y Do not attempt to use any other brand or model of AA batteries with this light.
y Do not attempt to use any type of rechargeable AA batteries with this light.
Warning: To prevent ignition of a hazardous atmosphere, do not remove the lens bezel or
the reector / battery carrier in the hazardous environment. This task must ONLY be done
in an area known to be non-hazardous.
y Loosen the locking screw located on the side of the lens cap (ATEX model only). NOTE:
Do NOT completely remove the screw. It is not necessary and may damage the threads.
Looen enough to allow the lens bezel to unscrew.
y Unscrew the lens bezel from the housing in a counter-clockwise direction.
y Turn the light upside down and carefully shake the light in order to remove the reector /
battery carrier. Allow the reector / battery carrier to slide into your hand. WARNING: Do NOT
touch the reector surface with your nger. Doing so may damage the reector surface.
y Using 3 – AA Duracell PC1500, Energizer EN91 or Energizer L91 batteries (make sure
that all 3 batteries are of the same model), install the batteries in the carrier paying close
attention to the markings on the battery carrier for proper battery terminal polarity alignment.
y Align the reector / battery carrier so that the switches on the carrier are aligned with
the switches on the housing. Carefully insert the reector / battery carrier back into the
ashlight housing until it is fully seated in the housing. WARNING: Be careful to not touch
the reector surface with your nger. Doing so may damage the reector surface.
y Replace the lens bezel by screwing it onto the housing in a clockwise direction.
y Tighten locking screw for ATEX models. CAUTION: Do NOT over-tighten. This may
damage the threads and impact the light’s Intrinsic Safety.
OPERATION
THE XPP-5422 HAS FOUR SEPARATE LIGHTING MODES:
Momentary Flashlight Mode
Lightly press the top body switch for momentary operation. Release the switch to turn
the light off.
Constant-on Flashlight Mode
Press the top body switch until it clicks and then release for constant-on mode. Press
and release the top body switch again to turn the light off.
Floodlight Mode
Press the bottom body switch until it clicks and then release for oodlight mode. Press
and release the bottom body switch again to turn the light off.
Dual-Light Mode
Turn on both the ashlight and the oodlight at the same time. Press the top body switch
to activate the ashlight and press the bottom switch to activate the oodlight. Press and
release both body switches to turn the lights off.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and
materials for the original purchaser’s lifetime. The Limited Lifetime Warranty includes the
LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics and
included accessories are warranted for a period of two years with proof of purchase. Normal
wear and failures which are caused by accidents, misuse, abuse, faulty installation and
lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or tness for
a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco-
productsupport/ warranties. Retain your receipt for proof of purchase.
Mode d’emploi
XPP-5422GMX / XPP-5422GMXA
LA LAMPE DE POCHE A ÉTÉ APPROUVÉE POUR UTILISATION
CAPACITANCE LIMITÉE - SÉCURITÉ INTRINSÈQUE
La capacitance mesurée sur les deux aimants et la pince latérale dépasse 3pF pour le
groupe IIC. L’utilisateur doit déterminer l’équipement qui convient pour l’application.


Produkt Specifikationer

Mærke: NightStick
Kategori: Lommelygte
Model: XPP-5422GMX

Har du brug for hjælp?

Hvis du har brug for hjælp til NightStick XPP-5422GMX stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lommelygte NightStick Manualer

Lommelygte Manualer

Nyeste Lommelygte Manualer

Dedra

Dedra DED7343 Manual

10 November 2025
ArmyTek

ArmyTek Prime C2 Pro Manual

17 Oktober 2025
Coleman

Coleman 2000006663 Manual

12 Oktober 2025
Maglite

Maglite TRM4RE4 Manual

11 Oktober 2025
Milwaukee

Milwaukee M12 ALIP Manual

8 Oktober 2025
Draper

Draper 90033 Manual

1 Oktober 2025