Tripp Lite PowerVerter PV375 Manual

Tripp Lite Batteri PowerVerter PV375

Læs gratis den danske manual til Tripp Lite PowerVerter PV375 (2 sider) i kategorien Batteri. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 6 anmeldelser. Har du et spørgsmål om Tripp Lite PowerVerter PV375, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

1111 W. 35th Street Chicago, IL 60609 USA • 773.869.1234 • www.tripplite.com

www.tripplite.com/warranty

Owner’s Manual

PowerVerter

Ultra-Compact DC-to-AC Inverters

PV150, PV375, PV500 & PV600

PV375 Front View

PV375 Rear View

PV150 Front View

PV150 Rear View

Feature Identification

Lighted ON/OFF Switch: move to ON (“I”) position to power connected equipment;

switch will illuminate. Move to OFF (“O”) position to stop powering connected

equipment.

AC Outlet(s): accept 120V AC equipment you would normally plug into a wall outlet.

DC Fuse(s) (externally mounted on PV150 and PV375; internally mounted on

PV500 and PV600):protect vehicle battery from damaging overload. If fuse

blows, replace with standard automotive fuse of equal amperage. CAUTION:

installing non-rated fuses could cause equipment damage and void your warranty.

Vehicle Lighter/Accessory Plug (PV150 & PV375 only): connects to a standard

12V DC vehicle lighter/accessory outlet.

DC Power Terminals (PV500 & PV600 only): directly connect to your battery terminals

with user-supplied cables. Always loosely twist each pair of cables (one positive

and one negative) together.

Cooling Fan (PV375, PV500 & PV600 only): maintains internal cooling.

Ultra-Compact, Lightweight Metal Case

Mounting Flanges (PV500 & PV600 only): provide fixed mounting, if desired.

Install and tighten four user-supplied screws through mounting flanges and into a rigid

horizontal surface. Mount Inverter before DC battery connection.

Low Battery Alarm (internal, not shown): detects low voltage and shuts down

Inverter to preserve vehicle battery. If alarm sounds, turn Inverter OFF and run

engine to recharge battery.

Overload Alarm (internal, not shown): detects wattage overload on Inverter outlets

and shuts down Inverter as a protective measure. If alarm sounds, turn Inverter

OFF and reduce wattage load (by unplugging high-wattage devices).

Safety

Important Safety Instructions! Save These Instructions!

This manual contains important instructions and warnings that

should be followed during the installation, operation and storage

of all Tripp Lite Inverters.

Warning!

• Do not use a Tripp Lite PowerVerter Inverter in life support or healthcare

applications where a malfunction or failure of a Tripp Lite PowerVerter Inverter

could cause failure or significantly alter the performance of a life support device

or medical equipment.

• Do not operate your Inverter near flammable materials, fumes or gases.

Caution!

• Since the Inverter requires adequate ventilation during operation, do not block fan

or cooling vents or cover the Inverter, and do not operate near vehicle heating

vents or in direct sunlight. Keep the Inverter dry at all times and disconnect when

not in use.

• Since the Inverter case will get hot (130° - 140° F) during continuous extended

use, use care when handling it. Do not place it near surfaces or materials

affected by this level of heat.

• Turn OFF connected equipment before starting your engine. DO NOT plug a surge

suppressor, line conditioner or UPS system into the Inverter. If you attach AC

extension cords, use the heaviest practical gauge.

• Before connecting a battery charger or adapter, check its manual to make sure that the

Inverter’s specifications (including output waveform) fall within its recommendations.

Congratulations! Your new PowerVerter Inverter will give you years of reliable, carefree service. Use it to convert DC (battery) power into 110-120V AC (household) power to run

a variety of electronics: notebook computers, game systems, battery chargers, small TVs/VCRs and more! The Inverter’s PWM (Pulse Width Modulated) sinusoidal wave is suitable

for almost all loads.

PV500/PV600 Front View

PV500/PV600 Rear View

Operation

Step 1 (PV150 & PV375 models): Plug Inverter into vehicle lighter/accessory outlet.

