2
EN - Manual
This manual provides instrucons for assembling and maintaining your new SJOEF
bicycle. Before assembling the bicycle, it is important to follow these steps. As-
sembly is intended for adults only
• Remove the bicycle from the packaging and remove the packaging materials.
The bicycles are manufactured to comply with the European standards EN
ISO-8098:2014 (maximum saddle height from 435mm to 635mm) or EN ISO-
4210:2014 (minimum saddle height of 635mm). Please note: the manufacturer is
not responsible for improper use or incorrect assembly of the bicycle. Please verify
with the local authories which regulaons apply to the use of children’s bicycles
on public roads. Ensure compliance with these rules at all mes. Always inspect
the surface of the terrain where the bicycle will be ridden and make sure that a
parent/guardian is always supervising the child during use. Improper use of the
bicycle can result in hazardous situaons.
Ensure that the child is always given clear instrucons on the use and dangers
associated with using the bicycle. In parcular, the use of the brakes should be
clearly explained.
Assembly
The bicycle can be assembled in a few simple steps. It is important to follow the
order of the instrucons in order to make the assembly as easy as possible.
Mounng the saddle
1. Aach the saddle post to the seat tube. Pay aenon to the safety mark
on the saddle post, which must not be exceeded. The maximum height is
reached when the safety mark is visible. The minimum height is reached when
the saddle bolt is completely loosened.
2. The saddle is at the correct height when your child can just touch the ground
on both sides of the bike. Preferably, the heel also touches the ground.
3. Tighten the saddle bolt to the desired height.
Installing the handlebar and stem (if required)
1. Aach the cone to the stem by ghtening the bolt (if necessary).
2. Insert the stem (including handbrake lever) into the frame.
3. Posion the handlebar at the desired height and check whether it is perpen-
dicular to the front wheel.
4. Tighten the handlebar clamp and/or bolt.
5. Mount the bell on the le side of the steer next to the grip.
