Tripp Lite MRV2012UL Manual

Tripp Lite Batteri MRV2012UL

Læs gratis den danske manual til Tripp Lite MRV2012UL (24 sider) i kategorien Batteri. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Tripp Lite MRV2012UL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/24

Owner’s Manual

Quiet Mobile Power

Congratulations! You've purchased the most advanced, feature-rich Inverter/Charger designed for recreational applications. Tripp Lite

PowerVerter Inverter/Chargers are the quiet alternative to generators—with no fumes, fuel or noise to deal with! You get AC electricity

anywhere and anytime you need it: away from shore power, rolling down the highway, dry camping in majestic back country or overnighting

at a non-electric site. Your Tripp Lite Inverter/Charger provides your appliances, equipment and electronics with utility- or generator-supplied

AC electricity (filtered through premium ISOBAR

surge protection) whenever available. In addition, it automatically powers your craft's 12V

system and recharges your connected battery bank—doing what traditional converter/chargers do. Whenever power blackouts, brownouts or

high voltages occur, your Inverter/Charger automatically switches over to inverting battery output to power connected AC equipment.

Better for Your Equipment Premium Protection Levels

• Built-In ISOBAR

Surge Protection

• Automatic Overload Protection

Ideal Output for All Loads

• Frequency-Controlled Output

• Automatic Load Switching

• Balanced Load Sharing

Better for Your Batteries Faster Battery Recharge

• High-Amp, 3-Stage Battery Charger (adjustable)

Critical Battery Protection

• Battery Charge Conserver (Load Sense)

• Battery Temperature Sensing

• High-Efficiency DC-to-AC Inversion

Better for You Quiet, Simple, Maintenance-Free Operation

• Multi-Function Lights & Switches

• Automatic Generator Starting

• Moisture-Resistant Construction*

Safety 2

Feature Identification 3

Operation 4-5

Configuration 5-7

Battery Selection 8

Mounting 9

Battery Connection 10

AC Input/Output Connection 11

Service/Maintenance 11

Troubleshooting 12

Warranty/Warranty Registration 12

Français 13

PowerVerter

DC-to-AC

Inverter/Charger

Input Output

Invert: 12 VDC 120V, 60 Hz. AC

Charge: 120V, 60 Hz. AC 12 VDC

1111 W. 35th Street, Chicago, IL 60609 USA

Customer Support: (773) 869-1234

www.tripplite.com

* Inverter/Chargers are moisture-resistant, not waterproof.

is a registered trademark of Tripp Lite.

Contents

WARRANTY

REGISTRATION

a chance to win a FREE Tripp Lite

product! www.tripplite.com/warranty

Important Safety Instructions

SAVE THESE INSTRUCTIONS!

This manual contains important instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite

Inverter/Chargers.

Location Warnings

• Although your Inverter/Charger is moisture resistant, it is NOT waterproof. Flooding the unit with water will cause it to short circuit

and could cause personal injury due to electric shock. Never immerse the unit, and avoid any area where standing water might

accumulate. Mounting should be in the driest location available.

• Leave a minimum of 2" clearance at front and back of the Inverter/Charger for proper ventilation. To avoid automatic Inverter/Charger

shutdown due to overtemperature, any compartment that contains the Inverter/Charger must be properly ventilated with adequate

outside air flow. The heavier the load of connected equipment, the more heat will be generated by the unit.

• Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will seriously inhibit the

unit's internal cooling, eventually causing product damage not covered under warranty.

• Do not install the Inverter/Charger directly near magnetic storage media, as this may result in data corruption.

• Do not install near flammable materials, fuel or chemicals.

Battery Connection Warnings

• Multiple battery systems must be comprised of batteries of identical voltage, age, amp-hour capacity and type.

• Because explosive hydrogen gas can accumulate near batteries if they are not kept well ventilated, your batteries should not be

installed (whether for a mobile or stationary application) in a “dead air” compartment. Ideally, any compartment would have some

ventilation to outside air.

• Sparks may result during final battery connection. Always observe proper polarity as batteries are connected.

• Do not allow objects to contact the two DC input terminals. Do not short or bridge these terminals together. Serious personal injury

or property damage could result.

Equipment Connection Warnings

Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the

failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this

equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

• You may experience uneven performance results if you connect a surge suppressor, line conditioner or UPS system to the output of

the Inverter/Charger.

• Tripp Lite recommends wiring the AC output to a GFCI protector (ground fault circuit interrupter).

• The main grounding lug should be connected to the vehicle chassis with an 8 AWG wire (minimum).

Operation Warnings

• Your Inverter/Charger does not require routine maintenance. Do not open the device for any reason. There are no user serviceable parts inside.

• Potentially lethal voltages exist within the Inverter/Charger as long as the battery supply and/or AC input are connected. During any

service work, the battery supply and AC input connection (if any) should therefore be disconnected.

• Do not connect or disconnect batteries while the Inverter/Charger is operating in either inverting or charging mode. Operating Mode

Switch should be in the DC OFF position. Dangerous arcing may result.

Caution: These models have a failsafe AC pass-through feature where the AC output will be live (if AC input is

available) even though the operating mode switch is set to DC OFF.

Caution: If your Inverter/Charger is mounted in a location that lacks proper ventilation, the surface of the metal

enclosure could become hot. Allow to cool before touching. If the Inverter/Charger must be installed in a location

that lacks proper ventilation, mount the unit in such a way that the top of the metal enclosure will not be subjected

to accidental contact during operation.

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	Batteri
Model:	MRV2012UL
Bredde:	266.7 mm
Dybde:	444.5 mm
Højde:	203.2 mm
Vægt:	19600 g
Produktfarve:	Sort
Pakkevægt:	21000 g
Pakkedybde:	342.9 mm
Pakkebredde:	538.5 mm
Pakkehøjde:	307.3 mm
Dimensioner (BxDxH):	266.7 x 444.5 x 203.2 mm
Udgangseffekt:	2000 W
Udgangsspænding:	120 V
Harmoniseret systemkode (HS):	8504.40.9570
Hovedkassen højde (udvendigt):	307.3 mm
Hovedkassens længde (udvendigt):	342.9 mm
Hovedkassens bruttovægt (udvendigt):	21000 g
Hovedkassens bredde (udvendigt):	538.5 mm
Oprindelsesland:	Kina
Produkter pr. hovedkasse (udvendigt):	1 stk