NUVO Clarksville 60/8062 Manual

NUVO Lys Clarksville 60/8062

Læs gratis den danske manual til NUVO Clarksville 60/8062 (2 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 7 anmeldelser. Har du et spørgsmål om NUVO Clarksville 60/8062, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

FOR YOUR SAFETY

WARNING: BE SURE THE ELECTRICITY TO THE WIRES

YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS

REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.

GENERAL

You don’t need special tools to install this xture. Be sure to follow

the steps in the order given. Under no circumstances should a

xture be hung on house electrical wires, nor should a swag type

xture be installed on a ceiling which contains a radiant type heating

system. Read instructions carefully. If you are unclear as to how to

proceed, consult a qualied electrician.

NOTE: Proper wiring is essential for the safe operation of this xture.

FIXTURE ASSEMBLY

Carefully remove the xture from the carton and check that all parts

are included as shown in gure. Be careful not to misplace any of

the screws or parts, which are needed to install this xture.

INSTALLATION

IMPORTANT: Do not attach xture directly to outlet box.

STEP 1: Fasten the mounting bar onto the outlet box with the outlet

box screws.

GROUNDING INSTRUCTIONS

STEP 1: Insert the green grounding screw into the hole with two

raised dimples on the mounting bar. Wrap the ground wire from the

xture (if supplied) around the green grounding screw, then connect it

to ground wire from the outlet box (if not xed on the outlet box) using

a wire connector (not supplied). If ground wire from the xture is not

supplied, wrap the ground wire (if not xed on the outlet box) from the

outlet box around the green grounding screw and tighten it.

NEVER CONNECT GROUND WIRE TO BLACK OR WHITE

POWER SUPPLY WIRES.

STEP 2: Take note of the color of the wire(s) on your xture. Identify

which group your xture wire(s) falls into and connect the wires

according to the directions below:

GROUP A:

Connect to Black House Wire

GROUP B:

Connect to White House Wire

BLACK WHITE

* PARALLEL WIRE (round & smooth) * PARALLEL WIRE (square & ridged)

WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER

BROWN, GOLD OR BLACK

WITHOUT TRACER

BROWN, GOLD OR BLACK

WITH TRACER

NOTE: When parallel wire (SPT-I & SPT-2) is used, the tracer wire is

square shaped or ridged and the less tracer wire is round in shape

or smooth (seen best when viewed from wire end.)

STEP 3: Take your xture wire(s) from group A and place evenly

against the black wire from the outlet box. Do NOT twist wires

together before using wire connectors.

STEP 4: Fit a wire connector over the wires and screw the

connector clockwise until you feel rmness.

STEP 5: Try gently to pull the connector off the wires. If you can

pull the connector off, carefully re-do steps 3 and 4 as above, and

check again for a rm connection.

STEP 6: Connect the xture wire from group B to the white wire

from the outlet box in the same manner. Make sure no bare wires

can be seen outside wire connectors.

FINAL ASSEMBLY

STEP 1: After wires are connected, tuck them carefully inside outlet

box. Place the xture body to the wall by aligning the protruding

mounting screws all the way through the wall plate and x the

mounting screws until the xture body is held rmly against the wall.

STEP 2: Secure the glass to the xture using the socket ring.

STEP 3: Install lamp (not included). Do not exceed the maximum

capacity recommended on the socket.

CLEANING

To clean, wipe xture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

ORDERING PARTS

Keep this sheet for future reference, and in case you need to order

replacement parts. Be sure to use exact wording from illustration

when ordering parts.

Line art shown may not exactly match the xture enclosed. However, the installations

do apply to this xture.

La ilustración puede no concordar exactamente con la pieza enviada. Sin embargo,

las instalaciones sí aplican para esta pieza.

Les images peuvent ne pas correspondre exactement au luminaire de la boîte.

Par contre, les directives d’installation s’appliquent au luminaire.

ITEM NO: 60-8061, 60-8062, 60-8063

ARTÍCULO Nº: 60-8061, 60-8062, 60-8063

ARTICLE N°: 60-8061, 60-8062, 60-8063

INSTALLATION AND SAFETY INSTRUCTIONS

FIGURE

Produkt Specifikationer

Mærke:	NUVO
Kategori:	Lys
Model:	Clarksville 60/8062

Har du brug for hjælp?

Hvis du har brug for hjælp til NUVO Clarksville 60/8062 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lys NUVO Manualer

21 December 2025

21 December 2025

21 December 2025

20 December 2025

20 December 2025

20 December 2025

20 December 2025

16 December 2025

16 December 2025

15 December 2025

Lys Manualer

Nyeste Lys Manualer

Vaxcel CH55606 Manual

25 December 2025

Vaxcel H0198 Manual

25 December 2025

Neolium X8 Manual

25 December 2025

Biltema 27-000 Manual

25 December 2025

Vaxcel P0260 Manual

24 December 2025

Vaxcel PD5024 Manual

24 December 2025

Vaxcel CR-VLU002 Manual

24 December 2025

Biltema 48-540 Manual

24 December 2025

Vaxcel W0375 Manual

24 December 2025

Vaxcel C0279 Manual

24 December 2025