Synco G2 Pro Manual

Synco Mikrofon G2 Pro

Læs gratis den danske manual til Synco G2 Pro (2 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Synco G2 Pro, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
RX Receiver x1 TX Transmitter x1 Carring & Charging Box x1
Type-C to Type-C Cable x1
External Lav Mic (With Wind Mu󽗈) x1
3.5mm TRRS Phone Cable x1
3.5mm TRS Camera Cable x1
1. Power On/ O󽗈
Power On
Method 1: The TX and RX automatically turn on after taken out from the
charging Case.
power button for 3 seconds, and the display screen lights up.
Power O󽗈
Method 1: After put the transmitter/receiver into the charging box, the
display screen shows [charging] and enters automatic charging. After fully
charged, the display screen goes out and automatically power o󽗈.
Method 2:The TX and RX automatically turn o󽗈 when long press the
power button for 3 seconds, and the display screen lights o󽗈.
2. Pairing
Automatic Pairing
Automatically pairing after the TX/RX turns on when taken out from the
charging case.
Manual Pairing
① Long press the transmitter and receiver at the same time for 3 seconds
to power o󽗈 .
② After shutdown, long press the power button of the transmitter and
receiver for 8 seconds at the same time to enter the [connecting ] state.
1. TX Transmitter
2. RX Receiver
3. Carrying & Charging Case
① External Mic Input
② Type-C Charging Port
③ On/ O󽗈 Button
④ Built-in Mic
⑤ Display Screen
① Type-C Charging Port / Digital Output
② On/ O󽗈 Button (Mono / Stereo / Safety Channel)
③ 3.5mm TRS Output
④ 3.5mm Monitoring Port
⑤ Display Screen
⑥ Gain Adjustment of TX A
⑦ Gain Adjustment of TX B
⑧ Magnet Pocket Clip
⑨ Contacts
① Contacts
Caring For Your SYNCO Product Product Instruction Operations
Package List
· Please keep the product in a dry, clean, dust-free environment.
· Keep corrosive chemicals, liquids and heat source away from the
product to prevent mechanics damage.
· Use only a soft and dry cloth for cleaning the product.
· Malfunction may be caused by dropping, impact of external force.
· Do not attempt to disassemble the product. Doing so voids warranty.
· Please have the product checked or repaired by authorized technicians
if any malfunctions happened.
· Failure to follow all the instructions may result in mechanics damage.
· Warranty does not apply to human errors.
Microphone G2A1 Pro
User Manual
Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions
mentioned herein.
⑥ Noise Reduction
⑦ Gain Adjustment of TX
⑧ Magnet Pocket Clip
⑨ Contacts
② Power Indicator ③ Type-C Port
4. Display Screen
Recording
TX A
Gain of A TX
Audio Dynamic
Display of A TX
Noise Reduction on
TX Transmitter
RX Receiver
Muting
Recording Mode:
Mono/ Stereo/ Safety
Disconnected
Connecting
Connected
Audio Dynamic
Display
Power Indicator
TX B
Gain of B TX
Audio Dynamic
Display of TX B
Power Indicator
Disconnected Connecting
Connected
③ Successfully Connected show as the picture
*Note: Before successful connection, the transmitter channel displays
A by default. The transmitter connected to the receiver 󽗉rst is the
transmitter A, and the later one is the transmitter B.
*Note: When using an external microphone, please insert it correctly
into the microphone input jack. Only TRS interface microphones are
supported.
3. Channel output connection
① 3.5mm OUT output
The receiver outputs the audio signal to the recording device via either a
3.5mm TRRS phone cable or a 3.5mm TRS camera cable. Please use the
appropriate cable according to your device.
Apple Adapter (With MFI Certi󽗉cation)
3.5mm TRRS Phone Cable
3.5mm TRS Camera Cable
② Type-C port digital output
The receiver Type-C port has a digital output function, which can directly
use the Type-C to Type-C cable to output mobile phones or computers
and other devices.
Mic Windshield x1
Type-C to USB-A Adapter X1
User Manual X1
Magnet x1
Wireless Transmission
RF Frequency Band
Working Distance
Mounting
Audio Input
Power Requirements
Battery Type
Battery Charging Time
Battery Life
Display Screen
Dimensions
Wireless Transmission
RF Frequency Band
Working Distance
Latency
Mounting
Number of Audio Channels
Audio Output
Volume Adjustment
Power Requirements
Battery Type
Battery Charging Time
Battery Life
Display Screen
Dimensions
Material
Weight
Form Factor
Frequency Range
Sensitivity
Maximum SPL
Battery Type
Battery Charging Time
Charging Port
Power Requirement
Dimension
Weight
Digital 2.4GHz
2400-2483.5MHz
656ft/200m (LOS area), 164ft/50m (NLOS area)
Pocket Clip
3.5 mm TRS Mic Input
5V 1A
Built-in Lithium Battery, 400mAh
2H
8H
TFT Screen
52X42X17mm
Digital 2.4GHz
2400-2483.5MHz
656ft/200m (LOS area)
164ft/50m (NLOS area)
20ms
Pocket Clip
2
3.5 mm TRS Mic Output
3.5 mm TRS Headphone Output
Type-C Output
6 levels (0-3-6-9-12-15)/(0~30dB)
5V 1A
Built-in Lithium Battery, 400mAh
2H
8H
TFT Screen
52X42X17mm
ABS
39g
