TOA WTU-4800 Manual

TOA Modtager WTU-4800

Læs gratis den danske manual til TOA WTU-4800 (4 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om TOA WTU-4800, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully

before use.

• Make sure to observe the instructions in this manual as

the conventions of safety symbols and messages

regarded as very important precautions are included.

• We also recommend you keep this instruction manual

handy for future reference.

When Installing the Unit

• Do not expose the unit to rain or an environment where it

may be splashed by water or other liquids, as doing so

may result in fire or electric shock.

• The equipment shall be fed from a power supply which is

in compliance with requirements of SELV circuit on the

EN60950 standard.

When Installing the Unit

• Do not mount the module in equipment other than those

designated. It is identical to the WTU-860 and WTU-870

wireless tuner modules in shape. However, since its pin

arrangement differs, it does not operate correctly when

mounted in the tuner (such as the WT-860 and WT-870)

other than those designated. This could also cause

failures to the tuner in which the unit is mounted.

Please follow the instructions in this manual to obtain the optimum results from this unit.

We also recommend that you keep this manual handy for future reference.

WTU-4800WIRELESS TUNER MODULE

INSTRUCTION MANUAL

Power Requirement 7 – 12 V DC

Current Consumption 100 mA

Receiving Frequency 576 – 865 MHz

(576 – 606 MHz and 614 – 698 MHz for

USA/Canada)

Receiving System Double superheterodyne

Receiving Sensitivity Better than 80 dB, S/N ratio (20 dB V input, 40 kHz deviation)μ

Antenna Input Impedance 75 Ω

Diversity System Space diversity

Channel 16 channels selectable

Squelch System Noise SQ

Squelch Sensitivity 17 dBμV

Output 0 dB* (maximum deviation, 2.2 kΩload)

Harmonic Distortion Less than 1%

Frequency Response

100 Hz – 12 kHz

, ±3 dB

Operating Temperature –10 to +50°C

Operating Humidity 30 % to 85 %RH

Finish Steel

Dimensions 60 (w) x 25 (h) x 139 (d) mm

Note : The design and specifications are subject to change without notice for improvement.

* 0 dB = 1 V

2. GENERAL DESCRIPTION

The TOA WTU-4800 Wireless Tuner Module is designed to be used in conjunction with UHF wireless equipment for vocal

or speech reinforcement applications. Its built-in circuit minimizes the influence of ambient noise.

3. HANDLING PRECAUTION

Never open nor remove the unit case, as doing so may result in unit failure. Refer all servicing to your nearest TOA dealer.

4. OPERATION

Refer to the operating instructions attached to equipment to be used with the tuner module for installation and operation of

the tuner module.

5. SPECIFICATIONS

Indicates a potentially hazardous

situation which, if mishandled, could result in moderate or

minor personal injury, and/or property damage.

CAUTION

Indicates a potentially

hazardous situation which, if mishandled, could result

in death or serious personal injury.

WARNING

• Accessories

Driver for channel

changing ....................... 1

Produkt Specifikationer

Mærke:	TOA
Kategori:	Modtager
Model:	WTU-4800
Bredde:	60 mm
Dybde:	139 mm
Højde:	25 mm
Vægt:	130 g
Produktfarve:	Grå
Frekvensområde:	100 - 12000 Hz
Effektkrav:	7 - 12 V DC
Understøttede radiobånd:	PLL,UHF
klirfaktor (THD):	1 %
Indgangsimpedans:	75 ohm (Ω)