2
EN - Manual
This manual provides instrucons for assembling and maintaining your new SJOEF
bicycle. Before assembling the bicycle, it is important to follow these steps.
• Remove the bicycle from the packaging and place all the parts together. Be
careful not to leave any parts inside the packaging.
• Check that all parts are present
• Assembly is intended for adults only
Tip: Are you having trouble with the assembly? Then please contact our customer
service.
The bicycles are manufactured to comply with European standards EN ISO-
8098:2014 or EN ISO-4210:2014. Please note: the manufacturer is not responsi-
ble for improper use or incorrect assembly of the bicycle.
Assembly
The bicycle can be assembled in a few simple steps. It is important to follow the
order of the instrucons in order to make the assembly as easy as possible.
Installaon of the saddle
1. Insert the saddle pillar into the seatpost.
2. Adjust the saddle to the correct height. Observe the safety mark on the
saddle pillar, which should disappear into the frame. The saddle is at the right
height when your toes touch the ground while standing sll. If possible, the
saddle should be adjusted so that the enre foot is on the ground.
3. Is the saddle at the right height? Lock the saddle by ghtening the saddle
bolt.
Installing the handlebar and stem (if required)
1. Insert the stem (including handbrake lever and bell if present) into the frame.
2. Observe the safety marking on the stem, it should disappear into the frame.
3. Posion the handlebar at the desired height and check whether it is perpen-
dicular to the front wheel.
4. Tighten the handlebar clamp and/or bolt.
Installing the pedals
PLEASE NOTE: there is an (L) on the le and an (R) on the right side of the pedal.
Incorrectly ghtening the pedal will render the bike unusable and will void the
warranty.