Built-in/External Mic
50Hz-20KHz
-35dB（±3dB，re 1V/Pa at 1 KHz）
120dB SPL（at 1KHz）
3400mAh
3.5H
Type-c
5V 1A
170*80*50mm
227g
TX Transmitter
RX Receiver
Microphone
Charging Case
4. Real-time monitoring
The 3.5mm monitoring port of the receiver supports digital monitoring,
which can simultaneously monitor the sound source of the transmitter
and the input sound source of the device.
5. Volume Control
① Press the power button on the TX to turn on/o󽗈 the mute.
② Short press the gain adjustment button of the TX to adjust the volume
for 6 levels (0-3-6-9-12-15).
③ Short press the gain adjustment of A/B TX buttons on the RX to adjust
the volume of A/B TX.
6. Noise Cancellation
Short press the noise cancellation button on the transmitter to switch
between noise-control modes:
① Noise Cancellation O󽗈
② Low-Level Noise Cancellation
③ High-Level Noise Cancellation
7. Switch the Channel Mode
Short press the power button on the RX to switch the mono/stereo/safety
channel mode.
Default mono mode.
8. Charging
① Connect the charging cable through the Type-C port to charge the
charging case, and fully charged about 3.5 hours.
② The TX/RX: Automatically charge through the contact point of the
charging case after put into the charging case.
③ Connect the charging cable through the Type-C port of the receiver and
the transmitter, and fully charged in about 2 hours.
9. Mic Windshield & Device Installation
10. Setting The Recording Level Correctly
3.5mm Monitoring Jack
Headphone Impedance: under 100 Ω
TX RX
Camera devices generally have poor-quality, noisy preamps. In order to
get the cleanest signals possible, it is highly recommended that you set
the recording level on your camera quite low, 1/2 or 1/3 of it.
G2 provides variable gain control, allowing you to tailor your levels to just
about environment and recording device.
Adjust the recording level of inbuilt mics for SONY Camera
(Take A7S Ⅱ for example)
Adjust the recording level of inbuilt mics for Canon Camera
(Take EOS 5D Mark Ⅳ for example)
Adjust the recording level of inbuilt mics for Panasonic Camera
(Take LUMIX GH5 for example)
Speci󽗉cations
*Please register your warranty. Meanwhile, you are welcomed to contact us via Email：
support@syncoaudio.com
Guangzhou Zhiying Technology Co., Ltd
Room 2401, 24 / F, South Tower, Lisheng Plaza, No. 68 Huadi Avenue, Liwan District,
Guangzhou, China, 510000
support@syncoaudio.com
www.syncoaudio.cn
Warranty Period
Warranty Exclusions and Limitations
Warranty Claim Procedure
Thank you for purchasing SYNCO products.
1. Customers are entitled to free replacement or repair service in case of
quality defect(s) found in the product under normal use within 30 days
upon receipt of the product.
2. Original SYNCO products are entitled to 12-month limited warranty
service. The warranty period begins on the date of purchase of brand new,
unused products by the 󽗉rst end-user.
Within the warranty period, if product defect or failure is attributable to
material defection or technological problem, the defective product or
defective part will be repaired or replaced without charge (service and
materials fee).
Faults resulted from inappropriate use of a product without following its
operation speci󽗉cation：
1. Arti󽗉cial damage, e.g. crash, squeeze, scratch, or soaking
2. Modi󽗉cations to a product by its user or a third party without prior
written consent of SYNCO, e.g. replacement of element or circuit, label
alteration
3. The code on product is inconsistent with that of warranty certi󽗉cate, or
the code on the product or warranty certi󽗉cate is altered or torn o󽗈
4. All consumable accessory attached to a product, like cable, wind mu󽗈,
battery
5. Faults as a result of force majeure, such as 󽗉re, 󽗊ood, lightning, etc.
1. If failure or any problem occurs to your product after purchase, please
contact a local agent for assistance, or you can always contact SYNCO’s
customer service through email at support@syncoaudio.com.
2. Please retain your sales receipt and warranty certi󽗉cate as proof of
purchase. If any of these documents is missing, only sales return or
chargeable service will be provided.
3. If the SYNCO product is out of the warranty coverage, the service and
the parts cost will be charged.
Warranty
*Note: When connecting the computer, enter the sound Settings and
set the input microphone to SYNCO G2Pro to use G2 recording; Set the
output speaker to SYNCO G2 Pro to use real-time ear return in the receiver
listening interface.
Product Model:
Date of Purchase:
Serial Number:
Malfunction Description :
Buyer Name:
Buyer Telephone :
Buyer Mail :
Buyer Address :
Dealer :
Dealer Telephone :
Delivery Date :
Cause of Malfunction :
Maintenance Personnel :
Malfunction Processing :
WARRANTY CERTIFICATE
Material
Weight
ABS
39g
Noise Cancellation O󽗈High-Level Noise
Cancellation
Low-Level Noise
Cancellation

