INSTRUCTION Manual D500SR - 4/15/2020
WARNING: When a flammable liquid is sprayed, there may
be danger of fire or explosion especially in a closed room:
keep compressor at least 20 feet away from areas where
hazardous concentrations of flammable vapors are likely to
occur. Disconnect power before servicing.
ATTENTION: Lorsqu'un liquide inflammable est pulverise,
il peut y avoir danger d'incendie ou d'explosion,
specialement dans une piece fermee; garder le
compresseur a au moins 20 pieds des endroits ou des
concentrations dangereuses de vapeurs inflammables
sont susceptibles de se produire. Debrancher avant toute
maintenance.
Manufactured in China for Paasche
D500SR Air Compressors
1/5 HP, 120 Volts, 60 Hz,
47 Db’s. Weight: 8.12 lbs (3.8 kg)
Features:
• Portable & Lightweight
• Low Noise Level
• Thermally Protected
• Steady Air Flow
• Regulator & Moisture
Trap
• Auto Stop and Start
• 1/4” NPT Fittings
• Carrying Handles
Compressor Specs:
• Single Cylinder Piston
• 1/5 HP
• HZ110-120 Volt 60 /
• 0-35 Working Pressure
(Depending on Airbrush)
• 8.3 lbs (3.7kg)
• Dim: 7.75”L 6.5”Hx x 5.5”W
• 6 Foot Electric Cord
This compressor is & both ETL CE Listed
1) ) Connect R-75 Regulator to compressor using
white plumbers tape included.
2) ) Use Plumbers tape on threads to seal any a
leaks when installing airbrush hose.
3) ) Plug compressor into grounded outlet
4) ) Turn on compress
5) ) Lift Black Knob on top of Regulator to adjust air
pressure. Pull “up” on regulator knob, twist clockwise to
increase air pressure.
(Note: press down on airbrush trigger while adjusting air
pressure.)
When you have reached desired air pressure push
“down” on Black knob to lock in setting.
6) ) Ensure the working area is well ventilated
7) Compressor will run when your airbrush is
being triggered
R-R-75 Regulator and moisture
Trap Air Pressure Adjustment.
Operation Instructions: