Sightron S6 1-6x24 Manual

Sightron Kikkert S6 1-6x24

Læs gratis den danske manual til Sightron S6 1-6x24 (2 sider) i kategorien Kikkert. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Sightron S6 1-6x24, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Introduction to Sightron

Ocular Lens

Diopter Ad sting Ringju

Elevation Adjusting Knob

Windage

Adjusting Knob

Battery Cap R2032)(C

Illumination

Adjusting Knob

Objective Lens

Your New S6 Riflescope

Focusing your Riflescope



Mounting your Riflescope

Sighting in Your Gun

Using your Illuminated Reticle

First Shot

First Adjustment

Adjust

reticle

to this

point

Resetting your Windage and

Elevation Turrets

Battery Cap R2032)(C

Illumination Switch



Power Ring Lever (Removeable)

CAUTION: ALWAYS ENSURE YOUR

WEAPON IS UNLOADED PRIOR TO MOUNTING

YOUR SCOPE.

USE EYE AND HEARING PROTECTION AND

FOLLOW PROPER SAFETY RULES WHEN

HANDLING OR FIRING YOUR WEAPON.

Place both rings on your mount base or

receiver,

and tighten.

Remove the top half of the rings and place the

riflescope in the bottom half of the rings.

Once you have determined proper ring spacing

and eye relief, align the reticle with a vertical

line preferably a plumb line.

Tighten the top half of the rings to between

15 to 18 inch pounds or

169 to 203 Newton

Centimeters and adjust the

diopter or eye

piece focus so the reticle is crisp

and clear.

Note: The only purpose of the diopter is to

focus the reticle sharp and clear.

To install the illumination battery, remove the

battery cap located at the Illumination switch

rotating it counterclockwise.

Insert the CR2032 battery with the positive side

up and retighten finger tight.

Rotate the illumination switch to the required

setting for the lighting conditions.

Your new scope has been optically centered at

the

factory and superior performance will be

obtained

with minimal adjustment.

Prior to sighting in your scope it is important to

know the windage and elevation adjustment

specifications of your particular scope model.

A general rule is the more the magnification the

less internal adjustment is available.

Once you have completed the eyepiece /

diopter

adjustment, your scope is adjusted and

ready for shooting.

Congratulations on the purchase of your new

Sightron S6 Series Riflescope.

Sightron is a leader in developing new products

for the outdoor enthusiast.

This instruction sheet is designed to provide you

with the proper fundamentals for using your S6

Series Riflescope.

If you have any questions, please feel free to

www.sightron.com, or by phone at

+1-919-562-3000.

Before mounting your new Sightron S6 1-6x24

Series

Scope please check to make sure it is

the correct

model and includes the following

accessories:

1-2.0 MM Allen wrench

1-Lens Cloth

1-Instruction Sheet

1-CR2032 Battery for the illumination Switch

1-Reticle Chart (LRT Only)

1. Place a 2 to 3 foot target at 50 to 100 yards

away. Using a bench rest, fire two shots while

aiming at the center of the bullseye.

While re-aiming at the bullseye adjust the reticle

to the bullets impact point by using the turret

adjustments and fire two more shots.

Your scope should now be close to point of aim.

Fire at the bullseye and make the necessary

final adjustments.

4. Adjusting the windage and elevation turret in

the direction of the arrow on the knob, it will

move the bullet impact in the direction indicated.

5. For best optical and mechanical performance

keep the windage and elevation travel as

centered as possible to allow for maximum

adjustment range for your model of riflescope.

Note: Most sight in problems are caused by

poor ring alignment.

Once your scope is sighted in for the required

distance loosen the 2.0 MM hex screw. Remove

the turret and re-install so the zero aligns with

vertical index mark on the scale under the turret.

Retighten to 4 inch pound or 45 N-CM.

Note:The turret is splined and must be removed

to reset the turret to zero.

S6 1-6x24 SERIES

RIFLESCOPE

INSTRUCTIONS

Produkt Specifikationer

Mærke:	Sightron
Kategori:	Kikkert
Model:	S6 1-6x24

Har du brug for hjælp?

Hvis du har brug for hjælp til Sightron S6 1-6x24 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Kikkert Sightron Manualer

Sightron SI 10x25 Manual

7 November 2025

Sightron S6 1-6x24 Manual

6 Juli 2025

Kikkert Manualer

Nyeste Kikkert Manualer

Nikon Prostaff P3 8x30 Manual

30 December 2026

Nikon Prostaff P3 10x42 Manual

19 December 2025

Nikon PROSTAFF P3 10X30 Manual

19 December 2025

Nedis SCBI4000BK Manual

9 December 2025

Steiner R1X Manual

4 December 2025

Luna Optics LN-ELIR-3 Manual

2 December 2025

Luna Optics STARGAZER-QD Manual

2 December 2025

CamLink CSP50 Manual

27 November 2025

CamLink HOBBY821BLU Manual

27 November 2025

CamLink CL-OAKHAM1042 Manual

26 November 2025