Step 1 (PV500 & PV600 models): First mount inverter, if desired. With user-supplied

cables,* connect the Inverter’s negative DC terminal directly to your battery’s negative

terminal; connect the Inverter’s positive DC terminal through a UL-listed fuse and fuse

block** and directly to your battery’s positive terminal. Always loosely twist each pair

of cables (one positive and one negative) together. CAUTION! Observe proper polarity.

Reversed polarity will blow the PV500’s and PV600’s internal fuses. To access internal

fuses, disconnect equipment and battery from the PV500 or PV600. Then unscrew and

remove end panels to access fuses. Replace blown fuses with an equal number of new fuses

of the same type and amperage. Replace end panels and screws.

Tighten your Inverter’s and battery’s DC terminals to approximately

2.25 Newton-meters (1.85 foot lbs.) of torque to create an efficient

connection and to prevent excessive heating at this connection.

Insufficient tightening of the terminals could void your warranty.

It is recommended that you solder cable ends and insulate the

terminals at the battery. WARNING! Do not connect your

Inverter directly to output from an alternator rather than a battery or battery bank.

* The PV500’s and PV600’s output is limited by the length and gauge of user-supplied cables. See cable sizing guide on back page. Shorter

and heavier gauge cable maximizes output (especially important when operating heavy-draw equipment). An excellent source of cables are

battery jumper cables. ** Required by NEC article 551. Mount within 18 inches of the battery.

Step 2: Turn on Inverter.

Step 3: Plug equipment into the Inverter.

Determine your equipment’s total wattage.* Do not connect more watts than your

Inverter’s Output Power (Maximum Continuous Watts) rating—either 150, 375, 500 or

600, see Specifications. See back page for typical equipment runtimes. Also see back

page for important note concerning the limitations of vehicle electrical systems.

* Wattage ratings are usually listed in equipment manuals or on nameplates. If your equipment is rated in amps, multiply that number

times AC utility voltage to determine watts. (Example: a ¼ in. drill requires 2½ amps. 2½ amps × 120 volts = 300 watts.)

Important! Alarms and automatic shutdown are normal safety functions of this

inverter, indicating either outlet overload or low vehicle battery voltage.

If alarm sounds and/or the inverter has shut down and will not turn on . . .

• Check inverter connections • Reduce wattage load • Run engine to recharge battery

• Toggle ON/OFF switch on and off 3 to 4 times, ending in the on ("I") position

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	Batteri
Model:	PowerVerter PV375

Har du brug for hjælp?

Hvis du har brug for hjælp til Tripp Lite PowerVerter PV375 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Batteri Tripp Lite Manualer

Tripp Lite UT2012UL Manual

1 August 2025

Tripp Lite APSWX6KP48VMPPT Manual

1 August 2025

Tripp Lite PowerVerter Plus PV2400FC Manual

1 August 2025

Tripp Lite PINV600SW-120 Manual

1 August 2025

Tripp Lite HCRK-36 Manual

31 Juli 2025

Tripp Lite APSWX4KP48VMPPT Manual

31 Juli 2025

Tripp Lite APS2448UL Manual

31 Juli 2025

Tripp Lite PINV2000SWL-120 Manual

31 Juli 2025

Tripp Lite PINV750 Manual

31 Juli 2025

Tripp Lite PowerVerter PV375 Manual

31 Juli 2025

Batteri Manualer

Nyeste Batteri Manualer

Dedra DED7320 Manual

30 Oktober 2025

Goji G26PBGR15 Manual

19 Oktober 2025

Mophie JPU-PWRSTION-PRO Manual

18 Oktober 2025

Bosch GAL 12V-40 Professional Manual

12 Oktober 2025

Powertraveller Powerstation Condor 100 Manual

6 Oktober 2025

Arris SURFboard Touchstone Battery BPB026S Manual

6 Oktober 2025

Kress KA3000 Manual

5 Oktober 2025

Arris Touchstone BPB088S Manual

3 Oktober 2025

Arris SURFboard Touchstone Battery BPD066H Manual

3 Oktober 2025

BlackVue Power Magic Ultra Battery B-130X Manual

3 Oktober 2025