Silva Schneider Cross Trail 3X Manual

Silva Schneider Lommelygte Cross Trail 3X

Læs gratis den danske manual til Silva Schneider Cross Trail 3X (1 sider) i kategorien Lommelygte. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Silva Schneider Cross Trail 3X, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Visit: www.silva.se

for more information about the

Waste Electrical and Electronic

Equipment (WEEE) Directive.

Thank you for choosing Silva Cross Trail 3X headlamp. This headlamp can, thanks to the

modular design, also be used on a helmet or on a bike handle bar.

Cross Trail 3 and 3X are our first lamps featuring Flow light

- a technology that lets you

control the light beam by tilting the lamp vertically and varies the light pattern infinitely

depending on where you aim the light. Thus the lamp is adaptable for slow or fast activities.

PRODUCT OVERVIEW

The Cross Trail 3X headlamp packaging consists of the following parts:

• Headlamp body

• Headband

• Helmet bracket with adhesive strip

• Bike bracket

• Extension cable with helmet strap

• Cable holder

• USB charge cable

• Li-Po battery in rubber skin

• Battery case with attachment strap

• Quick guide

BEFORE USE

BATTERY CHARGING

The battery needs to be charged before first use.

1. Disconnect headlamp from Battery

2. Open the rubber lid on the battery pack side and insert the micro USB connector on charge

cable.

3. Insert the USB connector in a USB-port

4. On the battery there is an LED showing the battery status during charging:

- Red light = battery is charging

- Green light = battery is fully charged

Battery charging time is approximately 4 hours.

Note! When the battery is fully charged the battery automatically switches off charging. How-

ever, never leave the battery connected to a USB-port unattended for longer periods.

ADJUST THE HEADBAND

The elastic headband is designed to give a comfortable fit at speed during activities such as run-

ning, XC skiing etc. Adjust the headband by moving the sliding buckle to fit it onto your head.

FLEXIBLE BATTERY CARRYING

The battery pack can be carried in multiple ways; for example on the head band, in a pocket,

backpack, on the waist or mounted on the bike frame by using the soft case with the integrated

strap.

MODULAR SYSTEM

In order to move the headlamp body from the headband to either the helmet bracket or the bike

bracket, gently push the lamp upward relative the head plate with head band. Insert the head-

lamp body in the new bracket and gently press it down until you hear a click sound.

MOUNTING THE HELMET BRACKET

The helmet bracket comes with pre mounted adhesive on the back for easy mounting on any

helmet. The adhesive is a polyethylene foam tape developed to not damage or cause any type of

weakness to the plastic in your helmet.

Before mounting the helmet bracket on a helmet, make sure the surface is dry and clean. Remove

the protective paper from the adhesive tape on the helmet bracket. Gently press the helmet

bracket to the helmet.

Depending on helmet type, it might be preferable to use the 4th light mode (Helmet mode – Flow

light deactivated), when the Cross Trail 3X is used on a helmet.

With Flow light deactivated you can tilt the lamp in a preferable position without affecting the light

beam.

MOUNTING THE BIKE BRACKET

The bike handlebar bracket is developed for use on bike handlebars with a dimension between

25 and 32 mm.

DURING USE

FLOW LIGHT

The Cross Trail 3X headlamp is equipped with Flow Light

which is a light distribution technolo-

gy that combines a wide angle flood light with a long reach spot light. If you aim the light beam of

the Cross trail 3X close to your feet by rotating the lamp body downward, the light beam will be

a wide flood light adapted for slower activities. If you aim the light higher up, further away, the

light beam will gradually transform into a long distance spot beam, perfect for higher speed.

This unique feature gives the user peripheral or long distance vision depending on the activity or

speed. For a runner, cross country skier, mountain biker or night orienteer this translates into

less head movement, increased control, better balance and more speed.

SWITCH ON YOUR HEADLAMP

On the side of the headlamp body there is a push button which controls all light modes.

Each press on the button gives you the following light:

1. Turns the headlamp ON with all LEDs in maximum power

2. Med mode

3. Min mode

4. Max mode with Flow light deactivated (helmet mode)

5. Blink

6. Starts over from 1 – Max mode

To turn OFF the headlamp; press and hold the button for 2 seconds.

TEMP CONTROL

The headlamp temperature will increase during use. The headlamp temperature is mainly

depending on light mode, ambient temperature and the airflow (speed). The Cross Trail 3X

headlamp is equipped with a temperature control function which prevents the headlamp body

from overheating by reducing the power to the LEDs. This means that the lower the ambient

temperature, the stronger the light output.

