Sanyo LNS-S04 Manual

Sanyo Tilbehør til projektor LNS-S04

Læs gratis den danske manual til Sanyo LNS-S04 (6 sider) i kategorien Tilbehør til projektor. Denne vejledning er vurderet som hjælpsom af 47 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 24 anmeldelser. Har du et spørgsmål om Sanyo LNS-S04, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

LCD PROJECTOR LENS

MODEL NO. LNS-S04/LNS-M02

LENS REPLACEMENT

AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of

cabinet. Before installing or replacing the lens, make sure the type of cabinet and be

sure to refer to the Installations corresponding with your projector.

When installing or replacing the lens, make sure the Lens Model No. matches with

your projector. Refer to the catalog, or contact your sales dealer for the proper Lens

Model No.

TYPE OF THE CABINET AND INSTALLATION PROCEDURES

Refer to the Installation procedure corresponding to your projector and install the lens

correctly. (See the chart below.)

1AA6P1P5925-- (IFTT)

※ For use the other models (other than above cabinet), contact your sales dealer.

Printed in Japan

Some parts are not used for installation or replacement. Keep these parts for later use.

Note : Figures in this manual may be differ from the actual product.

After installing or replacing the lens, be sure to check the following for safety.

1. Check the lens is securely fixed.

2. Check no part is missing, or no mounting part is loose.

BE SURE TO CHECK FOR SAFETY

-1-

LIST OF CONTENTS

Following parts are included in the packing.

• LENS 1 pc.

• LENS CAP Front and rear (Each 1 pc.)

• SCREW DRIVER 1 pc.

• INSTALLATION MANUAL 1 pc.

Lens installation and replacement should be performed by the qualified

service personnel.

It should be followed by this procedure precisely.

Before attempt to replace the lens, confirm the model number (both the

LCD projector and the lens) and use the proper lens.

The lens cover is on the lens for protection. Be sure to remove the lens

cover before installation.

When installing or removing the lens, be careful not to stain, scratch or

damage the lens.

When shipping the projector with the lens, remove the lens before shipping

the projector.

If you have any questions, contact the dealers.

Notes on Lens Installation and Replacement

●

Produkt Specifikationer

Mærke:	Sanyo
Kategori:	Tilbehør til projektor
Model:	LNS-S04
Vægt:	2600 g
Produktfarve:	Sort
Diameter:	140 mm
Kapabilitet:	PLC-HF10000L\nPLC-HF15000L\nPLC-XF1000\nPLC-XF47\nPLC-XF47A
Brændviddeområde:	76 - 98 mm
Blændeområde (F-F):	2 - 2.6
Zoomforhold:	1.3x