Produkt Specifikationer

Mærke: Synco
Kategori: Mikrofon
Model: G2 Pro

Har du brug for hjælp?

Hvis du har brug for hjælp til Synco G2 Pro stil et spørgsmål nedenfor, og andre brugere vil svare dig


Mikrofon Synco Manualer

Synco

Synco G2 Pro Manual

23 Juni 2025
Synco

Synco LAV-S6P Manual

29 Marts 2025
Synco

Synco WAir-G2-A1 Manual

25 Februar 2025
Synco

Synco WAir-G2-A2 Manual

28 December 2024
Synco

Synco CMic-V1M Manual

22 August 2024
Synco

Synco Mic-M3 Manual

22 August 2024
Synco

Synco Vlogger Kit 1 Manual

22 August 2024
Synco

Synco Vlogger Kit 2 Manual

22 August 2024
Synco

Synco MIC-D2 Manual

21 August 2024
Synco

Synco Cmic-V10 Manual

20 August 2024

Mikrofon Manualer

Nyeste Mikrofon Manualer

MELONARE

MELONARE MWM-400 Manual

23 Juni 2025
XIAOKOA

XIAOKOA U12A Manual

23 Juni 2025
Phenyx Pro

Phenyx Pro PTV-1 Manual

23 Juni 2025
CMTECK

CMTECK CM-G17006P Manual

23 Juni 2025
MEINIAO

MEINIAO A2 Manual

23 Juni 2025
Rythflo

Rythflo RY-LM02 Manual

23 Juni 2025
Tonor

Tonor TW350 Manual

23 Juni 2025
7RYMS

7RYMS iRay DW20 Manual

23 Juni 2025
Phenyx Pro

Phenyx Pro PTU-5200 Manual

23 Juni 2025
Cooyinka

Cooyinka TW110 Manual

23 Juni 2025