Qtx MBM-1 Manual

Qtx Lettelse MBM-1

Læs gratis den danske manual til Qtx MBM-1 (2 sider) i kategorien Lettelse. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Qtx MBM-1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

www.avsl.com 153.106UK User manual

MBM-1

Battery Powered Mirror Ball

Motor

Item ref: 153.106 UK

User Manual

Introduction

Thank you for choosing the QTX MBM-1 battery powered mirror ball motor.

This item will provide a convenient solution for small to medium tasks where no mains power is available.

Please read the below instructions to ensure proper implementation and avoid damage through misuse.

www.avsl.com 153.106UK User manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

General safety

The MBM-1 is intended for indoor use only. Keep away from damp or humid environments.

Keep the motor and housing dust free and do not allow particles to enter the mechanism.

Clean the MBM-1 periodically with a dry, lint free cloth. Do not use solvents on the casing.

Keep away from heat sources or direct sunlight.

Installation

The MBM-1 mirror ball motor is powered by a single 1.5V cell (D type) which should be installed before

installation. Open the battery compartment and connect the D cell, ensuring the correct polarity as

indicated.Positioning of the mirror ball motor is very important. Safety is the most important factor. Please

note the following to avoid failure and possible injury…

• The motor and mirror ball should be out of reach to avoid tampering

• The mirror ball should not weight more than 2kg

• The chain holding the mirror ball should be adequate for the load

• The fixing into the ceiling must be strong enough to hold both mirror ball and motor

Operation

To start the motor rotation, slide the side-mounted switch to the on position. The spindle will rotate and

so the mirror ball will rotate also. The MBM-1 is hinged to allow some sideways movement if the load is

not perfectly symmetrical. Remember to switch off when not needed to preserve the battery. If not being

used for long periods, remove the battery and store in a dry place.

Battery

1.5V (1 x D) not supplied

Max. weight load

2kg

Rotation per minute

6rpm

Dimensions

180 x 50mmØ

Weight

130g

This product is classed as Electrical or Electronic equipment and should not be disposed with other household or

commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.

Errors and omissions excepted.

Taylor Road, Trafford Park, Manchester. M41 7JQ. North Point Bus. Park, New Mallow Road, Cork, Ireland.

Produkt Specifikationer

Mærke:	Qtx
Kategori:	Lettelse
Model:	MBM-1

Har du brug for hjælp?

Hvis du har brug for hjælp til Qtx MBM-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lettelse Qtx Manualer

Qtx Recharge Performer Manual

25 August 2024

Qtx TetraCube Manual

25 August 2024

Qtx BATPAR-18W Manual

25 August 2024

Qtx TinyMover Manual

25 August 2024

Qtx Recharge DJ Manual

25 August 2024

Qtx Multi-Bar Manual

25 August 2024

Qtx SpectraWash Manual

25 August 2024

Qtx DP4 Manual

16 August 2024

Qtx MBM-1 Manual

15 August 2024

Qtx PAR10-RGBW Manual

9 August 2024

Lettelse Manualer

Nyeste Lettelse Manualer

Dainolite V166-1W Manual

5 April 2025

Dainolite OFE-161P Manual

5 April 2025

Dainolite DMLED10-A-5D Manual

5 April 2025

Dainolite DM1958F Manual

5 April 2025

NUVO Ballerina 60/1265 Manual

4 April 2025

NUVO SF77/196 Manual

4 April 2025

NUVO Ballerina 60/329 Manual

4 April 2025

NUVO Cordello 60/7883 Manual

4 April 2025

NUVO Destin 60/7706 Manual

4 April 2025

NUVO Livingston 60/7669 Manual

4 April 2025