2
EN - Manual
This manual provides instrucons for assembling and maintaining your new SJOEF
bicycle. Before assembling the bicycle, it is important to follow these steps. As-
sembly is intended for adults only
• Remove the bicycle from the packaging and remove the packaging materials.
The bicycles are manufactured to comply with European standards EN ISO-
8098:2014 or EN ISO-4210:2014. Please note: the manufacturer is not responsi-
ble for improper use or incorrect assembly of the bicycle.
Assembly
The bicycle can be assembled in a few simple steps. It is important to follow the
order of the instrucons in order to make the assembly as easy as possible.
Installing the handlebar and stem (if required)
1. Aach the cone to the stem by ghtening the bolt (if necessary).
2. Insert the stem (including handbrake lever) into the frame.
3. Posion the handlebar at the desired height and check whether it is perpen-
dicular to the front wheel.
4. Tighten the handlebar clamp and/or bolt.
5. Mount the bell on the le side of the steer next to the grip.
Installing the pedals
PLEASE NOTE: there is an (L) on the le and an (R) on the right side of the pedal.
Incorrectly ghtening the pedal will render the bike unusable and will void the
warranty.
1. It is advisable to grease the ends of the pedals so that they can be replaced
easily in the future.
2. An L or R can be read o from the axle of the pedal. Use this to check which
pedal should be ed on the le and which on the right. Are there no L or R
on the pedals? Then the le pedal contains a marking in the form of a line.
(le or right is viewed from the sing posion on the bicycle).
3. Insert the right pedal into the crank and turn the pedal clockwise by hand
towards the front wheel. It should be easy to turn the pedal; if it is s, the
thread may be damaged.
4. Then turn the le pedal by hand counter-clockwise into the crank, also in the
direcon of the front wheel.
5. Finally, ghten the pedals even further using an open-end spanner.