Note: Always make sure that the batteries are disconnected when the headlamp is stored in a

closed compartment such as a bag, pocket or similar.

BATTERY INDICATION

When the headlamp is turned off a small LED is turned on inside the front of the headlamp to

indicate the status of the batteries. The battery status indication LED will be on for 5 seconds

after power off.

Green light – Battery in good condition (more than ~70% remaining)

Red – Battery in poor condition (less than ~30% remaining)

LOW BATTERY WARNING

During operation of the headlamp there will be a low battery warning when 25-30% of the bat-

tery energy remains. This is done by flashing both LEDs for 1 second and repeated again after

5 seconds.

AFTER USE

MAINTENANCE

To make sure you get maximum performance from your Cross Trail 3X headlamp, clean it

regularly with a damp cloth.

Headset cleaning – wash in washing machine at 40 ºC.

ABOUT LI-ION (LI-PO) BATTERIES

• The battery should be stored in a dry environment within the temperature range of -20 ºC -

+35 °C.

• If you would like to store your battery for a longer period (more than 30 days) the battery

should 50%charged.

• Li-ion batteries have a discharge rate of approx. 20% over a 30 day period.

• Do not expose the battery for extreme temperatures which may cause fire or explosion.

• Do not disassemble or mistreat the battery, risk for chemical burn.

• Keep away from children.

• Do not submerge the batteries in water.

• Do not short circuit the contacts.

• Replace only with Silva battery.

Note! Always make sure to disconnect the battery when the headlamp is not used.

TECHNICAL SPECIFICATIONS

Weight: headlamp (excluding battery): 70g

Weight: battery 75g

Battery type: Li-ion 7.4V 900mAh

Light distance (Max/Med/Min): 120m/70m/50m

Lumen (Max, Med, Min): 400, 200, 100 Lumen

Burn time: (Max/Med/Min): 2h/4h/6h

Water resistance: IPX6

Material head lamp body: PC/ABS and Aluminium

Operative temperature range: -10º - +55 ºC

Storage temperature range: -20 - +35 ºC

Art No: 37537

PROTECT THE ENVIRONMENT.

Headlamp and batteries should be recycled and must not be thrown in the regular trash. Dispose

these items in accordance with applicable local regulations.

WARRANTY

Silva warrants that, for a period of two (2) years, your Silva Product will be substantially free of

defects in materials and workmanship under normal use. Silva’s liability under this warranty is

limited to repairing or replacing the product. This limited warranty extends only to the original

purchaser.

If the Product proves defective during the Warranty Period please contact the original place

of purchase. Make sure to have your proof of purchase on hand when returning the product.

Returns cannot be processed without the original proof of purchase. This warranty does not

apply if the Product has been altered, not been installed, operated, repaired, or maintained in

accordance with instructions supplied by Silva, or has been subjected to abnormal physical or

electrical stress, misuse, negligence or accident. Neither does the warranty cover normal wear

and tear. Silva is not responsible for any consequences, direct or indirect, or damage resultant

from use of this product. In no event will Silva’s liability exceed the amount paid by you for the

product. Some jurisdictions do not allow the exclusion or limitation of incidental or consequen-

tial damages, so the above limitation or exclusion may not apply to you. This Warranty is valid

and may be processed only in the country of purchase.

For more information please visit www.silva.se

FULL VERSION MANUAL

CROSS TRAIL 3X

Art. No 37537

Produkt Specifikationer

Mærke:	Silva Schneider
Kategori:	Lommelygte
Model:	Cross Trail 3X
Kode for international beskyttelse (IP):	IPX6
Antal effektniveauer:	4
Bredde:	30 mm
Dybde:	47 mm
Højde:	27 mm
Vægt:	145 g
Antal pr. pakke:	1 stk
Brugervejledning:	Ja
Produktfarve:	Black, Grey
Batterikapacitet:	900 mAh
Batteriteknologi:	Lithium polymer (LiPo)
Husmateriale:	Acrylonitrile butadiene styrene (ABS), Aluminium
Vandfast:	Ja
Indikator for batteriniveau:	Ja
Kabler inkluderet:	USB
Batterier inkluderet:	Ja
Batterilevetid (maks.):	100 t
Batteritype:	Indbygget
Antal understøttede batterier:	1
Antal lamper:	- Lampe( r)
Opladningstid for batteri:	4 t
Numre af batterier medfølger:	1 stk
Opladningskilde:	USB
Lommelygte type:	Hovedbånd lommelygte
Lysstråle afstand (maks.):	120 m
Lys output (maks.):	400 lm
USB oplader inkluderet:	Ja
Lys output (min.):	100 lm